Milwaukee PH55 Manuel utilisateur

BATTERY REPLACEMENT:

Units are supplied with BEPS (Battery Error Pre-venting

System) which avoids any erroneous reading due to low

battery level, by switching the meter off. To replace the

batteries unscrew the battery compartment cap and replace all

three 1.5V batteries while paying attention to their polarity.

Make sure the gasket is in place before screwing back the cap.

Batteries should only be replaced in a nonhazardous area using

the battery type specified in this instruction manual.

WARRANTY:

This meter (base unit) is warranted from all defects in

materials and manufacturing for a period of two years.

The electrode (probe end) is warranted for a period of 6

months.

During this period, the required repair or replacement of parts,

where the damage is not due to negligence or erroneous

operation by the user, will be effected free of charge.

WARRANTY REGISTRATION:

Please go to our web site and register your unit at

http://www.milwaukeeinstruments.com/registration.html

__________________________________________________

FOR A MUCH MORE DETAILED

OPERATORS MANUAL

GO TO OUR WEB SITE / MANUALS SECTION

AT THE FOLLOWING ADDRESS

www.milwaukeeinstruments.com

_______________________________________

Milwaukee Instruments

2950 Business Park Drive

Rocky Mount, NC 27804

Phone # 242-443-3630

PH55 & PH56 WATERPROOF

METER

STARTER MANUAL

•When calibration is completed the unit LED will flash

“OK 2”for 2 sec. then return to the temperature display

& normal operation taking the unit out of the calibration

mode. ** YOU ARE NOW CALIBRATED AND

READY TO PERFORM MEASURMENTS

_____________________________________

#3: OPERATION OF THE PH55 –PH56:

• Remove the unit from your storage container cup or jar

( Remember to always store the probe wet )

• Turn the pH55 - Ph56 on by pressing the ON key.

• Immerse the electrode in the solution to be tested.

• Stir gently and wait for the reading to stabilize.

• After the reading is stable you can press “SET / HOLD”

button and unit will freeze display until you press the

“SET / HOLD” button again to release the display.

• After use, turn unit off by pressing the OFF key and

rinse the end of the probe with water and then return it

to jar or cup for storage.

____________________________________________

#3: STORAGE OF THE PH55 –PH56:

Leave the protective cap off and put the unit back in a

cup or jar that has 1” to 1.5” of either bottle drinking

water, or 4.01 calibration solution, or MA9015 storage

solution

___________________________________________

You Must Move Unit - VERY FAST –Between

The 7.0 & 4.0 Cal Solution During The

Calibration Procedure –> Please Read Through

Instructions prior to starting procedure

NEVER LET YOUR PROBE DRY OUT

_________________________________

NEVER USE DISTILLED OR

DEIONIZED WATER FOR STORAGE

PURPOSES.

Autres manuels pour PH55

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Milwaukee Instrument de mesure

Milwaukee

Milwaukee MW190 MAX Manuel utilisateur

Milwaukee

Milwaukee MW500 Manuel utilisateur

Milwaukee

Milwaukee EC40 Manuel utilisateur

Milwaukee

Milwaukee MAX MW160 Manuel utilisateur

Milwaukee

Milwaukee M12 CPL Manuel utilisateur

Milwaukee

Milwaukee MW12 Manuel utilisateur

Milwaukee

Milwaukee MW102 Manuel utilisateur

Milwaukee

Milwaukee ORP 57 Manuel utilisateur

Milwaukee

Milwaukee pH 58 Manuel utilisateur

Milwaukee

Milwaukee MI 411 Manuel utilisateur

Milwaukee

Milwaukee Mi 150 Manuel utilisateur

Milwaukee

Milwaukee MW190 Manuel utilisateur

Milwaukee

Milwaukee SM700 Manuel utilisateur

Milwaukee

Milwaukee LDM 30 Manuel utilisateur

Milwaukee

Milwaukee M12 SPL Manuel utilisateur

Milwaukee

Milwaukee 3631-20 Manuel utilisateur

Milwaukee

Milwaukee C12 CMH Manuel utilisateur

Milwaukee

Milwaukee MW100 Manuel utilisateur

Milwaukee

Milwaukee Mi 180 Manuel utilisateur

Milwaukee

Milwaukee MW500 Manuel utilisateur

Milwaukee

Milwaukee MW102 Manuel utilisateur

Milwaukee

Milwaukee MI415 Manuel utilisateur

Milwaukee

Milwaukee MI404 Manuel utilisateur

Milwaukee

Milwaukee LDM 45 Manuel utilisateur

Manuels Instrument de mesure populaires d'autres marques

Suaoki

Suaoki D40 Manuel utilisateur

Elster

Elster BK-G1.6 Manuel utilisateur

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manuel

Duratool

Duratool D03128 Manuel utilisateur

Vega

Vega VEGAPULS 65 Manuel utilisateur

Tonghui

Tonghui TH2618B Manuel utilisateur

Tenmars

Tenmars TM-801 Manuel utilisateur

MSR

MSR 145 Manuel utilisateur

TPS

TPS WP-82 Manuel utilisateur

ELMETRON

ELMETRON CP-511 Manuel utilisateur

PCB Piezotronics

PCB Piezotronics 003C30 Manuel utilisateur

Tenma

Tenma 72-10465 Manuel utilisateur

Endress+Hauser

Endress+Hauser Proline Promag 50 Caractéristiques techniques

Siemens

Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces

KLINGER

KLINGER CMF V Series Manuel utilisateur

EXFO

EXFO FTB-2 Manuel d'exploitation et d'entretien

Keysight

Keysight M8290A Manuel utilisateur

ADTEK

ADTEK MW-5 Manuel utilisateur