ENG
2
Pairing your M1+ RE:DUCE Wireless speaker
Charging the M1+ RE:DUCE speaker
Next time charging
Turning Your M1+ RE:DUCE On and Off
Activate Siri on iOS-device: Double press the PLAY button (works only in
BT mode).
Play music from AUX mode
Pairing and connecting 2 x M1+ RE:DUCE speakers with TWS
1: Make sure the speaker is charged and turned OFF.
2: Press and hold the button for 3 seconds until the indicator light flashes
WHITE (pairing mode).
3: Activate BT on your phone or other device and search for new device and
select: M1+ by MIIEGO. It may take some seconds before it shows.
When M1+ RE:DUCE is connected the WHITE LED light is constantly on.
The speaker will remember your phone/device and automatically reconnect
the next time you turn it on.
An unpaired speaker will automatically turn off after 6 minutes.
Use a 5V/1A USB adapter (not included) for charging.
During charging the red light is on. When fully charged the red light is off.
Wireless Charging of the speaker: Make sure to place the speaker correctly
on the wireless charging plate/charger.
When you hear a warning tone every 180 seconds, the battery status is
low and needs charging.
ON: Press the Button for 3 seconds until a tone is heard.
OFF: Press the Button until a tone is heard.
Insert AUX audio cable on the side of the speaker.
(in AUX mode switching songs on +/- buttons is unavailable)
TWS only works when connecting two M1+ RE:DUCE by MIIEGO® together.
There needs to be free distance between them.
1: Turn on both speakers (BT mode). Make sure they are unconnected.
2: Press and hold the PLAY button on one speaker for 2 seconds. The product
emits a tone to indicate entering TWS-pairing mode.
3: The product then emits three tones and the LED indicator light (7) will be
constantly on. This is then the slave speaker. LED indicator light on master
speaker will flash to indicate successful TWS-pairing.
4: Activate BT on your phone/device and connect with the master speaker.
