Miele G 6994 Manuel utilisateur

Quick Start Guide

for dishwashers

These short instructions are not a substitute for the

operating instructions supplied with the appliance.

Please read the operating instructions supplied with your

dishwasher before using it for the first time and take note of

the Warning and Safety instructions, as well as the full

descriptions on how to use your appliance.

en-AU, NZ

M.-Nr. 10 632 800 / 01

Guide to the appliance

aOn/Off sensor 

For switching the dishwasher on and

off.

bTimeControl In-operation indicator

lights

For displaying the programme time

remaining with the door shut.

cInformation sensor 

For displaying additional information

about the option in the display.

dArrow sensors 

For selecting programmes, altering

values shown in the display and for

navigating between different menus.

eBack sensor 

For navigating back to the previous

menu or deleting values which have

been set previously.

fOK sensor

For selecting the option shown in the

display.

For confirming messages.

gDisplay

See next page for more information.

hDelay start sensor  with

indicator light

For selecting the "Delay start"

function.

Opening the door

This dishwasher has a motorised door opener which is activated by knocking on

the door front ("Knock2open function").

Knock twice in quick succession on the top third of the door front.

The door will open a little.

Brief instructions

 Filling the salt reservoir 

When filling the salt reservoir only

open the door halfway to ensure

that all the salt gets into the reservoir.

Press the button on the lid of the salt

reservoir in the direction of the arrow

until the flap springs open.

Lift up the funnel.

Dishwasher detergent will

damage the water softener.

Do not fill the salt reservoir with

powder or liquid detergent.

Do not fill the reservoir with water.

Add dishwasher salt only until the

reservoir is full or until water runs out

of the opening.

Clean any excess salt from around

the reservoir opening and then close

the flap.

Immediately after filling the salt

reservoir, run the QuickPowerWash

programme with the Short

programme option selected and

without any crockery in the

dishwasher to remove any traces of

salt from the cabinet.

 Adding rinse aid 

Press the button on the lid of the

rinse aid reservoir in the direction of

the arrow until the flap springs open.

Add rinse aid only until it is visible in

the opening.

Close the flap firmly. It should click

into place.

Wipe up any spilled rinse aid. This

prevents over-foaming occurring

during the next programme.

 Load the dishwasher

 Adding detergent 

Follow the dosage recommended by

the manufacturer on the packaging.

Press the opening catch on the

detergent dispenser. The flap will

spring open.

The flap is always open at the end of a

programme.

Add the required amount of detergent

and close the flap.

 Switching on the dishwasher

Turn on the tap if it is turned off.

Open the door.

Switch the dishwasher on using the

 button.

The main menu will appear in the

display.

If the Memory function is selected, the

last programme selected will appear in

the display instead of the main menu.

 Selecting a programme

Use the  arrows to select the

programme required.

The display will change to show the

programme menu.

 Selecting Extras (if required)

Select the Extras option.

All available Extras will be shown in the

display.

Select the Extras you want using the

OK button.

A tick  will appear beside the Extra to

show that it has been selected.

To deselect an Extra you have

chosen, simply press the OK button

again.

When you have finished selecting

Extras, confirm with Accept.

The display will change back to the

programme menu.

The number of Extras selected will

appear in the programme menu.

 Activating Delay start (if required)

Press the  button.

Select the function you want.

Use the  arrow buttons to set the

time and confirm with OK.

The display will change to show the

programme menu.

 Starting the programme

Start the programme by closing the

door.

 At the end of a programme -

Switching off

At the end of a programme, the

TimeControl indicator light will go out

with the door shut.

The buzzer might also be sounding.

The programme has finished when

Finished appears in the display and the

door has opened slightly (if applicable).

In the QuickPowerWash programme the

door will not open until a few minutes

after the programme has finished.

The drying fan may continue to run for

a few minutes at the end of the

programme.

Switch the dishwasher off using the

 button.

If you have deactivated the

automatic door opening function but

would still like to open the door at

the end of the programme, then

make sure that you open the door

fully.

Otherwise steam from the

dishwasher could damage the edge

of the worktop because the fan is no

longer running.

 Unloading the dishwasher

Dishes tend to break and chip more

easily when they are hot. Allow the

dishes to cool until they are comfortable

enough to handle before unloading

them.

Cleaning and care

Checking the filters in the

wash cabinet

This dishwasher must not be

used without all the filters in place.

The message Check filters will appear in

the display after every 50 programme

cycles (factory default setting).

Check the condition of the filters

regularly and clean them if necessary.

Then confirm the message with OK.

Cleaning the filters

Switch the dishwasher off.

Turn the handle anti-clockwise to

release the filter combination .

Lift the filter combination out of the

dishwasher . Remove any coarse

particles and rinse the filter well

under running water.

Use a nylon brush if necessary.

Ensure that course soil doesn't

get into the circulation system and

cause a blockage.

To clean the inside of the filter, the flap

must be opened:

Press catches  together in the

direction of the arrows as shown, and

open the filter .

Rinse all the filters under running

water.

Then close the flap so that the catch

engages.

Replace the filter combination so that

it lies flat in the base of the wash

cabinet.

Then turn the handle clockwise until

both arrows point towards each

other. This will lock the filter

combination in place.

Cleaning the spray arms

Particles of food can get stuck in the

spray arm jets and bearings. The spray

arms should therefore be inspected and

cleaned regularly (approx. every 4 - 6

months).

Switch the dishwasher off.

Remove the spray arms as follows:

Take out the cutlery tray (if your

dishwasher is fitted with one).

Push the top spray arm upwards to

engage the inner ratchet. Then

unscrew the spray arm.

Push the middle spray arm upwards

 to engage the ratchet. Then

unscrew the spray arm .

Remove the lower basket.

Pull the lower spray arm firmly

upwards to remove it.

Use a pointed object to push food

particles into the spray arm jets.

Rinse thoroughly under running

water.

Refit the spray arms and check that

they rotate freely.

Programme chart

Mixed,

everyday crockery

Heat-sensitive glasses and

plastic

Mixed crockery

Pots, pans, everyday porcelain

and cutlery

No crockery

All fresh to dried-on food

deposits

Fresh, easily removed food

deposits

Normal food deposits which

have begun to dry on

Burnt-on, stubborn, dried-

on food deposits containing

starch or protein 1)

Residual salt after reﬁlling the

salt container

Variable, sensor-controlled

programme sequence

Shorter duration

Short programme with

duration less than 1 hour 3)

Gentle programme with

glass care

Shorter duration

Very quiet programme

Water and

energy saving programme

Shorter duration

Average programme values

Shorter duration

Maximum cleaning power

Shorter duration

Flushes out salt residues

1) Food such as potatoes, pasta, rice or stews can leave starchy deposits. Deposits containing protein

can be left by food such as meat, ﬁsh or eggs and bakes.

Crockery Food deposits Programme

features

Fresh food deposits which

have begun to dry on

Fresh food deposits which

have begun to dry on

25 ml

1 tab

Automatic

+short

- 1 tab 3)

QuickPowerWash

20 ml

1 tab

Gentle 

+short

25 ml

1 tab

ExtraQuiet

25 ml

1 tab

ECO

+short

25 ml

1 tab

Light soiling 55°C

+short

10 ml

25 ml

1 tab

Intensive 75°C

+short

- -

QuickPowerWash

+short

2) see "Detergent"

3) best cleaning results are only achieved with Miele's quick dissolving UltraTab Multi

Detergent

Compartment I 2) Compartment II 2)

Programme

Autres manuels pour G 6994

Table des matières

Autres manuels Miele Lave-vaisselle

Miele

Miele Dishwasher Manuel utilisateur

Miele

Miele G6620SC Manuel utilisateur

Miele

Miele Standard Manuel utilisateur

Miele

Miele tx2349 Manuel utilisateur

Miele

Miele G 6160 Manuel utilisateur

Miele

Miele G 6582 Manuel utilisateur

Miele

Miele 11 872 630 / 01 Manuel utilisateur

Miele

Miele PG 8056 Manuel utilisateur

Miele

Miele PG 8083 SCVi Manuel utilisateur

Miele

Miele TOUCHTRONIC G 694 SC Manuel utilisateur

Miele

Miele NOVOTRONIC G 851 SC Plus Manuel utilisateur

Miele

Miele G 5810 Manuel utilisateur

Miele

Miele PFD 101 Manuel utilisateur

Miele

Miele PG 8583 CD Manuel utilisateur

Miele

Miele G 665 Manuel utilisateur

Miele

Miele Incognito G 658 SCVI Manuel utilisateur

Miele

Miele G 2832 Manuel utilisateur

Miele

Miele NOVOTRONIC G 842 PLUS Manuel utilisateur

Miele

Miele G 542 U Manuel utilisateur

Miele

Miele G 1832 Manuel utilisateur

Miele

Miele G 1202 Manuel utilisateur

Miele

Miele G 7360 Manuel utilisateur

Miele

Miele G 6582 SCVi K2O Manuel utilisateur

Miele

Miele G 4263 VI Active Manuel utilisateur

Manuels Lave-vaisselle populaires d'autres marques

Electrolux

Electrolux ESI5211LOX Manuel utilisateur

KitchenAid

KitchenAid KUDB230B Manuel utilisateur

Brandt

Brandt BDJ424DB Manuel utilisateur

Asko

Asko DSD767UXXL.AU Manuel utilisateur

Beko

Beko DFN26210W Manuel utilisateur

NEFF

NEFF S153ITX00E Fiche technique

Midea

Midea SV 4.45 wi Manuel utilisateur

LG LDF7932 Manuel utilisateur

Gorenje

Gorenje GV63214 Manuel utilisateur

Hotpoint

Hotpoint HDA1100ZWH Manuel de service

Blomberg

Blomberg LDFN2240W Manuel utilisateur

AEG

AEG FFB83836PM Manuel utilisateur

Cylinda

Cylinda DM3220RFD Manuel utilisateur

Atag

Atag DW8214MB Manuel utilisateur

GE GLD8000 Series Manuel utilisateur

Siemens

Siemens SN23HI02KE Fiche technique

Omega

Omega ODW717X Manuel utilisateur

BORETTI

BORETTI BVW-683 Manuel utilisateur