Miele KM 320 Manuel utilisateur

Installation Instructions

Gas Cooktop

KM 320

To prevent accidents and

machine damage,

read these instructions

before installation or use.

M.-Nr. 05 403 561

®®

WARNING:

If the information in this manual is not followed

exactly, a fire or explosion may result causing

property damage, personal injury or death.

–Do not store or use gasoline or other flammable

vapors and liquids in the vicinity of this or any

other appliance.

–WHAT TO DO IF YOU SMELL GAS

ßDo not try to light any appliance.

ßDo not touch any electrical switch.

ßDo not use any phone in your building.

ßImmediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s

instructions.

ßIf you cannot reach your gas supplier, call the

fire department.

– Installation and service must be performed by a

qualified installer, service agency or the gas

supplier.

(In Massachusetts a licensed plumber / gas fitter)

–Note to the installer:

Please leave this instruction book with the

consumer for the local electrical / gas inspector’s

use.

IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

Appliance dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Setting the cooktop into place . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Securing the support brackets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7

Electrical connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9

Gas connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Gas pressure regulator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Converting to another type of gas . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13

Contents

Installation

The minimum distances given in

these Installation instructions are to

combustible surfaces, and must be

observed to ensure safe operation.

Failure to do so increases the risk of

fire.

The cabinetry and venting hood

should be installed first to prevent

damage to the cooktop.

Gas appliances should only be

installed in a well ventilated area.

The countertop must be bonded

with heat resistant (212 °F/100 °C)

adhesive to prevent distortion or

dissolving.

The cooktop should only be

installed as shown in the

illustrations while maintaining the

required safety distances shown. Do

not install the cooktop between two tall

cabinets, this is a fire hazard.

a= indicates cooktop cut-out

b= minimum distance between

cut-out and a tall cabinet:

12" (305 mm)

This appliance has not been

designed for maritime use or for

use in mobile installations such as

recreational vehicles or aircraft.

However, under certain conditions it

may be possible for installation in these

applications. Please contact the Miele

Technical Service Department with

specific requirements.

recommended

not recommended

not allowed

IMPORTANT SAFETY INSTRUCTIONS

The cooktop must not be installed

over a dishwasher, washer, dryer,

refrigerator or freezer. Heat radiated by

the cooktop may damage the

appliances.

Deep fat fryers must not be

installed next to gas cooktops. Gas

flames can ignite splattering oil. A

distance of at least 12" (305 mm)

should be maintained between these

two appliances. The minimum distance

between two cooktops must be 4"

(100 mm).

Install the appliance so that the

power cord or gas piping does not

come into contact with any portion of

the cooktop which may become hot

during use.

This appliance must be installed

with its own shut off valve and the

included gas pressure regulator.

Both the valve and the regulator

must be easily accessible to the

consumer after the appliance is

installed.

This appliance must be

disconnected from the gas supply

during any pressure testing of the

system performed in excess of

1/2psi (3.5 kPa). This appliance

must be isolated at test pressures

equal to or less than 1/2psi

(3.5 kPa).

Any pipe connections must be made

using a thread sealant approved for

gas connections. Failure to correctly

install these items could lead to a

gas leak and subsequent explosion.

Safety distances above the

appliance

There must be a safety distance of at

least 30" (760 mm), cbetween the

appliance and any objects above it.

The overhead cabinet depth, d, if

unprotected, must not exceed 13"

(330 mm). The minimum distance of

combustible surfaces located above

and to the sides of the cooktop, e, is

18" (457 mm).

If the cabinet manufacturer

recommends a greater distance, follow

that manufacturers recommendation.

When installing the cooktop under a

venting hood, always observe the

minimum distance recommended by

the hood manufacturer.

Keep this instruction book in a safe

place for reference and pass it on to

any future user.

IMPORTANT SAFETY INSTRUCTIONS

KM 320

aBrackets

bBuilt-in depth

^Rember to maintain the minimum safety distances to combustible surfaces:

- 2 3/4" (70 mm) between the cut-out and the back wall and

- 12" (305 mm) between the cut-out and a side wall or tall unit to the right or left

of the cut-out.

(See "Important Safety instructions").

Appliance dimensions

Setting the cooktop into place

^After removing the protective

backing, d, stick the supplied seal,

c, under the edge of the cooktop.

^Screw the gas regulator/adapter

combination onto the nipple

underneath the cooktop. See "Gas

connection - Gas pressure regulator".

The included gas regulator/adapter

combination must be installed

between the cooktop and the gas

shut off valve. If clearance for the

regulator does not exist directly

under the cooktop, it may be moved

closer to the shut off valve.

^Guide the power cord through the

cut-out.

^Set the cooktop in the cut-out and

center it.

Securing the support brackets

^Place the brackets, a, as shown.

Installation

Important

The cooktop must not be

permanently sealed into the

countertop when installed.

The sealing strip under the edge of

the cooktop provides a sufficient

seal for the countertop.

If the cooktop is sealed into position,

the countertop or the appliance may be

damaged if the cooktop needs to be

removed for maintenance or service.

Installation

This appliance must be grounded

according to local or national codes.

All electrical work should be

performed by a qualified electrician

in accordance with local codes and

the:

- National Electrical Code

ANSI / NFPA No. 70

for the USA

- Canadian Electrical Code Part I

for Canada

(CSA Standard C 22.1).

,WARNING

Disconnect the appliance from the

main power supply before

installation or service. To reduce the

risk of electric shock, make sure the

appliance is properly grounded after

installation.

Power supply

The automatic ignition requires that the

cooktop be connected to a 120 VAC,

60 Hz power supply. The supply line

should be protected by a 15 A breaker.

Actual power consumption (during

ignition only) is 25 W.

This appliance is equipped with a 4 ft.

(1.2 m) long power cord that is ready

for connection to the appropriate outlet.

Please place the power outlet so that it

is accessible after the appliance has

been installed in the countertop.

This appliance is equipped with a

three-prong grounding plug to

prevent shock hazards. It should be

plugged directly into a properly

grounded outlet. Do not cut or

remove the grounding prong from

the plug. If the plug does not fit the

outlet, have a proper outlet installed

by a licensed electrician.

To guarantee the electrical safety of

this appliance, continuity must exist

between the appliance and an

effective grounding system. It is

imperative that this basic safety

requirement be met. If there is any

doubt, have the electrical system of

the house checked by a qualified

electrician.

The manufacturer cannot be held

responsible for damages caused by

the lack, or inadequacy, of an

effective grounding system.

Note to the installer

Please leave these instructions with the

consumer or the appliance.

Electrical connection

Installation and service must be

performed by a qualified installer,

service agency or the gas supplier.

In Massachusetts a licensed

plumber / gas fitter is required.

This appliance must be installed

with its own shut off valve and the

included gas pressure regulator.

Both the valve and the regulator

must be easily accessible to the

consumer to turn on or shut off the

gas supply after the appliance is

installed.

This appliance and its individual

shut off valve must be disconnected

from the gas supply during any

pressure testing of the system

performed in excess of 1/2psi

(3.5 kPa). The appliance must be

isolated from the gas supply line, by

closing its individual manual shut off

valve, at test pressures equal to or

less than 1/2psi (3.5 kPa).

Any pipe connections must be made

using a thread sealant approved for

gas connections. Failure to correctly

install these items could lead to a

gas leak and subsequent explosion.

The gas connection must be made

in accordance with local codes or, in

the absence of local codes, with:

- the National Fuel Gas Code,

ANSI Z 21.1 / NFPA 54

for the USA

- the current Can / CGA B 149.1

and .2 Installation Codes for gas

burning appliances for Canada.

Make sure that the maximum gas

supply pressure, before the gas

pressure regulator, is never more than

1/2psi for both natural gas or LP gas.

The minimum supply pressure to get

the required gas input is:

6" w.c. for natural gas

10" w.c. for LP gas.

Gas connection

Autres manuels pour KM 320

Table des matières

Autres manuels Miele plaque de cuisson

Miele

Miele KM 404 Instructions d'utilisation

Miele

Miele CS 1011 G Manuel utilisateur

Miele

Miele CS 1012 Manuel utilisateur

Miele

Miele CS 1112 E Fiche technique

Miele

Miele KM 5656 Guide de l'utilisateur

Miele

Miele KM 7678 FR Manuel utilisateur

Miele

Miele KM 3465 Manuel utilisateur

Miele

Miele SmartLine CS 7612 FL Manuel utilisateur

Miele

Miele KM 5676 Manuel utilisateur

Miele

Miele KM 2030 Manuel utilisateur

Miele

Miele KM 6002 Manuel utilisateur

Miele

Miele CS1122E Manuel utilisateur

Miele

Miele CS 1122 Manuel utilisateur

Miele

Miele ProLine Teppanyaki CS 1327 Manuel utilisateur

Miele

Miele ProLine CS 1212-1 Manuel utilisateur

Miele

Miele KM 93-2 Manuel utilisateur

Miele

Miele KM 5773 Fiche technique

Miele

Miele SmartLine CS 7101 Manuel utilisateur

Miele

Miele KM 360 Manuel utilisateur

Miele

Miele TX2070 Manuel utilisateur

Miele

Miele CS 1421 S Manuel utilisateur

Miele

Miele KM 443 Manuel utilisateur

Miele

Miele KM 5676 Manuel utilisateur

Miele

Miele KM 360 Manuel utilisateur

Manuels plaque de cuisson populaires d'autres marques

Bonnet

Bonnet OPTIMUM 700 Manuel du propriétaire

Jenn-Air

Jenn-Air JGCP430 Manuel utilisateur

Frigidaire

Frigidaire FES367FCC Guide de démarrage rapide

Ztove

Ztove EZ2 DUO Manuel utilisateur

Kleenmaid

Kleenmaid cooking GCTK9011 Guide d'installation

Casselin

Casselin CSASRE24 Manuel utilisateur

Jenn-Air

Jenn-Air JGC2536EB00 Manuel utilisateur

Waldorf

Waldorf RN8603E-B Mode d’emploi

Whirlpool

Whirlpool SMP658CNEIXL Manuel utilisateur

Wolf

Wolf CI243C/B Manuel utilisateur

Fulgor Milano

Fulgor Milano F5PGK305S1 Manuel utilisateur

GE JP389 Manuel utilisateur

Wells

Wells WV-2HFG Manuel utilisateur

IKEA

IKEA Lagan HGA4K Manuel utilisateur

Samsung

Samsung NA36N9755 Manuel utilisateur

Lacor

Lacor 69562 Fiche technique

Keating Of Chicago

Keating Of Chicago MG-2 Manuel utilisateur

Jenn-Air

Jenn-Air CCE1400 Manuel utilisateur