Microlab T-9701 Manuel utilisateur

2004-8-31 T-9701 USER MANUAL Page: 1

T-9701

User Manual

Please read through this manual carefully before using the T-9701

2004-8-31 T-9701 USER MANUAL Page: 2

SAFETY INFORMATION

Your wireless handheld portable transceiver contains a low

Power transmitter. When the Push-To-Talk (PTT) button is pressed, it sends out

radio frequency signals. The device is authorized to operate at a duty factor not to

exceed fifty percent.

CAUTION

To maintain compliance with the FCC’s RF exposure guidelines,

hold the transmitter and antenna at least two inches from your face

and speak in a normal voice, with the antenna pointed up and away

from your face. If you wear the handset on your body while using the

headset accessory, use only the supplied belt clip for this product.

When transmitting, take it out of the belt to ensure the antenna is

at least one inch (2.5cm) from your body.

Use only the supplied antenna. Unauthorized antennas,

modifications, or attachments could damage the transmitter and may

violate FCC regulations."

2004-8-31 T-9701 USER MANUAL Page: 3

CONTENTS

About The T-9701

Panel Description

Display Panel

Battery Care And Precautions

Installation Of The Batteries

Battery Level Indicator

Turn On/Off The T-9701

Backlight Of LCD Display

Set The Main Channel And CTCSS Codes

Listen Or Speak To Your Correspondent

Call Your Correspondent

Lock/Unlock Keys

Monitor Mode

Search The Main Channel and CTCSS codes

Set Call Alert

Talk Range

Handsfree Use

Vox function

Type of battery

Volume Control

Technical Specifications

Channel Frequency Table

CTCSS Code Frequency Table

2004-8-31 T-9701 USER MANUAL Page: 4

About The T-9701

The T-9701 is a transmitter-receiver which allow message transmission on 14

channels in UHF. Using the T-9701 does not require any licence, subscription or tax

payment. It is a multi-purpose communication device suitable for many

circumstances: security control, building sites, leisure, guiding, sport, etc.

It is extremely easy to use, even for children. The T-9701 is to be used together with

one or more t-9701

In this operation manual, the correspondent is another user of T-9701 who

communicates with you.

T-9701 is in compliance with Part95 .

Panel Description

2004-8-31 T-9701 USER MANUAL Page: 5

: Push To Talk key

: Selection keys, select Volume control keys in standby mode and select another

function in MENU mode.

: Press and release the key to toggle the scan function the “ ” icon

will flash . Once the unit received the same signal . The scan function

will stop . Press the PTT key to confirm.

Press and hold the key for 3 second to toggle the on/off of the

monitor function.

: Function key, press this key to enter function selection mode. Press and

hold MENU key three seconds the “ ” icon will displayed on LCD and

hold the MENU key three seconds released the lock function.

: Press to call other parties, alert of tone or vibration or both are

activated on other parties.

Display Panel

:2-digit channel number

:2-digit CTCSS code number

: Scan frequency channel or CTCSS number

: Battery level indicator

2004-8-31 T-9701 USER MANUAL Page: 6

: Volume level indicator

: Key lock enabled

: VOX function enabled

: Battery saving function enabled

Battery Care And Precautions

Please read and follow the note below to avoid fire hazards or personal injury:

• Do not expose batteries to open flame or heat source. They could explode. Contact

your local authority on disposal of batteries to ensure conformance with prevailing

community regulations.

• Do not throw batteries into dustbin. Contact your local authority on disposal of

batteries to ensure conformance with prevailing community regulations.

• Do not crush or take battery apart. Leakage of corrosive electrolyte may damage

the eyes and the skin. Swallowing a battery is harmful.

• Do not attempt to recharge the battery provided with the T-9701. Recharging can

cause leakage of corrosive electrolyte or explosion.

• Be sure that the poles of each battery are positioned properly in the unit.

Inadvertent charging, leakage of corrosive electrolyte or explosion can occur if a

battery is installed backwards.

• Remove the batteries from the unit if you do not plan to use the T-9701 for an

extended period of time (several months or more) because the batteries may leak

electrolyte during this period.

• Do not leave dead batteries in the T-9701 because they may leak electrolyte in the

unit.

NB: Please keep this operation manual carefully for future references.

Installation Of The Batteries

2004-8-31 T-9701 USER MANUAL Page: 7

Battery Level Indicator

4 levels battery indicator for showing the capacity of the battery

Full

2/3

1/3

low battery warning. Replace all four batteries.

Turn On/Off The T-9701

To turn on the T-9701, press the ON/OFF key for 2 seconds. The T-9701 will beep

and enter to reception mode.

To turn off the T-9701, press the ON/OFF key until the LCD display is cleared.

Backlight Of LCD Display

The screen will light for 10 seconds whenever the any key is pressed. You can

extinguish the backlight by pressing the any key again.

Set The Main Channel And CTCSS Codes

The T-9701 have 14 main channels and 38 CTCSS codes (CTCSS 00 means no code

is checked). You can only communicate the group of correspondent with same main

channel and CTCSS code. If your CTCSS code is 00, you can hear all messages of

the main channel but other people cannot hear your message if their CTCSS code is

not 00.

To set the main channel:

1. Press key 1 time, the main channel number will flash.

2. Press or key to select your desired main channel.

3. Press PTT key to confirm the selection.

To set the CTCSS code:

2004-8-31 T-9701 USER MANUAL Page: 8

1. Press key two times, the CTCSS code number will flash.

2. Press key to select your desired main channel.

3. Press key to confirm the selection.

Listen Or Speak To Your Correspondent

You cannot speak and listen to your correspondent at the same time. While you are

speaking, you cannot hear your correspondent.

To listen to your correspondent:

1. Make sure the key is not pressed.

2. When your correspondent starts to speak.

3. You can adjust the speaker volume by pressing or keys, volume digital

number are shown according to the setting.

To speak to your correspondent:

1. Press and hold the key while you speak. The LED will light.

2. When you finish speaking, release the key.

Call Your Correspondent

Press the key, the call tone will appears. The T-9701 of your

correspondent will beep , depending on the call alert setting.

Lock/Unlock Keys

After you have pressed and hold the key, the icon appears. The

keys will not function.

To unlock the keys, press the key again. The icon will disappear.

Monitor Mode

Your T-9701 has an Automatic Squelch Circuit to turn off the speaker when there is no

receiving message. However, the circuit will reduce the reception ability if the

receiving message signal is weak. It is advised to deactivate the circuit if you want to

monitor the weak signal.

To deactivate the Automatic Squelch Circuit (monitor mode):

1. Press and hold the key until the monitor function enabled .

2. You will hear noise. This is normal because the circuit will not turn off the

speaker even the noise is large.

To activate the Automatic Squelch Circuit again:

1. Press and hold the key until the monitor function will disable.

Search The Main Channel and CTCSS code

This function enables you to find a main channel used by other people.

2004-8-31 T-9701 USER MANUAL Page: 9

1. Press key and release.

2. The icon appears and the channel number and ctcss number flashes.

3. When your unit finds a main channel and CTCSS channel which is in use, it will

stop at this channel for 10 seconds.

4. You can now stop the searching by pressing the key. The T-9701 will stay at

this channel. Otherwise, it will continue to search for another busy channel.

Select Call Alert

This function allows you to set the 8 types call tone alert when you receive a call.

1. Press key three times.

2. Press the or keys to select the desired type of call alert:

3. Confirm the selection by pressing the key.

Set Talk Confirmation Tone and key tone

This function allows you to alert yourselves with a beep when your correspondent has

finished speaking. You can answer him after the beep tone.

1. Press key five times.

2. The icon [ ]flashes.

3. Press the

[] or [-] keys to turn on or off beep tone.

4. The icon [ ] indicates with beep tone.

5. The icon [ ] indicates without beep tone.

6. Confirm the change by pressing the key.

Talk Range

Your T-9701 has been designed to maximize the transmission range. It is

recommended not to use two units within 1.5 m apart because of interference. The

maximum talk range is affected by terrain. In flat and open area, the talk range can be

up to 5 km. The range will be reduced if there is obstruct in between.

Handsfree Use

Your T-9701 can connect an external mic/speaker kit for handsfree use. Simple insert

the plug into the mic/speaker jack. The unit has a built in Voice Activated

Transmission (VOX) circuit. You speak to the external mic and your voice will

activate the transmission without pressing the key. Remember to adjust the

volume to a comfortable listening level.

Vox function

Press key four times, the icon will displayed on LCD . The VOX function

have four levels. “0” means vox function disable. “1” the means low sensitivity, “2”

the means middle sensitivity; “3” the means high sensitivity. Press or key

to select your desired VOX level. Press key to confirm this selection.

2004-8-31 T-9701 USER MANUAL Page: 10

Type of battery

1) Press key five times.

2) The icon flashs.

3) Press or key to select battery types. the means alkaline battery;

the means nickel battery. This selection base on the unit in used battery type.

Volume Control

1. You can adjust the volume level in standby mode.

2. Press or key to select volume level.

3. There are 8 types volume level can be selected.

4. Press key to confirm this selection.

Technical Specifications

Operating Frequency 462.5625 – 462.7125 MHz; 467.5625-467.7125

Channels 14

Channel Spacing 25KHz

CTCSS Code 00 – 38

Power Source 4x 1.5 V ‘AAA’ Alkaline Battery

Channel Frequency Table

Channel. Frequency (MHz) Channel. Frequency (MHz)

01 462.5625 08 467.5625

02 462.5875 09 467.5875

03 462.6125 10 467.6125

04 462.6375 11 467.6375

05 462.6625 12 467.6625

06 462.6875 13 467.6875

07 462.7125 14 467.7125

CTCSS Codes Frequency Table

Code Frequency (Hz) Code Frequency (Hz)

01 67.0 20 131.8

02 71.9 21 136.5

03 74.4 22 141.3

04 77.0 23 146.2

05 79.7 24 151.4

06 82.5 25 156.7

07 85.4 26 162.2

08 88.5 27 167.9

09 91.5 28 173.8

Table des matières

Autres manuels Microlab Émetteur-récepteur

Microlab

Microlab T-9752 U Manuel utilisateur

Manuels Émetteur-récepteur populaires d'autres marques

Yaesu

Yaesu FT-7B Manuel utilisateur

Kenwood

Kenwood ProTalk TK-3201 Manuel utilisateur

Texas Instruments

Texas Instruments TLK10232 Manuel utilisateur

Mizuho

Mizuho MX-2 Guide produit

Kenwood

Kenwood TK-3180 Manuel d'utilisation et d'entretien

Blitz

Blitz MJ-398U Manuel utilisateur

Utilicom

Utilicom LongRanger 2050 Manuel utilisateur

Standart

Standart HX290UKA Manuel utilisateur

Altronix

Altronix Pace1PTM Manuel utilisateur

Kirisun

Kirisun PT2208 Manuel utilisateur

ELECRAFT

ELECRAFT KX2 Manuel utilisateur

Zodiac

Zodiac K3 Manuel utilisateur

Assa Abloy

Assa Abloy SecureComm HKC GSM-WIFI U Manuel utilisateur

Kenwood

Kenwood TK-2217 Manuel utilisateur

Siemens

Siemens PSO 4000 Manuel utilisateur

Kenwood

Kenwood TS-590SG Manuel utilisateur

Midland

Midland G8E-BT Manuel

ComNav

ComNav Mariner X2 Manuel utilisateur