METREL A 1622 Manuel utilisateur

3G and Wi-Fi Router

A 1622

Instruction manual

Version 1.0, Code No. 20 752 818

Distributor:

METREL d.d.

Ljubljanskacesta 77

1354 Horjul

Slovenia

web site: http://www.metrel.si

e-mail: [email protected]

Manufacturer:

HQ JSC Teltonika

Saltoniskiust. 10c

LT-08105, Vilnius,

Lithuania

Tel: +370 5 212 74 72

Tel: +370 5 265 73 60

Fax: +370 5 276 13 80

web site: http://www.teltonika.lt/

e-mail: [email protected]

Mark on your equipment certifies that this equipment meets the requirements of the EU

(European Union) concerning safety and interference causing equipment regulations

No part of this publication may be reproduced or utilized in any form or by any means

without permission in writing from METREL.

A 1622 - 3G and Wi-Fi Router Table of contents

English

1Introduction.............................................................................................................4

2Remote Communication over 3G / GPRS network..............................................4

2.1 Router connection.............................................................................................4

2.2 Router Setup.....................................................................................................6

2.3 Connection status............................................................................................11

2.4 Connection check and further steps................................................................13

3Remote Communication over Wi-Fi network .....................................................13

3.1 Router connection...........................................................................................13

3.2 Router Setup...................................................................................................14

3.3 Connection status............................................................................................20

3.4 Connection check and further steps................................................................20

4Technical Specifications......................................................................................21

4.1 General specification.......................................................................................21

4.2 LAN and Wi-Fi.................................................................................................21

4.3 UMTS/HSPA+ .................................................................................................22

4.4 GSM/GPRS/EDGE..........................................................................................22

Deutschland

5Einführung ............................................................................................................23

6Fernkommunikation über 3G / GPRS Netzwerk.................................................23

6.1 Router Verbindung ..........................................................................................23

6.2 Router einrichten.............................................................................................26

6.3 Status der Verbindung.....................................................................................31

6.4 Verbindungsprüfung und weitere Schritte........................................................33

7Fernkommunikation über Wi-Fi Netzwerk..........................................................33

7.1 Router Verbindung ..........................................................................................33

7.2 Router einrichten.............................................................................................34

7.3 Status der Verbindung.....................................................................................41

7.4 Verbindungsprüfung und weitere Schritte........................................................42

8Technische Daten.................................................................................................42

8.1 Allgemeine Angaben .......................................................................................42

8.2 LAN und Wi-Fi.................................................................................................43

8.3 UMTS/HSPA+ .................................................................................................43

8.4 GSM/GPRS/EDGE..........................................................................................43

A 1622 - 3G and Wi-Fi Router Introduction

1 Introduction

Metrel instruments (MI 2892 Power Master, MI 2885 Master Q4, etc.) can be remotely

accessed through Ethernet communication port.

However, on measurement locations where 3G/2G mobile or Wi-Fi communication is

available, this router can be used to establish Communication Bridge to the instrument.

3G and Wi-Fi Router A 1622, is a high-speed Wi-Fi and 3G gateway, for remote access

to the measurement certified and tested by Metrel. In this manual MI 2892 Power

Master is used as example, however other Metrel instruments with Ethernet port are

used in similar way. Two configurations are supported and described:

Instrument remote communication over 3G / GPRS network

Instrument remote communication over Wi-Fi network

For other means of connections and configuration please check RUT 230 instruction

manual, provided by OEM manufacturer Teltonika www.teltonika.lt.

Standard set include:

- Router RUT230

- Euro PSU

- 1 x 3G antenna (swivel, SMA male)

- 1 x WiFi antenna (swivel, RP-SMA male)

- Ethernet cable (1.5 m)

- Installation Manual 20 752 818

2 Remote Communication over 3G / GPRS

network

2.1 Router connection

After you unpack box, follow the steps, documented below, in order to properly connect

the router.

1. Pull out SIM holder by pushing the button (1) and insert SIM card which as

given by your ISP (Internet Service Provider). Insert SIM card into holder (3) and

put it back into the modem (4) Correct SIM card orientation is shown in the figure

below.

Figure 1: SIM card insertion into SIM holder and router

A 1622 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network

2. Attach 3G and Wi-Fi antennas.

3. Connect the power adapter to the socket on the front of the device. Then

plug the other end of the power adapter into the power socket.

4. Connect devices, as shown on figure below

oRouter can be set up over Wi-Fi network, by finding RUT230_*** access

point on PC. In that case Ethernet connection with PC is not needed.

oAlternatively, use Ethernet cable to connect Router with PC. PC will be

used to set up router.

Note: Ethernet LAN port is used for connection the PC (during Router setup)

–step 1 and for connection the MI 2892 instrument –step 2

oUse Ethernet cable to connect instrument MI 2892 and router

Figure 2: Router 3G connection

5. Power up router, instrument and PC.

On following figures description of router front and back plates can be found.

A 1622 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network

Figure 3: Router front plate

Figure 4: Router back plate

2.2 Router Setup

Before first use, router should be setup in order to work with 3G network.

1. To connect to the router:

- Through Wi-Fi, look up for Access Point RUT230_001E42***** (unique for each

device) on your computer, and connect to it (no password is required).

A 1622 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network

- Through LAN (Ethernet) network, plug Ethernet cable into computer and LAN

Ethernet port on Router, marked as “LAN”.

2. Launch your browser and enter the router IP into the address field:

3. If connection was successful, a login screen will appear:

Enter the default password admin01 into the Password field and then click on

4. A wizard will start in order to setup router. Change default password (1) with your

own, Time Zone Settings (2) and Synchronize time (3) with the browser

A 1622 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network

5. Set up mobile network parameters (APN, Authentication method, username,

password,) according to the mobile provider specification.

6. Change LAN setup if necessary, otherwise leave it as is.

A 1622 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network

7. Set up wireless network if you would like to use router as access point. Don’t

forget to protect it with password and encryption.

8. Press Save button. Router will now apply new settings and restart.

9. Select Mobile interface as gateway to the system.

A 1622 - 3G and Wi-Fi Router Remote Communication over 3G / GPRS network

10.Press Status button to check the all interface statuses

Table des matières

Langues :

Autres manuels METREL Routeur sans fil

METREL

METREL A 1753 Manuel utilisateur

Manuels Routeur sans fil populaires d'autres marques

Milesight

Milesight UG67 Manuel utilisateur

Airlogic

Airlogic AirSync Class 1 Manuel du propriétaire

Samsung

Samsung WCH730B Manuel utilisateur

TELEFONICA

TELEFONICA USB Adapter Manuel utilisateur

NETGEAR

NETGEAR PowerLINE WiFi 1000 Series Manuel utilisateur

Askey

Askey RAC2V1K Manuel utilisateur

Alloy

Alloy WLF2454AP-S Manuel utilisateur

TP-Link

TP-Link TL-WR542G Manuel utilisateur

NETGEAR

NETGEAR WNR2000v4 Manuel utilisateur

Hama

Hama 53120 Manuel utilisateur

Intellinet

Intellinet 524582 Manuel utilisateur

Asus

Asus RT-N10P Manuel utilisateur

D-Link

D-Link DIR-506L Manuel utilisateur

Sapido

Sapido GR297n Manuel utilisateur

Asus

Asus DSL-N55U Manuel utilisateur

AMTC

AMTC WR7502 Manuel utilisateur

Compaq

Compaq CP-2W - iPAQ Connection Point Manuel utilisateur

SMC Networks

SMC Networks WBR14-N2 FICHE Manuel utilisateur