Maximon Max-555 Manuel utilisateur

Max-555 16 channel UHF PMR446
Transceiver 446mhz
User Manual

PRECAUTIONS
Refer service to qualified technicians only.
Do not operate the transceiver or charge a battery pack in an explosive
atmosphere (gases, dust, fumes, etc.).
Turn OFF the transceiver while taking on fuel or while parked in a
gasoline service station.
Do not modify or attempt to adjust this transceiver for any reason.
Do not expose the transceiver to long periods of direct sunlight, nor place
it close to heating appliances.
Do not place the transceiver in excessively dusty, humid, and/or wet areas,
nor on unstable surfaces.
SAFETY
It is important that the operator is aware of, and understands, hazards
common to the operation of any transceiver.

CONTENT
UNPACKING AND CHECKING EQUIPMENT
Supplied Accessories………………………………………. 1
Unpacking and checking the equipment…………………… 2
PREPARATION……………………………………………
Charging the Lion Battery Pack…………………………… 3
Charging Information……………………………………… 4
Installing/Removing the Battery Pack…………………….. 5
Installing the Belt Clip……………………………………… 6
Installing the Cover over the Speaker / Microphone Jacks &
Installing the Optional Speaker Microphone ………………. 7
GETTING ACQUAINTED (Max--555) ……………………………… 8
Max-555 OPERATION…………………………………….. 9
AUXILIARY FUNCTIONS………………………………...
Time\Out timer……………………………………………… 10
Battery & battery save ……………………………………… 10
Low Battery Warning……………………………………….. 10
Monitor……………………………………………………… 11
Quiet Talk (QT) ……………………………………………. 11
OPTIONAL ACCESSORIES………………………………. 12
TROUBLESHOOTING GUIDE…………………………… 13
FREQUENCY CHART…………………………………….. . 14

P1
UNPACKING AND CHECKING EQUIPMENT
Carefully unpack the transceiver. We recommend that you identify the
items listed in the following table before discarding the packing material.
If any items are missing or have been damaged during shipment, file a
claim with the carrier immediately.
Supplied Accessories
ITEM
QUANTITY
Max-555 : 1
Battery charger (Max-10C) 1
Li-on battery pack (Max-10) 1
(Max-555 only) 6V (1200mAh) 1
Speaker/ microphone jack cover 1
Belt clip 1
Screw set 1
Instruction Manual Disk (1 per batch of units)
1

P2
UNPACKING AND CHECKING EQUIPMENT
Battery charger (Max-555)
AC adaptor (Max-555 only) Li-ion battery pack (Max-10) (Max-555
only)
Belt clip Speaker / microphone jack cover
Screw set

P3
Charging the Li-ion Battery Pack
The battery pack is not charged at the factory; charge it before use.
Initially charging
the battery pack after purchase or extended storage (greater than 2 months)
will not bring
the battery pack to its normal operating capacity. After repeating the
charge/discharge
cycle two or three times, the operating capacity will increase to normal.
CAUTION
DO NOT RECHARGE THE BATTERY PACK IF IT IS ALREADY
FULLY CHARGED.DOING SO MAY CAUSE THE LIFE OF THE
BATTERY PACK TO SHORTEN OR THE BATTERY PACK MAY
BE DAMAGED.
AFTER RECHARGING THE BATTERY PACK,DISCONNECT IT
FROM THE CHARGER.
CHARGING THE BATTERY PACK FOR MORE THAN 5 DAYS
MAY REDUCE THE BATTERY PACK LIFE DUE TO
OVERCHARGING.
Note:
The ambient temperature should be between 41 and 104°F (5 and 40℃)
while charging is in progress.
Charging outside this range may not fully charge the battery.
Always switch OFF the transceiver equipped with a Li-ion battery pack
before charging. Using
the transceiver while charging its battery pack will interfere with correct
charging.
The battery pack life is over when its operating time decreases even
though it is fully and correctly charged. Replace the battery pack.

P4
Charging Information
Plug the AC adaptor cable into the adaptor
jack located on the rear of the charger.
Plug the AC adaptor into an AC outlet.
Slide the Li-ion battery pack or transceiver with a Li-ion battery pack into
the charger.
Make sure the battery pack contacts are in contact with the charging
terminals.
The charger LED lights Red and charging begins.
After charging the supplied MAX-10 battery pack for 12 hours, remove
from the charger. Thereafter green light indicates charged battery.
The charger does not turn OFF automatically after charging is completed.
Unplug the AC adaptor from the AC outlet.
Note:
It takes approximately 12 hours to fully charge the MAX-10 (6v /
1200mAh) battery pack. for the first time.

P5
Installing/Removing the Battery Pack
The average life of the supplied MAX-10 Lion battery pack is up to 16
hours use.
Average times are calculated using 5% transmit time 5% receive time,
and 90% standby time. (5/5/90 cycle)
CAUTION
DO NOT SHORT THE BATTERY TERMINALS OR DISPOSE OF
THE BATTERY BY FIRE.
NEVER ATTEMPT TO REMOVE THE CASING FROM THE
BATTERY PACK.
Match the four grooves of the battery pack with the corresponding guides
on the back of the transceiver.
To remove the battery pack, pull back on the release latch and slide the
pack away from the transceiver.
Slide the battery pack along the back of the transceiver until the release
latch on the base of the transceiver locks.

P6 .
Installing the Belt Clip
If necessary, buckle the belt clip to the back of the battery pack.
Note: If the belt clip is not installed, its mounting location may get
Warm during continuous transmission or when left sitting in a hot
environment.
CAUTION
DO NOT USE GLUE WHICH IS DESIGNED TO PREVENT SCREW
LOOSENING
WHEN INSTALLING THE BELT CLIP, AS IT MAY CAUSE
DAMAGE TO THE
TRANSCEIVER.ACRYLIC ESTER, WHICH IS CONTAINED IN
THESE GLUES, MAY
CRACK THE TRANSCEIVER'S BACK PANEL.

P7
Installing the Cover over the Speaker/ Microphone Jacks
If you are not using a speaker / microphone, install the cover over the
speaker Microphone jacks using the supplied 3 x 6 mm screw.
Note: To keep the transceiver water resistant, you must cover the
speaker/Microphone jacks with the supplied cover.
Installing the Optional Speaker/ Microphone
Insert the speaker/ microphone plugs into the speaker/ microphone jacks.
Attach the locking bracket using the supplied 3 x 6 mm screw.
Note:
The transceiver is not fully water resistant while
using the speaker/ microphone.
Table des matières
Autres manuels Maximon Émetteur-récepteur


















