Page 5
ATTACH THE POSTS
Lay the wood top upside down on a soft
mat for protection. Identify the front and
back of the wood top. Note the locations of
the holes in the diagram below.
Front
Back
Attach each post to the worktop using four
M6 x 16 mm hex bolts. Tighten securely.
NOTE: The two posts labelled "Front Leg"
should be attached to the front of the
workbench. The other two posts should be
attached to the back of the workbench.
Post A
Post A
Post B
Post B
Front
Back
ATTACH THE
CROSS BRACES
Attach the three long cross braces and two
short cross braces using M6 x 16 mm hex
bolts. The cross braces should be attached
in the locations shown in the diagram and
as described below:
1 X LONG CROSS BRACE: Attach to top
back. Use four M6 x 16 mm hex bolts to
attach the cross brace to the posts and
three M6 x 16 mm hex bolts to attach the
cross brace to the worktop.
1 X LONG CROSS BRACE: Attach to top
front. Use four M6 x 16 mm hex bolts to
attach the cross brace to the posts and
three M6 x 16 mm hex bolts to attach the
cross brace to the worktop.
1 X LONG CROSS BRACE: Attach to middle
of the back posts using four M6 x 16 mm
hex bolts.
2 x SHORT CROSS BRACES: Attach one on
either end using four M6 x 16 mm hex bolts
per cross brace.
Tighten securely.
Front
Back
ASSEMBLY
