. Place the carrier onto the front cross bar with the boarding
ramp facing out. Swing the Jawz under the cross bar as
shown. See image 3.
Place the carrier onto the front cross bar with the forward
section (with small foam pads, or boarding ramp) facing
out. Swing the Jawz under the cross bar as shown. See
image 3.
3
. Insert a second Mounting Bolt into the top side unused hex
hole and down through the Jawz mounting adapter. Apply
washer and second T-knob and slightly tighten until the carrier
is secure. Repeat steps 1-4 for the 2nd carrier and rear cross
bar. See image 4.
top rear of the carrier. Pull the free end down unt
there is an even loop. Repeat for the second carrie
See image 7.
de 3
6 mètres autour de la
artie su
érieure du su
ort
. Confirm the carriers are in alignment. Firmly tighten
the T-knobs until both carriers are securely fixed to
the cross bars. See image 5.
5
. Insert the four Rubber Plugs into the four top side hex holes
in the two carriers. See image 6.
. Insérez un bouchon de caoutchouc dans chacun des quatre
trous hexagonaux situés sur le côté supérieur des supports.
(Figure 6)
4
6
7
4
Loading the Kayaks:
With and With-out the
Boarding Ramp Feature
. Route the free end of a 12’ Load Strap around the
top rear of the carrier. Pull the free end down until
there is an even loop. Repeat for the second carrier.
See image 7.
See image 1
7
1
Insert a second mounting bolt into the top side unused hex
hole and down through the Jawz mounting adapter. Close
the mounting hole cover. Apply second T-knob and slightly
tighten until the carrier is secure. Repeat steps 1-4 for the
second carrier and rear cross bar. See image 4.
(Figure 4)
5
Loading the Kayaks:
With-out the
Boarding Ramp Feature
