Malaguti CIAK MASTER 50-4T Guide de l'utilisateur

CIAK MASTER 50-4T

ELECTRIC SYSTEM

TROUBLESHOOTING

WORKSHOP MANUALS

10.05 3

Table of contenents

CHAPTER

PAGEISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 1

B- TROUBLESHOOTING

Table of contents

Sect. Page

INTRODUCTION 1 5

Manual updates 1 5

Notes for easy consultation 1 6

Page layout 1 6

Modified pages 1 6

Additional pages 1 6

Editing symbols 1 6

Abbreviations 1 8

TROUBLESHOOTING 2 9

Electrical components 2 9

General wiring diagram 2 11

Checking switches 2 12

Checking procedures 2 12

Connection of the switches described in this manual 2 12

Checking fuses 2 13

Position of switches and connection of connectors 2 14

Troubleshooting 2 15

Checking light system 2 24

Troubleshooting 2 28

10.05 5

Introduction

CHAPTER

PAGEISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 1

B- TROUBLESHOOTING

• Malaguti S.p.a. reserves the right to make any and all changes to its vehicles as it deems fit and appropriate

at any time without prior notice.

•No part of this publication, whether text or illustrations, may be reproduced or circulated. Malaguti

reserves all rights over this publication. Reasons must be given for any request for permission (written) thereto.

INTRODUCTION

•This publication describes all necessary steps for troubleshooting concerning the electrical system and of

the possible service operations, which are necessary for their solution. It supplies the trade technicians

(authorised customer service centres) with the necessary information for operating in compliance with the

modern concepts of “good practice” and “safety at work”.

• Additional information is available in the Engine Service Manual and Spare Parts Catalogue.

• All described operations must be performed by technicians with the necessary skill and experience.

• The steps for removal of body parts and of electric and mechanical components, to allow access to wiring or

electric components to service, can be taken from the “Chassis” Workshop Manual.

• We recommend you follow the information given in this publication with care.

• For any further information you may need, refer to the Malaguti S.p.A. Technical Department.

• It is essential to follow the instructions with great care. Work carried out carelessly or, worse still, work that has

not been accomplished, can cause injuries and damage or, in the less serious cases, tiresome complaints.

MANUAL UPDATES

•Any subsequent updates applying to this Manual will be sent in a reasonable time.

•The table of contents will be duly updated in the event that new pages are inserted, which render the consultation

of the manual difficult.

• IMPORTANT! The “Electrical System Troubleshooting Manual” is to be considered as an essential tool to

be properly kept up-to-date so as to maintain its

“validity”

over time.

FIRST EDITION: 10/05

610.05

Introduction

CHAPTER

PAGE ISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 1

B- TROUBLESHOOTING

MODIFIED PAGES

• Modified pages shall bear the same number as those in the previous edition/pre-modified ones, followed by the

letter M, with the date of issue appearing in the appropriate box.

• Modified pages may contain new illustrations; in this case, the added illustration (or illustrations) will bear the

number of the illustration on the former page, followed by a letter.

ADDITIONAL PAGES

• Any additional pages shall bear the last number of the section to which they belong, followed by the letter A

and the date of issue.

EDITING SYMBOLS

• Symbols have been provided for quick and easy reference (see page 7). They identify situations requiring

utmost attention, practical advice or simple information.

•These symbols may appear next to a text (in which case they refer solely to the text itself), next to a figure

(in which case they refer to the topic illustrated in the figure and to the relative text), or at the top of the page

(in which case they refer to all the topics dealt with in the page).

Note:

the meaning of the symbols should be duly memorised as their scope is to avoid having to repeat basic technical

concepts or safety recommendations. They are therefore to be considered as veritable “memory tags”. In case

of any doubt as to their meaning, consult the page in which they are fully described.

(RH PAGE)

PAGE LAYOUT

NOTES FOR EASY CONSULTATION

YChapter

XSection title

WPage N°

ZDate of issue

10.05 7

Introduction

CHAPTER

PAGEISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 1

B- TROUBLESHOOTING

A) CAUTION! Recommendations and precautions regarding

rider safety and vehicle integrity.

B) WARNING! Situations entailing the risk of personal injury

to maintenance or repair mechanics, other workshop

personnel or third parties, or damage to environment,

vehicle or equipment.

C) FIRE HAZARD

Indicates operations which may constitute a fire hazard.

D) RISK OF EXPLOSION Indicates operations which may

constitute a risk of explosion.

E) TOXIC FUMES

Indicates a possibility of intoxication or inflammation of

the upper respiratory tract.

F) MECHANICAL MAINTENANCE Operations to be

performed only by an expert mechanic.

G) ELECTRICAL MAINTENANCE

Operations be performed only by an expert electrical/

electronic technician

H) NO! Operations to be absolutely avoided

I) ENGINE SERVICE MANUAL Indicates information which

may be obtained by referring to said manual.

L) SPARE PARTS CATALOGUE

Indicates information which may be obtained by referring

to said catalogue

810.05

Introduction

CHAPTER

PAGE ISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 1

B- TROUBLESHOOTING

Note:

the letter V in the illustrations refers to retaining or adjusting screws. The number following this letter refers to

the number of the same type of screw in the unit or component described and illustrated. Letters not followed

by a number indicate a single screw. In case of different screws being referred to in the illustration, the letter

Vis followed by a number and a small letter, for instance: (V4a).

Unless otherwise specified, units and components are reassembled by proceeding in the reverse order of

removal.

Before any servicing, make sure that the vehicle is perfectly stable.

The front wheel should preferably be anchored to the equipment integral with the lifting board.

ABBREVIATIONS

FFigure

Cs Tightening torque

PPage

Pr Paragraph

SSection

Sc Diagram

TTable

VScrew

10.05 9

CHAPTER

PAGEISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 2

Electrical components

SECTION 2

B- TROUBLESHOOTING

ELECTRICAL COMPONENTS

1) HORN

2) SWITCH WITH KEY

3) STARTING RELAY

4) FUEL PROBE

5) HV COIL

6) BATTERY

7) C.D.I. CONTROL UNIT

8) VOLTAGE REGULATOR

9) RESISTANCE

10 10.05

CHAPTER

PAGE ISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 2

General wiring diagram

SECTION 2

B- TROUBLESHOOTING

20 21 22

10.05 11

CHAPTER

PAGEISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 2

General wiring diagram

SECTION 2

B- TROUBLESHOOTING

GENERAL WIRING DIAGRAM

COLOUR KEY

N-R BLACK/RED B-R WHITE/RED

R RED BL BLUE

RS PINK BL-R BLUE/RED

VL PURPLE GL YELLOW

VL-N PURPLE/BLACK GL-N YELLOW/BLACK

VR GREEN GL-V YELLOW/GREEN

AR-BL ORANGE/BLUE GL-R YELLOW/RED

AZ LIGHT BLUE GR GREY

AZ-B LIGHT BLUE/WHITE M BROWN

B WHITE M-B BROWN/WHITE

B-N WHITE/BLACK N BLACK

KEY TO THE GENERAL WIRING DIAGRAM

1) 12V BATTERY

2) RELAY

3) STARTER MOTOR

4) REAR LEFT TURN INDICATOR

5) REAR OPTICAL UNIT

6) REAR RIGHT TURN INDICATOR

7) FUEL LEVEL SENSOR

8) VOLTAGE REGULATOR

9) ELECTRICAL STARTER

10) CHASSIS GROUNDING

11) RESISTANCE

12) FRONT RIGHT TURN INDICATOR

13) STOP LIGHT

14) RIGHT HAND SWITCH BLOCK

15) SWITCH WITH KEY

16) INSTRUMENT BOARD

17) HEADLIGHT

18) LEFT HAND SWITCH BLOCK

19) FRONT LEFT TURN INDICATOR

20) HORN

21) FLY WHEEL MAGNETO

22) ELECTRONIC CONTROL UNIT

12 10.05

CHAPTER

PAGE ISSUE

ELECTRIC SYSTEM TROUBLESHOOTING

ENGLISH

SECTION 2

Checking switches

SECTION 2

B- TROUBLESHOOTING

CHECKING SWITCHES

CHECKING PROCEDURES

Using a tester (Code n°08609500), check the switches

by making sure that there is continuity between terminals

and that they are correctly connected.

Replace the switch, even if only one of the possible

combinations does not give the requested result.

NOTE: flick the switch from “ON” to “OFF” several

times and select ::

Set the tester to its correct “0” position,

before connecting the switches.

CONNECTION OF THE SWITCHES DESCRIBED IN THIS MANUAL

- This manual contains connection diagrams, like the one illustrated hereby,

which illustrate how switch terminals should be connected (key switch, brake

switch, start button, etc.).

- The first column from the left indicates the different positions of the switch

and the top line the colour of the wires connected to the switch terminals.

- The “ ” symbol identifies terminals in which there is a condition of continuity,

i.e. a closed circuit, in a certain position of the switch.

- In this diagram:

“B/R” and “N” feature continuity with the button pressed (switch in its “ON”

position).

Table des matières

Autres manuels Malaguti Moto

Malaguti

Malaguti SPIDER MAX GT 500 Manuel utilisateur

Malaguti

Malaguti XSM125 2018 Manuel utilisateur

Malaguti

Malaguti Fast Time F-10 50cc Mode d'emploi

Malaguti

Malaguti Grizzly Minicross RCX/12 50CC Manuel utilisateur

Malaguti

Malaguti MADISON 125cc Manuel utilisateur

Malaguti

Malaguti XTM 50 2007 Manuel utilisateur

Malaguti

Malaguti MADISON 300 2018 Manuel utilisateur

Malaguti

Malaguti XAM CE Manuel utilisateur

Malaguti

Malaguti Password 250 Manuel d'instructions

Malaguti

Malaguti F18 WARRIOR Guide de l'utilisateur

Malaguti

Malaguti MONTE 125 Manuel utilisateur

Malaguti

Malaguti Dune X 125 Mode d’emploi

Malaguti

Malaguti X3Motard Manuel d'instructions

Malaguti

Malaguti MADISON 3 125 cc Manuel d'instructions

Malaguti

Malaguti CNK 50 DRAKON Manuel d'instructions

Malaguti

Malaguti PHANTOM F12 Manuel utilisateur

Malaguti

Malaguti Blog 126 Manuel utilisateur

Malaguti

Malaguti MADISON 125 Manuel utilisateur

Malaguti

Malaguti XTM 50 Manuel d'instructions

Malaguti

Malaguti CNK 50 DRAKON Manuel d'instructions

Malaguti

Malaguti Dune 125 Manuel utilisateur

Malaguti

Malaguti GRIZZLY Manuel utilisateur

Malaguti

Malaguti RST125 2018 Manuel utilisateur

Malaguti

Malaguti SPIDER MAX 500 Manuel utilisateur

Manuels Moto populaires d'autres marques

OHVALE

OHVALE GP-0 Manuel de la liste des pièces

Yamaha

Yamaha Star XV19CTSZ 2009 Manuel utilisateur

KTM

KTM 350 XCF-W USA Manuel utilisateur

HYOSUNG

HYOSUNG ST7 Manuel utilisateur

Husqvarna

Husqvarna FC 250 2016 Manuel utilisateur

Ducati

Ducati SCRAMBLER 800 Manuel d'instructions

MOTO GUZZI

MOTO GUZZI QUOTA 1100 ES Manuel utilisateur

APRILIA

APRILIA ETV MILLE CAPONORD - PART1 02-2001 Manuel utilisateur

Yamaha

Yamaha 2006 YZF-R1V Manuel utilisateur

KTM

KTM Freeride E-XC 2021 Manuel utilisateur

Fantic

Fantic Enduro 125 Manuel utilisateur

Ducati

Ducati Supersport 750 desmodue Manuel utilisateur

MV Agusta

MV Agusta 2008 F4 312RR 1078 Manuel d'instructions

Yamaha

Yamaha XVS650A Manuel utilisateur

Yamaha

Yamaha YZF-R6T(C) Manuel

Ducati

Ducati 748 monoposto strada Manuel utilisateur

ATK

ATK 1988 250 Manuel utilisateur

Excelsior-HENDERSON

Excelsior-HENDERSON 1999 HCX Manuel utilisateur