Functional parts of the device
1. Keyboard case
2. Numeric keypad
3. Keyboard case, rear view
4. Tamper contact
5. Batteries
6. On/Off switch
7. Keypad plate
8. " Partial Arming" button ("Stay"
or "Night Mode")
Selecting the installation location
Carefully select the installation location for the MAKS Keypad mini.
The device cannot be placed:
1. Outdoors or in areas with unacceptable humidity and temperature
2. In places with a high level of radio interference
3. Near objects that can cause radio signal attenuation or shield-
ing (metal, mirrors, etc.)
4. At a distance of less than 1 m from the security center
Installation and connection
1. Use a plastic card to remove
the device from the plate
2. Insert the card into the slot
3. Press down on the fixation
elements with the card
4. Move the keypad up
5. Remove the MAKS Keypad mini
from the back plate
6. Fit the rear plate 7using the
supplied screws and wall plugs.
7. Place the device on the rear plate 7
and slide it down to fix it and lock
the tamper contact 4. Flashes on indicator 15
will confirm that the tamper is locked
Registration and setup
1. Place the detector at a distance of no more than 2 m from the MAKS
PRO security center. Registration is run at on lowest possible power to
avoid the influence of neighboring systems, which can be being set up
nearby
2. Run the MAKS SETUP application
3. Follow the instructions of the application to connect to the MAKS PRO
and start the registration of MAKS wireless devices
4. Turn on the MAKS Keypad mini, after 10-20 seconds it will be registered
5. Set up a new device in your mobile application
Switching on and off
Set switch 6to "ON" to turn on the device. If the device is registered in
MAKS PRO, it switches to standby mode. If the device has not been
registered, it will go into sleep mode after 30 seconds.
To turn off the device, set switch 6to "OFF"
Before installing the MAKS Keypad mini, register it with MAKS PRO and
test the keyboard signal level using the MAKS SETUP app.
We recommend to install the keypad in the following order:
1. Selecting the installation location with the best signal
2. Installation of the back plate
3. Keypad installation
Keypad installation
Battery replacement
1. Use a plastic card to remove the device from the mount
2. Pull out and replace the batteries
3. Place the keypad on the back plate and slide it down until it locks
9. "Partial Arming" LED indicator
10. "Arming" button
11. "Arming" indicator
12. “Disarming” button
13. "Ready" LED indicator
14. "Info" button with reprogramming capability
15 "Info" LED indicator
16. "Cancel" button
17. "OK" button - additional actions
Indication
Disarmed - "Arming" and "Partial Arming" indicators are
switched off
“Stay” armed - “Partial Arming” indicator is red
Arming - "Arming" indicator is on
Entry delay - "Ready" indicator flashes green, keypad emits short
beeps
Not ready for arming - "Ready" indicator is orange
Ready for arming - "Ready" indicator is green
Exit delay - "Ready" indicator flashes green, keypad emits short beeps
Alarm - "Arming" and "Partial Arming" indicators flash red
User is authorized, there are troubles - "Info" indicator is yellow
User not authorized yet - "Info" indicator flashes yellow
1
3
8
9
10
11
12
13
14
15 16 17
7
5 64
2
