Mako StyliCleaner Manuel utilisateur
Getting started:
Getting Started StyliCleaner LK v2022-04
Getting Started StyliCleaner LK v2022-04
Introduction
This presentation describes how a StyliCleaner should be put into use.
Follow all future instructions.
All these instructions are also described in the manuals supplied.
2
Getting Started StyliCleaner LK v2022-04
Contents of the packaging
The following parts are included in the plastic box of the StyliCleaner:
1) Control unit
2) Cleaning unit
3) Manuals
4) CE-Declaration
5) Power supply
6) T-piece for compressed air supply
7) Spare O-rings
8) Socket screw
9) Compresses air hose
10) USB-Stick
3
Getting Started StyliCleaner LK v2022-04
Control unit
Place the control unit on the back of the measuring machine.
Attention!!!
Make sure that the compressed air hose between the control unit and
the cleaning unit is as short as possible.
As a result, there is a little chance that there is still cleaning liquid in
the hose after performing a cleaning.
4
Getting Started StyliCleaner LK v2022-04
Installation control unit using "plateholder"
A special "plateholder" is also available to hold the Control Unit to the side of a CMM. We
include a set of adhesive pads or ‘Velcro coins’ for the back of the plateholder.
5
Getting Started StyliCleaner LK v2022-04
Installation cleaning unit
Place the control unit on the back of the measuring machine.
This is "usually" placed under the
parking position of the measuring
machine.
This allows the compressed air
hose Ø4mm between control unit
and cleaning unit to be as short
as possible.
6
Getting Started StyliCleaner LK v2022-04
Connection cleaning unit
Connect the cleaning unit to the control unit.
1) Connect the black cable to the cleaning unit
2) Compressed air hose Ø4mm cleaning unit
3) Compressed air hose Ø4mm control unit
7
Getting Started StyliCleaner LK v2022-04
Connection power supply
Connect the power supply to the control unit
Pay attention !!!
Do not plug the power supply
into an outlet.
We will only do this when the
entire StyliCleaner is connected.
There are also 2 additional
connection adapters for the
power supply. Use this if
necessary.
8
Getting Started StyliCleaner LK v2022-04
Cleaning liquid
Fill the reservoir of the nebuliser with a cleaning liquid.
Never use heptane for this (this will eventually damage various parts).
Use (if possible) refill bottles with pipette (if possible).
Unscrew the gray screw and fill the liquid through the opening.
Fill the tank maximum by 75% and screw the gray screw back on.
9
Getting Started StyliCleaner LK v2022-04
Spare parts O-rings
2 spare O-rings are supplied with the StyliCleaner.
You can use these O-rings if the O-ring breaks when the cleaning liquid is being
refilled.
10
Table des matières
