Lightcorp Nik Manuel utilisateur
Step 1
Slide unit mount onto
edge of surface.
Included in package:
Step 2
Tighten thumb screws
on underside of the
surface.
Clamp-on surface variation
Unit 2X Thumb Screws
Nik
Installation instructions
Step 3
Plug in the unit.
Step 1
With two of the provided screws, attach the
mounting bracket to the underside of the
surface in the location desired, utilizing the
two slotted holes. Do not fully tighten screws.
Step 2
Adjust the mounting bracket
into its final desired position
and drive in the third screw
through the remaining hole.
Tighten all screws.
Unit Mounting Bracket
3X #10 Wood Screw Plastic Thumb Nut
Included in package:
Under surface mount variation
• Philips head screwdriver
• Pilot drill bit (optional)
Tools needed:
Step 4
Fix the unit with the
provided thumb nut.
Step 3
Feed unit through the mounting
bracket making sure to pass the
threaded stud through the hole in
the back of the bracket.
Step 5
Plug in the unit.
Step 1
Identify the desired location for the unit
and using a hole saw, cut out the respective
shape below into the surface.
Unit Mounting Bracket
Plastic Thumb Nut
Included in package:
Panel mount variation
• 1-11/16” hole saw
•Jig saw
Tools needed:
1.69in
3-TAP UNIT
2-TAP UNIT
1.69in
2.375in
4.053in
Step 2
Feed cord through surface and
seat unit into position.
Step 3
From the back, slide the
mounting bracket over the
unit, feeding the threaded
stud through the hole in
the bracket.
20485.000.000 Rev. A
Step 4
Tighten the provided thumb
nut, securing the unit in
place.
Step 5
Plug in the unit.
Note: Panel mount not intended for use in
work surface, desk surface or similar.
Autres manuels Lightcorp Unité de distribution d'énergie
