LG GW910 Manuel utilisateur

This document is the user guide for the GW910 Windows Phone

Smartphone. All rights for this document are reserved by LG Electronics.

Copying, modifying and distributing this document without the consent of

LG Electronics are prohibited.

GW910 User Guide

- English

Part 15.21 statement

" Change or Modifications that are not expressly approved by the manufacturer could void

the user's authority to operate the equipment. “

Part 15.105 statement

This equipment has been tested and found to comply with the limits for a class B digital

device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful interference or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Part 15 Class B Compliance

This device and its accessories comply with part15 of FCC rules.

Operation is subject to the following two conditions:

(1) This device & its accessories may not cause harmful interference.

(2) This device & its accessories must accept any interference received,

including interference that may cause undesired operation.

Body-worn Operation

This device has been tested for typical body-worn operations

with the distance of 0.79inches (2.0cm) from the user’s body.

To comply with FCC RF exposure requirements, a minimum separation distance

of 0.79inches(2.0cm) must be maintained from the user's body.

Additionally, Belt clips, holsters & other body-worn accessories may not contain

metallic components.

GW910TM Features

Phone Components

Touch Screen

Send Key

Opens the touchscreen

Dialpad and answers

incoming calls

End Key

Ends or rejects a call.

Earpiece

Allows you to listen to the

other party/caller.

Proximity Sensor

Turns off the LCD automati-

cally when in close proximity

to your face, during a call.

Fingerprint Navigation sensor

Scrolls right and left or up and

down to navigate menus.

Hands-free Connector/

Charger/

Back button

Returns to the previous menu

Multitasking Key

MicroSD Card Slot

Camera key

Activates the camera

Stylus Connector Slot

Volume Keys

When the screen is idle:

Adjust the phone volumes

During a call:

Adjust the in-call earpiece

volumes

Power/End Key

Hold down to power the phone On or

Off.

GW910TM Features

SIM card slot

Battery Terminals

External Camera Lens

Soft Reset Key

How to hold your GW910TM

For better RF antenna reception, LG suggests that you hold the handset as

depicted in the figure below.

Do not cover the RF antenna area with your hand during a call.

. This may degrade speech quality.

RF antenna

This product’s keys consist of touch keys displayed on the LCD screen. Be sure to read follow these

Touchscreen Guidelines before using this product.

Make sure your hands are clean and dry.

vIn humid environments, remove any moisture from your fingers or the touch keys.

Touchscreen

It is unnecessary to press the touch keys hard for them to work. Do not subject the product to

severe impact, as this may damage the touch key sensors.

Use the tip of your finger to press precisely on the touch key you want, being careful not to tap

any other keys.

Touch keys may not work properly if a mobile phone case or plastic cover is covering them.

Keep metallic or other conductive materials away from the surface of the touchscreen. Contact

with them may result in errors.

This phone allows you to use a pen or stylus to select Menus. You can also use your finger to

select Menus.

The touchscreen may not function properly in hot and humid environments.

Touchscreen Guidelines

Getting Started

Installing the SIM Card and Battery

1. Installing the SIM card

Your SIM card contains your phone number, service details and contacts and must be inserted into your

handset. If your SIM card is removed, your handset becomes unusable (except for emergency calls,

depending on which Country you are in at the time) until a valid one is inserted. Always disconnect the

charger and other accessories from your handset before inserting or removing your SIM card. Slide the

SIM card into the SIM card holder. Make sure that the SIM card is properly inserted and the gold contact

area on the card is facing downwards. To remove the SIM card, press down lightly and pull it gently

outwards.

To remove the SIM cardTo insert the SIM card

Note

vThe metal contact of the SIM card can easily be damaged by scratches. Pay special attention to the SIM

card while handling. Follow the instructions supplied with the SIM card.

Installing the battery.

Remove the battery cover (as shown below). Align the metal contacts on the bottom edge of the battery

compartment. Press the other end of the battery down until it clicks into place. Finally, place the battery

cover on the phone as shown below.

Charging the Battery

Before connecting the charger to the phone, you must first check if the battery is installed.

Charging Mode

When you charge your phone, the phone’s LED next to the earpiece of your phone turns red.

When the phone is fully charged, the LED turns green.

Note

vIf the phone is off while charging, you can press the power key for approx. 2 seconds and it will turn on.

vWhen the battery is completely discharged, the red LED blinks and you can’t turn on the phone at this

moment. As soon as the charged power reaches 1%(after a few minutes), the LED stops blinking and

charging animation is displayed. Then you can power on the phone.

CAUTION!

• When you charge a fully discharged battery, it may take over a minute for the display to respond.

This is not a malfunction but completely normal.

• Do not force the connector in, as this may damage the phone and/or the charger.

• If you use the charger out of your own country, use an attachment plug adaptor for the proper

configuration.

• Do not remove your battery or the SIM card while charging.

• There is risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries

according to the manufacturer’s instructions.

WARNING

• Unplug the charger from the power source and the phone during lightning storms to avoid electric

shock or fire.

• Make sure that no sharp-edged items such as animal teeth or nails come into contact with the

battery. It may cause a fire.

Getting Started

Disconnecting the Charger

Disconnect the travel adapter from the phone as shown in the diagram below. Make sure you pull the

plug, not the cord.

Table des matières

Manuels Téléphone portable populaires d'autres marques

Zte

Zte BLADE A520 Manuel utilisateur

Nokia

Nokia Lumia 620 Manuel utilisateur

Blackbe;rry

Blackbe;rry KEYone Manuel utilisateur

Bea-fon

Bea-fon X5 Premium Manuel utilisateur

Blackbe;rry

Blackbe;rry 8707 Series Manuel utilisateur

Blackbe;rry

Blackbe;rry Storm Mode d'emploi

LifeWatch

LifeWatch V Manuel utilisateur

Bea-fon

Bea-fon SILVER LINE SL860 Manuel utilisateur

IKI Mobile

IKI Mobile KF4.5i Manuel utilisateur

Hitech

Hitech HT-850 Manuel utilisateur

Yezz

Yezz Fashion F10 Manuel utilisateur

Point Mobile

Point Mobile PM60 Manuel utilisateur

Blackbe;rry

Blackbe;rry Q10 Manuel utilisateur

Blackbe;rry

Blackbe;rry Bold 9900 Manuel utilisateur

Blackbe;rry

Blackbe;rry STORM 9500 - VERSION 5.0 Manuel utilisateur

ISAFE MOBILE

ISAFE MOBILE IS655.2 Manuel utilisateur

Blackbe;rry

Blackbe;rry CURVE 8300 - SMARTPHONE Manuel utilisateur

Blackbe;rry

Blackbe;rry 8707 - VERSION 4.1 Manuel utilisateur