LEGRAND HKRL10 Manuel utilisateur

installation guide

Smart Switch

Room . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

HKRL10

with HomeKit Technology

table of contents

before you start..................................3

what you need ...................................4

getting to know your switch ..........6-7

installation and setup ................ 8–23

speciﬁcations.............................24-25

faqs ....................................... 25–29

regulatory information ......... 30–33

warranty.......................................34

support ........................................35

before you start

Review this guide in its entirety before beginning device installation. Consult an

electrician with any questions or if you are unsure of your abilities.

DWarning: Incorrect installation could

result in death, serious injury, and/or

damage to your home or devices.

DCaution: To reduce the risk of injury

and/or overheating and damage to other

equipment:

• For dry, indoor use only.

• Do not use to power medical equipment.

• Not suitable as a disconnecting means.

• Do not use with loads exceeding the

device load rating (see page 24).

• Connect the smart switch to a

120 VAC, 60 Hz power source ONLY.

• Always use copper wire to install the

smart switch and follow all applicable

local and national electrical codes.

• Install in a non-metallic electrical box

to protect wireless signal strength.

Visit the Legrand website at www.legrand.us/radiant/homekit.aspx to learn more about

your smart device.

what you need

REQUIRED:

Phillips-head screwdriver

Flat blade screwdriver

YOU MAY ALSO NEED:

Non-contact voltage tester, pliers, wire cutter, wire stripper, electrical tape,

ﬂashlight, radiant®screwless wallplate (included), wiring leads (included), and

wire nuts (included)

NOTE: Exercise caution when using power tools. Overtightening the screws can

damage the device.

getting to know your switch

Item Name Description

1 Paddle Switch

• Press the top of the paddle to turn the light on

and the bottom to turn the light off.

• To return the switch to factory default, press and

hold the top of the paddle for 15 seconds. Then,

remove the device from the Legrand Home app

(or Apple Home app).

2 LED Locator Light Indicates the current state of the device. Refer to

“LED Locator Light Explanations” for detail.

NOTE: For in-wall control of this switch in a three-way application, refer to the installation

instructions for the HomeKit Remote Switch (HKRL20).

LED LOCATOR LIGHT EXPLANATIONS

LED

Color State of Light Explanation

Slowly Flashing

Amber

Device is attempting to connect to

the network

Solid White Connected to Wi-Fi and turned off

No Light Device is on

Rapidly Flashing

Amber

N-Way Pairing mode: device is

ready to pair with the remote(s)

installation & setup

step one

turn off the power for your device at the

circuit breaker

Flip the existing light switch multiple times to conﬁrm the power is off.

NOTES:

• If there are multiple devices next to your existing light switch, make sure power is

off at the circuit breaker for all of those devices.

• For multi-way installations using a remote switch, follow the instructions for the

remote device (HKRL20).

OFF

installation & setup

step two

remove the existing device

Check for the following wires:

1HOT or LINE: Receives power from the circuit box. Referred to as “hot” for the

purposes of this guide. Do not touch or let “hot” wires contact other wires.

2LOAD: Directs power to your light(s).

3NEUTRAL: Creates a path to return current to the power source when the

device is off. Required for your switch installation.

4GROUND: Provides a safe path for electricity in the event of a short circuit.

NOTE: Refer to the “faqs” on page25 if you are unsure of your wiring.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels LEGRAND Changer

LEGRAND

LEGRAND Celiane 673 23 Manuel utilisateur

LEGRAND

LEGRAND C2G 29974 Manuel utilisateur

LEGRAND

LEGRAND Plexo 695 06 Manuel utilisateur

LEGRAND

LEGRAND Celiane 048896A Manuel utilisateur

LEGRAND

LEGRAND Pass & Seymour WattStopper DRCL453P Manuel utilisateur

LEGRAND

LEGRAND WattStopper RH-200 Manuel utilisateur

LEGRAND

LEGRAND Qmotion QIS Manuel d'installation

LEGRAND

LEGRAND radiant WWRL10WHCCV2 Manuel utilisateur

LEGRAND

LEGRAND Mosaic Manageable switch Manuel de l'opérateur

LEGRAND

LEGRAND DPX 3 250 Manuel utilisateur

LEGRAND

LEGRAND In One Celiane 672 15 Manuel utilisateur

LEGRAND

LEGRAND 0 672 27 Manuel utilisateur

LEGRAND

LEGRAND 0 226 04 Manuel utilisateur

LEGRAND

LEGRAND Plexo 698 50 Manuel utilisateur

LEGRAND

LEGRAND PRO 21 7756 29 Manuel utilisateur

LEGRAND

LEGRAND Pro 21 7756 39 Manuel utilisateur

LEGRAND

LEGRAND 3 109 53 Manuel utilisateur

LEGRAND

LEGRAND Valena Life Manuel utilisateur

LEGRAND

LEGRAND 4 142 21 Manuel utilisateur

LEGRAND

LEGRAND RRW600V Manuel de service

LEGRAND

LEGRAND 488 01 Manuel utilisateur

LEGRAND

LEGRAND Chief Kontour KPWR Series Manuel utilisateur

LEGRAND

LEGRAND radiant WNP10 Manuel utilisateur

LEGRAND

LEGRAND 841 01 Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur