5
Do not look directly at the light source from close range.
Take precautions to prevent injury due to falls when working at height.
For permanent installation, ensure that the fixture is securely fastened to a
load-bearing surface with suitable corrosion-resistant hardware.
For temporary installation with clamps, ensure that the quarter-turn
fasteners are turned fully and secured with a suitable safety cable. The
cable must be approved for a safe working load (SWL) of 10 times the
weight of the fixture, and it must have a minimum gauge of 3 mm.
3. Preparing for installation
Unpack the fixture and inspect it to ensure that it has not been damaged during
transport.
The fixture is shipped with two quarter-turn brackets, that can be used to
mount the fixture at elevation.
The fixture is IP65-rated, and is designed for use in wet locations. This means
that it is protected from:
Dust, to the degree that dust cannot enter the fixture in sufficient
quantities as to interfere with its operation.
Lower pressure jets of water from any direction.
When selecting a location for the fixture, ensure that:
It is situated away from public thoroughfares and protected from contact
with people.
It is not immersed in water or exposed to high-pressure water jets.
It has adequate ventilation.
4. Installation
The fixture may be installed in any orientation, but if installed horizontally with
a downward beam-angle, water can potentially pool in the fan wells. Under
