Larson Electronics LED10W-LT Manuel utilisateur

Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com

9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364

LED10W-LT

BATTERY SPECIFICATIONS

12 volt output

33 Amp hour AGM sealed lead acid

Built-in automatic charger rated for continuous duty

Voltage indicator gauge with push-to-test button

External charge cord receptacle, U.S. or foreign power cord supplied

Battery rated for 300+ full discharge cycles

3-5 year estimated service life

1 year warranty

SET-UP

1. Charge unit for 24 hours when new and every three months thereafter to maintain a full

charge (Charge monthly in hot weather)

2. Do not charge or use this light in hazardous location

3. Extend retractable legs if necessary for uneven terrain

4. Extend aluminum pole to desired height and tighten each pole section into position

OPERATION

1. Single head light will operate over 40 hours on a full charge

2. Dual head light will operate over 20 hours on a full charge

3. The power port provided can be used to operate a cell phone, a laptop computer, or any

of Larson Electronics’ handheld light with cigarette plug. The power port can be used as

a quick charge inlet for the light from an automobile’s 12-volt power port.

SAFETY AND USAGE INFORMATION

1. Read these instructions completely before using the products and save them for future

reference.

2. Do not use unit to recharge dry cell batteries

3. Do not jump-start or attempt to recharge a frozen battery.

4. Charge unit in a well-ventilated area.

5. All batteries are affected by temperature changes, and the unit’s small, lightweight

battery is more sensitive to storage temperature than a standard automotive battery.

Temperatures above 68° F (20° C) decrease amperage output. The ideal storage

environment for emergency use is at room temperature.

Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com

9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364

BATTERY STATUS GAUGE

1. Press the RED push button momentarily to turn the gauge on:

2. The GREEN shaded indicator bar indicates the unit is capable of normal operation.

3. The YELLOW shaded indicator bar indicates the unit needs to be recharged.

4. The RED shaded indicator bar indicates the unit must be recharged before use.

RECHARGING

1. Plug the unit into 115 VAC and note the lighted gauge indicator for battery status.

2. The unit may be recharged by using an optional accessory power port cord with two

male ends.

3. Plug one end into the unit’s 12V outlet and the other end into the vehicle’s 12V power

port socket. The vehicle must be running to charge with this method.

STORAGE

Unit may be stored virtually anywhere, and in any position.

BATTERY REPLACEMENT

This unit contains a sealed non-spillable lead acid battery. The battery must be recycled.

Contact Larson Electronics’for replacing battery.

Table des matières

Autres manuels Larson Electronics Mettre en lumière

Larson Electronics

Larson Electronics HL-85-HID Manuel utilisateur

Larson Electronics

Larson Electronics GL-3610-S-E Manuel

Larson Electronics

Larson Electronics HUL-LED25WRE-CPR Manuel utilisateur

Larson Electronics

Larson Electronics Golight Radioray GL-2051GT Manuel utilisateur

Larson Electronics

Larson Electronics GL-2110-F Manuel

Larson Electronics

Larson Electronics GL-2000-S-E Manuel

Larson Electronics

Larson Electronics GL-30675-F Manuel utilisateur

Larson Electronics

Larson Electronics RCL700 Manuel d'exploitation et d'entretien

Larson Electronics

Larson Electronics GL-3100-S-12-E Manuel

Larson Electronics

Larson Electronics Golight Stryker GL-3049-P Manuel

Larson Electronics

Larson Electronics APM-GL20004 Manuel utilisateur

Larson Electronics

Larson Electronics GL-2100-E-F Manuel

Larson Electronics

Larson Electronics Golight RadioRay GL-7 GT Series Manuel utilisateur

Larson Electronics

Larson Electronics 2000-M Manuel

Larson Electronics

Larson Electronics RL-14 Manuel utilisateur

Larson Electronics

Larson Electronics MUL-30-LED Manuel utilisateur

Larson Electronics

Larson Electronics GL-8130-M Manuel utilisateur

Larson Electronics

Larson Electronics RL-85-10W1 Manuel utilisateur

Larson Electronics

Larson Electronics GL-30004-S-E Manuel

Larson Electronics

Larson Electronics Golight Stryker GL-30064ST Manuel utilisateur

Larson Electronics

Larson Electronics HUL-LED25WRE-CPR-TRP Manuel utilisateur

Larson Electronics

Larson Electronics GL-9950 Manuel

Larson Electronics

Larson Electronics HL.RL-85-LED-36W-CPR-1227 Manuel utilisateur

Larson Electronics

Larson Electronics GVP-48-2L-LED-D-V2 Manuel utilisateur

Manuels Mettre en lumière populaires d'autres marques

Guangzhou Yinhe Lighting&Sound Equipment Factory

Guangzhou Yinhe Lighting&Sound Equipment Factory NE-204 Manuel utilisateur

LIVARNO home

LIVARNO home 375304 2101 Instructions originales

Cameo

Cameo CLQS40WW Manuel utilisateur

Leviton

Leviton Ellipsoid 5/50 Manuel utilisateur

Monacor

Monacor img Stage Line PARL-56PDX/CR Manuel utilisateur

Vector

Vector SL3AKV Manuel utilisateur

Quantum

Quantum Q262 Manuel d'exploitation

Philips

Philips Vari-lite VL3015LT Manuel utilisateur

EUROSPOT

EUROSPOT C51 Manuel utilisateur

DTS

DTS MINI BRICK ARC Manuel utilisateur

Federal Signal Corporation

Federal Signal Corporation VISIBEAM II Manuel

ACME

ACME LED-MS350B Manuel utilisateur

EuroLite

EuroLite Akku flat light 1 Manuel utilisateur

Commercial Electric

Commercial Electric SPTM-1401 Manuel utilisateur

Vision & Control

Vision & Control SLB-500-W5K7-P-SL Manuel utilisateur

Teknik

Teknik FLEXI Manuel utilisateur

Craftsman

Craftsman CMXLSB10 Manuel utilisateur

EuroLite

EuroLite LED SLS-144 UV Floor Spot Manuel utilisateur