Larson Electronics ATEX-EPL-TL-3X10W-C Manuel utilisateur

ATEX-EPL-TL-3X10W-C

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

30W Explosion Proof Traffic Light

Instruction Manual

Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this

instruction sheet. Read carefully before operating. Retain these instructions for future reference.

INSTALLATION PRECAUTIONS

•Do not attempt installation until you are familiar with all warnings, precautions, and procedures outlined within this

instruction sheet.

•Do not install fixture in any classified location where the marked operating temperature exceeds the ignition

temperature of the hazardous atmospheres. Consult fixture nameplate for suitability in specific hazardous

locations.

•Do not install fixture in a location where the ambient temperature exceeds the maximum ambient temperature

shown on the fixture nameplate.

•Refer to fixture nameplate for minimum supply wire temperature rating.

•Verify that the supply voltage agrees with fixture rating as indicated on nameplate.

•All local and national electrical/building codes must be followed when installing the lighting fixture. FOR CODE

INTERPRETATION, CONSULT YOUR LOCAL CODE AUTHORITY.

•Product must be used only with globe intact and fully engaged. Replace cracked or damaged globe prior to use.

WARNINGS

•Electrical power must be off before and during installation and maintenance.

•Use only lamp size and wattage as shown on fixture nameplate.

•Fire and Explosion Hazard: Breakage of glass globe and exposure of lamp to a combustible atmosphere

can result in an explosion and possible injury or death.

•During installation or maintenance, care should be taken not to scratch, score, nick, or chip the glass globe.

•Fixture must be grounded as required per paragraph 410-21 and article 250 National Electric Code and/or

rule 30-500 and section 10 of Canadian Electric Code. Failure to properly ground this fixture will create an

electrical shock hazard which can cause serious injury or death.

•Do not energize the fixture until the globe assembly has been installed to avoid exposing hot surfaces or

electric arcing to hazardous atmosphere. Failure to comply with this warning can cause fire or explosion

which can result in serious injury or death.

INSTRUCTIONS FOR INSTALLATION

This unit ships with the selected Voltage, Colors, and Beam Config pre-configured. We

strongly recommend only a licensed electrician install this product.

WARNING: Make sure power is disconnected prior to installing.

This fixture must be mounted to a surface that can structurally support the load.

Four mounting holes are predrilled into the sides of the stack light back plate.

1. Turn off power at electrical panel.

2. Locate surface mounting holes. Raise fixture into place and drive mounting screws

through the predrilled mounting holes.

3. Run cable to power source and wire to correct voltage following all appropriate

procedures for the hazardous area.

NOTE: Fixture must be grounded. Check ground continuity before energizing the

fixture.

4. See wire labels for connections. Connect line lead to terminal marked

“RED”, “YELLOW” or “GREEN”. Complete circuit by attaching neutral

marked “NEUTRAL”. Attach additional line lead or switch to control

colors independently. Fixture must be grounded.

WARNING: Check product label for voltage! Damage

from improper voltage may void warranty.

5. Visually inspect connections and ensure all proper electrical

procedures for the hazardous area have been followed.

ATEX-EPL-TL-3X10W-C

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

RELAMPING PROCEDURES

WARNING: Disconnect this fixture from supply circuits before removing globe to avoid

exposing hot surfaces or electric arcing to hazardous atmospheres. Do not re-energize

until the globe has been re- installed. Failure to comply with this warning can cause fire

or explosion which can result in serious injury or death.

1. Remove globe. Loosen set screw and carefully unscrew screw globe assembly

(counterclockwise) to remove.

2. Remove lamp and replace.

NOTE: Verify that the replacement lamp complies with lamp specifications on fixture

nameplate, then install.

3. To reassemble globe assembly, refer to installation procedure.

GUARD REMOVAL

Loosen screws around globe guard and rotate to remove.

FIXTURE CLEANING

Periodic cleaning of the globe assembly may be needed to maintain full lighting efficiency and

to prevent excessive dustordirt accumulation, which could cause the fixture to operate at a

higher temperature.

Cleaning the fixture components should be done with a non-abrasive solution of soap or

detergent and water. Residual solution should be removed byclean water rinsing.

USE AND CARE

Unauthorized modification may impair the function and/or safety of the work light and could affect the life of the

equipment. Always check damaged or worn out parts before using the work light. When work light is not in use, store it in

a secure place out of the reach of children. Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The ATEX-EPL-TL-3X10W-C isdesigned to provide years of reliable performance. Should the need for replacement parts

arise, please contact Larson Electronics.

Should further information not covered bythese instructions be required, please contact Larson Electronics at

1-800-369-6671 or sales@larsonelectronics.com for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

SET SCREW

Table des matières

Autres manuels Larson Electronics Luminaire

Larson Electronics

Larson Electronics RCL360-LED-40 Manuel utilisateur

Larson Electronics

Larson Electronics GVP-48-2L-LED-125VDC Manuel utilisateur

Larson Electronics

Larson Electronics GAU-WP-500LTL-LED-WG-DNMS Manuel utilisateur

Larson Electronics

Larson Electronics GVP-EMG-48-2L-LED Manuel utilisateur

Larson Electronics

Larson Electronics EPL-EMG-HB-50LED-RT-WLM Manuel utilisateur

Larson Electronics

Larson Electronics IND-AHC-CR-12-UVC-R1-120V Manuel utilisateur

Larson Electronics

Larson Electronics SPLT-1.59K-800A-30-4X100W-LED-MS Manuel utilisateur

Larson Electronics

Larson Electronics EPL-PM-1X30LED-100 Manuel

Larson Electronics

Larson Electronics WAL-SBDL-SS-WP60E-24-1227 Manuel utilisateur

Larson Electronics

Larson Electronics GVP-48-2L-LED-G3 Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LB-50LED-RT-CM Manuel utilisateur

Larson Electronics

Larson Electronics GAU-HB-12L-LED-WP-WCM Manuel utilisateur

Larson Electronics

Larson Electronics LEDWP-600E-E2E-10C Manuel utilisateur

Larson Electronics

Larson Electronics IND-HR-UVC-EXS-R1-24-3L-120V-2X Manuel utilisateur

Larson Electronics

Larson Electronics HALD-24-1X100LED-DIMM Manuel utilisateur

Larson Electronics

Larson Electronics EPL-AMB-150LED-200 Manuel utilisateur

Larson Electronics

Larson Electronics EPL-PM-1X30LED-120XLV-100 Manuel

Larson Electronics

Larson Electronics EPLC2-LB-40LED-RT-CM Manuel utilisateur

Larson Electronics

Larson Electronics Golight Manuel utilisateur

Larson Electronics

Larson Electronics GVP-48-2L-LED-D-LV Manuel utilisateur

Larson Electronics

Larson Electronics EPLC2-LB-25LED-RT Manuel utilisateur

Larson Electronics

Larson Electronics HAL-16BS-1X185LED-CPR-100 Manuel

Larson Electronics

Larson Electronics CL1B-SS-PM-1227 Manuel utilisateur

Larson Electronics

Larson Electronics EPL-HB-150LED-PND Manuel utilisateur

Manuels Luminaire populaires d'autres marques

Emos

Emos CLASSIC ZY1431T Manuel utilisateur

Westinghouse

Westinghouse Outdoor Lighting Fixture Manuel utilisateur

Hedler

Hedler C 12 silent Manuel utilisateur

Blizzard Lighting

Blizzard Lighting Puck: CSI Manuel utilisateur

Energetic Lighting

Energetic Lighting ELYSL-5004 Series Manuel utilisateur

Lightmaxx

Lightmaxx Shaft 5R Manuel utilisateur

Triarch

Triarch 31083 Manuel utilisateur

Philips

Philips 32614 Series Manuel utilisateur

IKEA

IKEA TIVED Manuel utilisateur

Lightolier

Lightolier LP200 Manuel utilisateur

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH Manuel utilisateur

Martin

Martin MAC 250 Krypton Manuel utilisateur

Cooper Lighting

Cooper Lighting Halo L3232E Manuel utilisateur

Stageline

Stageline ODW-2410RGBW Manuel utilisateur

Light Sky

Light Sky Tornado Series Manuel utilisateur

Lightolier

Lightolier Paralyte 2424 PLA2G9LS26U Manuel utilisateur

Lightolier

Lightolier Lytespan 83ED17S Manuel utilisateur

Lightolier

Lightolier Calculite CS8226 Manuel utilisateur