La Crosse Technology WS-7016U Manuel utilisateur

WS-7016U

Wireless 433 MHz

Temperature Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Inventory of Contents 1

Additional Equipment 1

Quick Setup 2

Detailed Setup Guide

Battery Installation 3-6

Remote Control Sender 3-4

Indoor Temperature Station 5-6

Setting the Time 7-8

Selecting Units of Measurement 8

Features

Indoor Minimum and Maximum

Temperatures

Outdoor Minimum and

Maximum Temperatures

10-11

Resetting the Indoor Minimum

and Maximum Temperatures

11-12

Resetting the Outdoor Minimum

and Maximum Temperatures

Reading the Temperature Trend 13

Mounting

iii

Remote Control Sender 13-16

Indoor Temperature Station 16-18

Using Multiple Remote Control Senders

Setup of Multiple Units 18-21

Viewing Remote Control

Senders

21-22

Features of the Multiple Remote

Control Senders

22-23

Troubleshooting 24-28

Maintenance and Care Instructions 28-29

Specifications 29-31

Warranty Information 31-33

FCC DISCLAIMER 34

INVENTORY OF CONTENTS

1. The Indoor Temperature Station (Figure 1)

2. The Outdoor Remote Control Sensor

(TX3U) and mounting bracket. (Figure 2)

3. 3 each, 1/2” Philips screws.

4. One strip of double sided adhesive tape.

5. Instruction Manual and Warranty Card.

ADDITIONAL EQUIPMENT (not included)

1. 1 Philips screwdriver.

2. 1 Flat screwdriver.

Figure 1

Figure 2

3. 2 Fresh AA 1.5V batteries.

4. 2 Fresh AAA 1.5V batteries.

QUICK SETUP

1. Insert two AAA batteries into the Remote

Control Sender.

2. Insert two AA batteries into the Indoor

Temperature Station.

3. Wait 5-6 minutes, or until the outdoor

temperature is displayed in the OUTDOOR

LCD (Liquid Crystal Display) of the Indoor

Temperature Station.

4. Set the Time (See complete instructions

for details).

5. Mount units.

Note: The Remote Control Sender transmits a

signal every 3 minutes. After the batteries have

been installed, the Indoor Temperature Station

searches for these signals for a duration of 6

minutes. If there is no temperature reading in

the OUTDOOR LCD after 6 minutes, make

sure the units are within range of each other, or

repeat battery installation process.

DETAILED SETUP GUIDE

I. BATTERY INSTALLATION

A. REMOTE CONTROL SENDER

1. Remove the mounting bracket.

The bracket snaps on and off with

minimal effort.

Battery compartment

Battery cover

2. Remove battery cover. To do this,

remove the flathead screw located

in the lower-central position of the

unit. The rubber weather-seal

creates a tight seal for the battery

cover, and does not allow the

battery cover to fall away from the

unit. Place the screw partially

back into the hole and angle it

slightly, so the threads grab the

battery cover. With the screw,

pull the battery cover off.

3. Observing the correct polarity,

install 2 AAA batteries. The

batteries will fit tightly—make

sure they do not spring free, or

start-up problems may occur.

4. Check the LCD screen of the

Remote Control Sender to see if

there is a temperature reading. If

there is no reading check the

polarity of the batteries or replace

with new batteries.

5. Observing that the rubber

weather-seal is in place; replace

battery cover, screw, and

mounting bracket.

B. INDOOR TEMPERATURE

STATION

Note: After the batteries are installed, DO

NOT press any buttons. This may interfere

with the signals, causing temperatures to

1. Remove the battery cover on the

backside. To do this, push up and

pull out.

Battery

Cover

2. Observing the correct polarity,

install 2 AA batteries.

3. Replace battery cover.

4. Wait 5-6 minutes or until both

indoor and outdoor temperatures

are shown on the Indoor

Temperature Station.

5. The Indoor Temperature Station

should now show: “-:- -” in the

TIME LCD, and temperatures in

the INDOOR and OUTDOOR

LCD’s.

TIME LCD

INDOOR LCD

OUTDOOR LCD

II. TIME

Control Buttons

A. SETTING THE TIME

1. Press and hold the SET button for

1 second. “12h” will appear in the

TIME LCD.

2. Use the INDOOR button to select

either 12h time or 24h time (12h is

an AM—PM mode, and 24h is

military time).

3. Press the SET button 2 times,

“TIME” will flash in the upper left

corner.

4. Press the INDOOR button to set

the hours, and press the

OUTDOOR button to set the

minutes.

Autres manuels pour WS-7016U

Table des matières

Autres manuels La Crosse Technology Thermomètre

La Crosse Technology

La Crosse Technology 314-152 Manuel utilisateur

La Crosse Technology

La Crosse Technology K84377 Manuel utilisateur

La Crosse Technology

La Crosse Technology 922-818 Dimensions

La Crosse Technology

La Crosse Technology T83639 Dimensions

La Crosse Technology

La Crosse Technology 308-1409BTV3 Dimensions

La Crosse Technology

La Crosse Technology K84377 Dimensions

La Crosse Technology

La Crosse Technology 308-179 Manuel utilisateur

La Crosse Technology

La Crosse Technology 314-152B Manuel utilisateur

La Crosse Technology

La Crosse Technology 308-1910 Manuel utilisateur

La Crosse Technology

La Crosse Technology 306-645 Manuel

La Crosse Technology

La Crosse Technology WS-9006U Manuel utilisateur

La Crosse Technology

La Crosse Technology WT-62U Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-9160U-IT Manuel utilisateur

La Crosse Technology

La Crosse Technology T83622 Dimensions

La Crosse Technology

La Crosse Technology 308-1409BTV4 Manuel utilisateur

La Crosse Technology

La Crosse Technology T83622v2 Manuel utilisateur

La Crosse Technology

La Crosse Technology 308-1410GRV2 Manuel utilisateur

La Crosse Technology

La Crosse Technology LTV-POOL Manuel utilisateur

La Crosse Technology

La Crosse Technology WT-1025 Manuel utilisateur

La Crosse Technology

La Crosse Technology WS-1025U Manuel utilisateur

La Crosse Technology

La Crosse Technology 314-152-BL Manuel utilisateur

La Crosse Technology

La Crosse Technology CA84411 Manuel utilisateur

La Crosse Technology

La Crosse Technology 308-1409BTV4 Manuel utilisateur

La Crosse Technology

La Crosse Technology INFRASCAN IR 101 Manuel utilisateur

Manuels Thermomètre populaires d'autres marques

Delton

Delton 981A Manuel utilisateur

Baker

Baker MM2P Manuel utilisateur

Tarmo

Tarmo 320281 Manuel utilisateur

Citizen

Citizen CTD 504 Manuel utilisateur

TFA

TFA 14.1500 Manuel utilisateur

Vive

Vive DMD1010 Manuel utilisateur

Gotemp

Gotemp THB4002 Manuel utilisateur

GREISINGER

GREISINGER G 1202 Manuel utilisateur

Amprobe

Amprobe TMD-53W Manuel utilisateur

Trotec

Trotec BP10 Manuel utilisateur

Radiance instruments

Radiance instruments RT616 Series Manuel utilisateur

Eurolec

Eurolec IR151 Manuel utilisateur

Scaneo

Scaneo TS42B Manuel utilisateur

Sper scientific

Sper scientific 800043 Manuel utilisateur

Microlife

Microlife NC 200 Mode d’emploi

Motorola

Motorola MBP69SN Guide de configuration

The MeatStick

The MeatStick The MeatStick Manuel utilisateur

Hama

Hama TH35-A Manuel utilisateur