Kramer VM-218DTxr Manuel utilisateur

VM-218DTxr Quick Start (P/N: 2900-300622QS REV 2)

P/N:

2900- 300622QS

Rev:

Scan for full manual

VM-218DTxr Quick Start Guide

This guide helps you install and use your VM-218DTxr for the first time.

Go to www.kramerav.com/downloads/VM-218DTxr to download the latest user manual and check if

firmware upgrades are available.

Step 1: Check what’s in the box

VM-218DTxr HDMI/HDBT Switcher/DA

1 Quick start guide

1 Set of rack

ears

1 Power cord

4 Rubber feet

Step 2: Get to know your VM-218DTxr

Feature

Function

IR LED

Lights orange when the unit accepts IR remote commands.

IR Sensor

Enabled only if IR OUT 2 (on the rear panel) is not connected.

Use to control a peripheral device connected to OUT 2 HDBT with that device’s remote

controller.

POWER LED

Lights when the unit is powered.

VOLUME ()

Press to decrease the volume of the analog audio output.

VOLUME ()

Press to increase the volume of the analog audio output.

INPUT Selector Button

Press to select input 1 HDMI or input 2 HDBT.

INPUT LEDs

Lights green to indicate the selected input: 1 HDMI or 2 HDBT.

EDID READ Button

Press to read the selected EDID and write it to both inputs.

EDID SELECT Button

Press to cycle through the sources from which to read the EDID: Default, External, or Output.

When Output is selected, cycles through outputs 1 to 9. The relevant EDID TYPE and OUTPUT

LEDs light green.

EDID TYPE LEDs

Lights green to indicate the selected EDID type: DEFAULT, EXT. (external) or OUTPUT.

OUTPUT LEDs (1 to 9)

In normal operation mode: lights green when an acceptor is connected to the output.

In EDID mode: when EDID TYPE OUTPUT LED lights green, press the EDID SELECT button

briefly to cycle through output 1 to 9 to select the output from which to read EDID. The relevant

LED lights during EDID setup and remains lit after completing the EDID setup.

Feature

Function

IN 2 IR on a 3.5 Mini Jack

Connect to an IR emitter/sensor cable for IR link extension via IN 2

HDBT.

IN 2 RS-232 (G, Rx, Tx) Terminal Block Connector

Connect to a serial controller for RS-232 link extension via IN 2

HDBT.

IN 1 HDMI Connector

Connect to an HDMI source.

IN 2 HDBT on RJ-45 Connectors

Connect to an HDBT transmitter (for example, TP-580Txr).

IR OUT on 3.5 Mini Jacks (2 to 9)

Connect to remote IR emitter/sensor cables to IR control the devices

that are connected to the HDBT acceptors.

RS-232 OUT (G, Rx, Tx) Terminal Block

Connectors (2 to 9)

Connect to serially control the devices connected to the HDBT

acceptors.

OUT 1 HDMI Connector

Connect to a local HDMI acceptor.

OUT HDBT RJ-45 Connectors (2 to 9)

Connect to HDBT receivers (for example, TP-580Rxr).

AUDIO OUT 3.5mm Mini Jack

Connect to an analog audio acceptor.

RS-232 CONTROL 3-pin Terminal Block

Connect to the serial controller to control the VM-218DTxr.

REMOTE 3-pin Terminal Block

For future use.

SETUP DIP-switches

Use to set the device behavior.

ETHERNET RJ-45 Connector

Connect to LAN for Ethernet extension via IN and OUT HDBT ports

and remote IP control of the VM-218DTxr.

RESET Button

Press and hold while powering on the device to reset to factory

default parameters.

PROG Mini USB Connector

Connect to a PC to perform firmware upgrades.

Mains Power Connector, Fuse, and Switch

Connect to the mains supply.

Step 3: Install VM-218DTxr

Install VM-218DTxr using one of the following methods:

Remove the three screws from each side of the unit, reinsert those screws through the rack ears

and mount on a 19" rack.

Attach the rubber feet and place the unit on a flat surface.

Step 4: Connect the inputs and outputs

Always switch OFF the power on each device before connecting it to your VM-218DTxr. For best results, we recommend that

you always use Kramer high-performance cables to connect AV equipment to the VM-218DTxr.

RJ-45 Pinout:

DIP-Switch Settings

For the Ethernet connector, see the wiring diagram

below:

Changes to the DIP-switches only take effect on power-up. After

changing a switch, reboot the device. All DIP-switches are set to Off

(up) by default.

PIN EIA /TIA 568B

Wire Color

Feature

Dip-switch Settings

Orange / White

Reserved

Orange

Range mode

On (down) –HDBaseT Ultra-long range

(provides increased range at a reduced

bandwidth).

Off (up) –Normal range (default).

Green / White

Blue

Blue / White

Note that range mode affects the HDBT input only

Green

Digital audio

pass-through

On (down) –Digital audio pass-thru with

compressed audio clear traversal.

Off (up) –Digital audio de-embedding (default).

Brown / White

Brown

Note that enabling digital audio pass-thru (On) mutes its

de-embedding via the analog output.

Force RGB

On (down) –Force RGB mode.

Off (up) –Normal mode (default)

For optimum range and performance use the recommended Kramer cables available at www.kramerav.com/product/VM-218DTxr.

Step 5: Connect the power

Connect the power cord to VM-218DTxr and plug it into the mains electricity.

Safety Instructions

Caution:

There are no operator serviceable parts inside the unit.

Warning:

Use only the power cord that is supplied with the unit.

Warning:

Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.

Warning:

Disconnect the power and unplug the unit from the wall before installing.

See www.KramerAV.com for updated safety information.

Step 6: Operate the VM-218DTxr

Web pages:

RS-232 and Ethernet:

RS-232/Ethernet

Baud Rate:

115,200

Parity:

None

Data Bits:

Command Format:

ASCII Protocol

3000

Stop Bits:

Example (Route input 1 to output 1):

#ROUTE 1,1,1

<cr>

Ethernet Parameters

IP Address:

192.168.1.39

Subnet Mask:

255.255.0.0

Default UDP Port #:

50000

Default Gateway:

192.168.0.1

Full Factory Reset

Front Panel

Buttons:

Front panel buttons: power off the device, press and hold the

RESET button for 3 seconds while powering the device, and

then release.

Protocol 3000:

“#factory” command.

Web Pages:

In the Device Settings page, click Reset.

Technical Specifications

Inputs

1 HDMI

On a female HDMI connector

1 HDBT

On an RJ-45 connector

Outputs

1 HDMI

On a female HDMI connector

8 HDBT

On RJ-45 connector

1 Unbalanced Stereo Audio

On a 3.5mm mini jack

Ports

1 IR IN

On a 3.5mm mini jack for IR link extension via IN 2HDBT

8 IR OUT

On 3.5mm mini jacks for IR link extension via OUT HDBT (2 to 9)

1 RS-232 IN

On a 3-pin terminal block for serial link extension via IN 2HDBT

8 RS-232 OUT

On 3-pin terminal blocks for serial link extension via OUT HDBT (2

to 9)

1 Mini USB

On a female USB connector for firmware upgrade

1 RS-232

On a 3-pin terminal block for device control

1 10/100BaseT Ethernet

On an RJ-45 female connector for device control via LAN

Extension Reach

4K @60Hz (4:2:0)

Up to 100m (330ft)

Full HD (1080p @60Hz 36bpp)

Up to 130m (430ft)

HDBaseT Ultra Mode and Full HD

(1080p @60Hz 24bpp)

Up to 180m (590ft)

Compliance

HDBaseT 1.0

Video

Max. Resolution

4K@60Hz (4:2:0) and 4K@30Hz (4:4:4)

Compliance

Supports HDMI 2.0 and HDCP 1.4

Analog Audio

Max Level

1 Vrms

THD + Noise

0.03% @1kHz at nominal level

Controls

Front Panel

Front panel buttons: input select, volume, EDID, IR

Indication LEDs: input select, EDID type

Rear Panel

RS-232 device control

RS-232 remote control via HDBT ports

IR remote control via HDBT ports

Ethernet

DIP-switches

Supported PC Web Browsers

Windows 7 and Higher

Internet Explorer (32/64 bit) version 10

Firefox version 30

Chrome version 35

MAC

Chrome version 35

Chrome version 63.0.3239.84

Firefox version 30

Firefox version 57.0.2

Safari version 7

Minimum Browser Window Size

1024 x 768 when in full screen mode

Power

Consumption

65VA

Source

100-240V AC, 50/60Hz

Cooling

Fan Ventilation

Environmental Conditions

Operating Temperature

0° to +40°C (32° to 104°F)

Storage Temperature

-40° to +70°C (-40° to 158°F)

Humidity

10% to 90%, RHL non-condensing

Regulatory Compliance

Safety

Environmental

RoHs, WEEE

Enclosure

Size

19” 1U

Type

Aluminum

General

Net Dimensions (W, D, H)

19", 7.2", 1U, rack mountable 18.3 cm

Shipping Dimensions (W, D, H)

52.5cm x 33cm x 10.7cm

(20.7” x 13” x 4.2”)

Net Weight

1.6kg (3.4lbs) approx.

Shipping Weight

2.7kg (6lbs) approx.

Accessories

Included

Power cord, rack ears

Optional

For optimum range and performance use the recommended USB,

Ethernet, serial and IR Kramer cables available at

www.kramerav.com/product/VM-218DTxr

Specifications are subject to change without notice at www.kramerav.com

Autres manuels pour VM-218DTxr

Ce manuel convient aux modèles suivants

Autres manuels Kramer Changer

Kramer

Kramer VS-421 Manuel utilisateur

Kramer

Kramer vs-162 Manuel utilisateur

Kramer

Kramer VP-214DS Manuel utilisateur

Kramer

Kramer DIP-31M Manuel utilisateur

Kramer

Kramer VS-211UHD Manuel utilisateur

Kramer

Kramer VP-770 Manuel utilisateur

Kramer

Kramer VP-725N Manuel utilisateur

Kramer

Kramer VS-81H Manuel utilisateur

Kramer

Kramer VP-31KSi Manuel utilisateur

Kramer

Kramer VS-21T Manuel utilisateur

Kramer

Kramer VP-4x1 CS Manuel utilisateur

Kramer

Kramer VS-21H-IR Manuel utilisateur

Kramer

Kramer Tools VP-211 Manuel utilisateur

Kramer

Kramer VP-41 Manuel utilisateur

Kramer

Kramer VS-44DT Manuel utilisateur

Kramer

Kramer VS-21DTP Manuel utilisateur

Kramer

Kramer VS-41AV Manuel utilisateur

Kramer

Kramer PL-15 Manuel utilisateur

Kramer

Kramer VP-8x8 Manuel utilisateur

Kramer

Kramer VP-436N Manuel utilisateur

Kramer

Kramer VS-21HDCP-IR Manuel utilisateur

Kramer

Kramer ASPEN-1616UX Manuel utilisateur

Kramer

Kramer 4x1V Manuel utilisateur

Kramer

Kramer VIA CONNECT PRO Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur