Kollercraft AP360-2 Manuel utilisateur
1. Your Aquarium 3. Tank Placement
Rinse materials in running water –
aquarium, gravel, stones, plasc plants
and other decoraons, etc.
Place gravel, rocks and decoraons in the
tank now, spreading the gravel evenly
across the boom of the aquarium.
Please read Safety Instrucons secon
before operang this unit. Completely
set up the aquarium kit before plugging
lter and light into electrical outlet.
2. Important Safety
Instrucons
6. Hood Funcons
Make sure a drip loop is formed in all
electrical cords. Use of a GFCI rated
outlet or circuit is recommended.
Gravel and Decoraons are not
included with this aquarium kit.
Aquarium Kit
AP360-2
Place the
hood on top
of the tank
and make
sure it is
fully seated.
Insert LED light unit into back of hood
turning to the right and ghten snuggly
to secure it. Insert power adapter
barrel plug into the LED light unit.
Plug power adapter into standard 110
volt wall socket. Use of a GFCI (Ground
Fault Circuit Interrupter) is always
recommended when using electrical
appliances around water.
Children under the age of 13 should be
supervised by an adult with the setup,
maintenance and sh care
AQUARIUM
INSTRUCTIONS
FOR USE
KEEP THESE INSTRUCTIONS FOR
FUTURE REFERENCE
Recommended
water level
4. Adding Gravel
Make sure your tank has
not been damaged during
shipping before you start
the setup process.
Place the aquarium on a level, strong
surface that is able to support the
weight of the assembled aquarium and
cannot be damaged by water.
The aquarium should be located near
an electrical outlet to provide power
for the light and lter. Use of a GFCI
rated outlet or circuit is recommended.
Never place an aquarium on top of a TV
or other electrical components.
People of all ages enjoy looking at aquari-
ums. Aside from the belief that an aquarium
is beauful, many also believe having an
aquarium can be relaxing, rewarding and a
great conversaon piece all at the same
me. You will have many enjoyable hours
with your new aquarium and sh.
Included in your API Aquarium Kit
1. Tank
2. Full hood
3. LED light
4. SUPERCLEAN 10
5. Crystal Bio-Chem
Zorb Cartridge
6. Perfect Start
5. Filter Set Up
Aach hanger onto the
post at the back of the
SUPERCLEAN 10 lter,
inserng it into the 2nd
hole of hanger. To raise
or lower the lter adjust
hanger up or down.
Hang the lter on the back
of the aquarium posion-
ing the lter hanger onto
the indented channel.
It is important the lter is
submerged to the recom-
mended water line found
on the lter. Always make
sure your water level is at
or above this mark for
proper lter operaon.
KOLLERCRAFT
LIMITED WARRANTY
KOLLERCRAFT a Division of Koller Enterprises,
Inc. warrants this aquarium product to be free
from defects in material and workmanship under
normal use and service and according to the
provisions as specified in the accompanying as-
sembly and operating instructions, for a period of
2 years from date of purchase.
This warranty does not cover and
KOLLERCRAFT is not liable for the cost of re-
pair or replacement of parts which have been
subject to misuse, negligence, accident, improp-
er installation, damage during shipment or han-
dling, normal deterioration due to wear and
exposure or defects caused by unauthorized
UNDER NO CIRCUMSTANCES
WILL KOLLERCRAFT BE LIABLE
FOR ACCIDENTAL OR CONSE-
QUENTIAL DAMAGES, INCLUDING
BUT NOT LIMITED TO LOSS OF
Some states do not allow the exclusion or limitaon
of incidental or consequenal damages, or limitaon
on how long an implied warranty lasts, so the above
limitaons or exclusions may not apply to you. This
warranty gives you the legal rights, which vary from
state to state.
7. Add Water
Fill the aquarium with water to within
one inch of the top of the tank. Do not
overll since spillage may occur.
Add Perfect Start Day 1 packets to your
aquarium. Wait 14 days and add the
second group of packets. On day 28
add the third set of packets.
Allow the aquarium to run for 24
hours before adding sh to allow the
water to reach desired temperature.
8. Light Hood
You can add addional accessories
by removing one of the two secons
shown below.
Oponal) If you are adding a heater
(heater not included) remove the secon
shown below by using side cung pliers
and cung the aached webbing.
Read and follow the heater’s instrucons.
Check with your retailer for recommend-
ed heater sengs.
Adjust heater sengs as directed.
9. Oponal Heater
10. Oponal Accessories
Use easy-to-use API BIO-
CHEM ZORB 10 replace-
ment lter cartridges.
11. Tank & Fish Care
IF ANY COMPONENTS ARE
DAMAGED OR MISSING
DO NOT RETURN TO THE STORE
CALL (800)-545-1344
Warranty Repairs or Replacement
FOR HELP OR COMMENTS
GO TO cservice@koller-cra.com or
CALL (800) 545-1344
Use side cut pliers to
remove cutouts by
cung aachment webs.
12. Shopping List
Change the lter car-
tridge every three to four
weeks depending on the
number of sh in your
tank and amount of daily
feedings.
Perform a 25% water
change monthly.
API CRYSTAL BIO-CHEM ZORB®
cartridge 10
Makes water crystal clear
API STRESS COAT®
Makes tap water safe
API STRESS ZYME®
Keeps the aquarium clean
API 5 in 1 AQUARIUM TEST STRIPS
Measures water parameters
You can turn on the LED light by
pushing down on the blue buon
switch on top of the hood.
To select light color connue to press
the blue buon repeatedly unl
desired color is located.
Pick the color that best suits your
mood or me of day. Choose from
7 colors; amber, aqua, blue, green,
purple, red and white.
API® items and components are registered trade-
marks of Mars, Incorporated and its aliates.
Manufactured and distributed under license by
KOLLERCRAFT Fenton, MO 63026 USA
When stocking your sh tank add no more than 1
inch of sh per gallon of water to your aquarium.
Remember these sh will grow larger as they
mature and become adults. Do not overcrowd.
Autres manuels Kollercraft Autre
