Kohler K-T6906 Manuel utilisateur
Installation Guide
Bath Faucet
Mproduct numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
Mcorresponden a México (Ej.
K-12345M)
Français, page“ Français-1”
Español, página“ Español-1”
K–T6906 K–T6915
106386-2-AB
Tools and Materials
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.
Before You Begin
The valve is sold separately. Please read the instructions packed
with the valve for installation procedures.
Please read all instructions before you begin.
Shut off the main water supply.
Observe all local plumbing and building codes.
Complete the finished deck material before installing.
Before installation, unpack the new faucet trim and inspect it for
damage. Return it to the carton until installation.
Kohler Co. reserves the right to make revisions in the design of
faucets without notice, as specified in the Price Book.
Adjustable
Wrench • Rag
Plus:
Tube Cutter
Tape
Measure
Hex
Wrench Assorted
Screwdrivers
File
Plumbers
Putty
106386-2-AB 2 Kohler Co.
1. Remove the Pipe Plug
WARNING: Risk of personal injury. Lines may be pressurized.
Do not lean over the pipe plug when turning or removing the
plug.
Make sure the valves are closed (cold = fully counterclockwise;
hot = fully clockwise).
Turn off the main water supply.
Wrap a rag around the pipe plug to prevent water spray.
IMPORTANT! Water may purge from the supply tube when you
remove the plug.
Carefully remove the pipe plug.
Pipe Plug
Close
Hot
Close
Cold
Kohler Co. 3 106386-2-AB
2. Prepare for Spout Installation
Remove the plaster guard from the spout supply tube.
Cut off the spout supply tube 1-1/4” (3.2 cm) above the rim,
finished deck, or tile.
Remove all burrs from the supply tube to prevent damage to the
O-ring seal.
NOTE: The washer is not needed for rim/finished deck installation.
If the installation includes a tile covered rough deck, slide the
washer, flat side facing forward, onto the supply tube.
Rough
Deck
Tile
Finish
1-1/4"
(3.2 cm)
Washer
Spout
Supply
Tube
Rough
Deck
Finished
Deck
106386-2-AB 4 Kohler Co.
3. Install the Spout
CAUTION: Risk of product damage. Use care when installing
the spout assembly to prevent damage to the O-ring seal.
IMPORTANT! Keep the spout supply tube clean above the finished
deck to avoid damage to the O-ring seal.
Loosen the setscrews in the sleeve.
Use a twisting motion to install the sleeve on the spout supply
tube until it contacts the deck or washer.
Align the sleeve with the setscrews offset from the center (not
facing directly forward or backward) of the supply tube.
Remove the setscrew from the back of the spout assembly.
Thread the collar all the way onto the spout assembly.
Slide the spout sleeve onto the spout assembly and thread the
escutcheon snug against the sleeve.
Apply a bead of plumbers putty or other sealant to the underside
of the escutcheon according to the manufacturer’s instructions.
Position the spout on the sleeve, and carefully press down until
the spout contacts the finished deck.
Align the spout as desired and tighten the setscrew.
Thread the escutcheon down until it contacts the deck.
Remove any excess putty or sealant.
Setscrew
Setscrew
Sleeve Collar
Sleeve
Setscrew
Escutcheon
Apply
Plumbers
Putty.
O-Ring
Kohler Co. 5 106386-2-AB
4. Installing Cross Handles
Close the valves (hot = clockwise, cold = counterclockwise).
Lubricate each O-ring with water and position them on the
bonnet grooves.
Install a spline adapter to each valve stem.
Position a stem adapter on each spline adapter with the hex holes
in line with each other.
Install a gasket over each valve body.
Thread a bonnet onto each valve body.
Position a center cap over each stem adapter.
Insert a cross arm through the large hole in the center cap and
the hex holes in each stem adapter.
Align the holes in the cross arms and center caps.
Insert a long stud through the hole in each center cap.
Secure with the short stud.
Install the sleeves, washers, and end caps.
Valve
Body
Valve
Body
Stem
Adapter
Gasket
Bonnet
O-Ring
Screw
Stem
Adapter
Spline
Adapter
Valve
Stem
Center Cap
Stem
Adapter
End
Cap
Washer
Sleeve
Long Stud
Hole
Cross
Arm
Short Stud
106386-2-AB 6 Kohler Co.
5. Installing Lever Handles
Close the valves (hot = clockwise, cold = counterclockwise).
Position a gasket and escutcheon over each valve body.
Fit a spline adapter onto each valve stem.
Wet each O-ring with water.
Install a snap ring and O-ring in the grooves in each stem
adapter.
Position the stem adapters with the hex holes in-line with each
other.
Secure each stem adapter with a provided screw.
NOTE: To adjust the handle alignment, rotate the spline adapter.
Fit a sleeve and bonnet over each stem adapter.
Thread a bonnet to each valve body until they are tight against
the escutcheon.
Install a center cap to each bonnet.
Fit a long sleeve to each handle arm, and secure it with the end
cap.
Insert a handle arm through each center cap and bonnet.
Install a short sleeve and washer onto each handle arm and
secure them with the end caps.
Screw
Stem
Adapter
Stem
Adapter
Snap Ring
Valve Body
Valve Stem
Gasket
Escutcheon
Escutcheon
Spline
Adapter
O-Ring
Bonnet
Sleeve
Handle
Arm
Center
Cap
Center
Cap
Short
Sleeve
Washer
Hex
Hole
Bonnet Bonnet
End
Cap
Long
Sleeve
Kohler Co. 7 106386-2-AB
6. Complete the Installation
Turn off the water (hot = clockwise, cold = counterclockwise).
Remove the aerator assembly.
Turn on the main water supply and check for leaks.
Turn on the hot and cold valves and run water through the spout
to remove debris. Check for leaks.
Turn off the hot and cold valves.
Reinstall the aerator assembly.
Spout
Aerator
106386-2-AB 8 Kohler Co.
Guide d’installation
Robinet de baignoire
Outils et matériels
Merci d’avoir choisi la compagnie Kohler
Nous apprécions votre engagement envers la qualité Kohler. Veuillez
prendre s’il vous plaît quelques minutes pour lire ce manuel avant de
commencer l’installation. Ne pas hésiter à nous contacter en cas de
problème d’installation ou de fonctionnement. Nos numéros de
téléphone et notre adresse du site internet sont au verso. Merci encore
d’avoir choisi la compagnie Kohler.
Avant de commencer
La valve est vendue séparément. Veuillez s’il vous plaît lire les
instructions d’installation emballées avec la valve.
Veuillez lire toutes les instructions avant de commencer.
Couper l’alimentation d’eau principale.
Respecter tous les codes de plomberie et de bâtiment locaux.
Compléter le matériau du comptoir fini avant d’installer.
Avant l’installation, déballer la garniture du nouveau robinet et
l’examiner pour en déceler tout dommage. Remettre le robinet
dans l’emballage jusqu’à l’installation.
Cléà
molette • Chiffon
Plus:
Coupe-tubes
Mètre
ruban
Clé
hexagonale Tournevis
assortis
Lime
Mastic de
plombier
Kohler Co. Français-1 106386-2-AB
Avant de commencer (cont.)
Kohler Co. se réserve le droit d’apporter toutes modifications au
design des robinets et ceci sans préavis, comme spécifié dans le
catalogue des prix.
106386-2-AB Français-2 Kohler Co.
Ce manuel convient aux modèles suivants
1
Table des matières
Langues :
Autres manuels Kohler Équipements de cuisine et de salle de bain
Kohler
Kohler K-5149 Instructions de montage
Kohler
Kohler K-10433 Instructions de montage
Kohler
Kohler K-8813 Instructions de montage
Kohler
Kohler K-R78035 Instructions de montage
Kohler
Kohler Renew 76881T-E Manuel utilisateur
Kohler
Kohler ARTIFACTS 72762T-9M Manuel utilisateur
Kohler
Kohler LOURE 98454T-CP Manuel utilisateur
Kohler
Kohler K-3760 Instructions de montage
Kohler
Kohler K-11748-K Instructions de montage
Kohler
Kohler 11623 Manuel utilisateur
Kohler
Kohler Sterling 33197 Instructions de montage
Kohler
Kohler TAUT 74013T-4CD Manuel utilisateur
Kohler
Kohler K-9451 Instructions de montage
Kohler
Kohler K-12171 Manuel utilisateur
Kohler
Kohler K-6340 Manuel utilisateur
Kohler
Kohler PURIST 14426A Manuel utilisateur
Kohler
Kohler K-6127 Manuel utilisateur
Kohler
Kohler K-73081 Instructions de montage
Kohler
Kohler Mazz R72511-SD-VS Manuel utilisateur
Kohler
Kohler K-15265 Instructions de montage
Manuels Équipements de cuisine et de salle de bain populaires d'autres marques
Alpha Bidet
Alpha Bidet Alpha One Manuel utilisateur
InSinkErator
InSinkErator H/HC3300 Manuel d'installation
Clou
Clou Xo type 1 Manuel utilisateur
Grohe
Grohe Bridgeford 20 158 Manuel utilisateur
Hans Grohe
Hans Grohe Croma Select S 180 Showerpipe EcoSmart... Manuel utilisateur
Wickes
Wickes MONO SINK MIXER Manuel utilisateur