Jzoom ZoomerX Manuel utilisateur

1"
"
Portable Electric scooter
USER MANUAL
(Model: Zoomer/ZoomerX)
Thank you for purchasing our products
Please carefully read the user manual
And warranty book before using

2"
"
CATALOGUE
MAIN PARTS
3
SAFETY
4
PRODUCTS / FOLDING STAGE
5
Folding stages
5
Folding steps
6
Unfolding steps
7
OPERATION
8
Introduction of Handlebar parts
8
Operation Instruction
8
Display Factory settings
10
RIDING OPERATION
11
Ready
11
Start
11
Brake
11
BATTERY AND CHARGER
12
Battery
12
Changer
12
Change Description
12
MAINTENANCE
13
Lubricating
13
Battery
13
Placement and daily care
13
GENERAL TROUBLESHOOTING
14
PRODUCT SPECIFICATION SHEET
15
QUALITY ASSURANCE
16

3"
"
MAIN PARTS
1. Handlebar 6. Folding hook
2. UBI (Display, etc) 7. Battery charging jack
3. LED headlight 8. Folding lever
4. Hooter 9. Lock bolt
5. Lock lever 10. Rear brake

4"
"
SAFETY
1. The product is for adults only, limited for one adult, please do not carry two
adults at the same time. Is not suitable for minors.
2. Please wear your safety helmet and other protective equipment when
riding.
3. Do not ride in traffic lane or unsafe roads and do not break local regulations
4. Please exercise in wide areas, and ride after skilled manipulation, do not
ride in traffic lane.
5. Do not make any dangerous actions when riding or riding with one hand.
Keep your feet on the scooter.
6. Do not attempt to ride the scooter on stairs that are above 3 cm; it may
overturn the scooter causing injury or damage. Please try to avoid also the
stairs smaller than 3 cm. It also may cause injury or damage.
7. The scooter’s highest speed is 28 Km/h. For your safety, please limit the
speed within 20 Km/h. Please try to avoid using it at night, if needed, please
limit the speed within 15 K/h or less and turn on headlight.
8. Do not use scooter when the temperature is lower than -5 ºC.
9. Please slow down or get off when riding in rough or poor road conditions.
10. Do not ride the scooter in oily or icy surface terrain.
11. Please adjust the height of handlebar according to your height or to ensure
a safety riding.
12. Do not immerse the scooter in the water with the depth of 4 cm or spray it
directly with water to avoid damage of the electrical parts of the vehicle.
13. Please try to avoid riding in bad weather such as heavy rain and high winds
to protect it.

5"
"
PRODUCTS
Folding stages
A – unfolded B - folding handlebars
C - fully folded

6"
"
Folding steps
1. Open the lock lever, in the direction of arrow, as shown in figure (a).
2. Press the red button, figure (b), at the same time press down handlebars as
shown in figure (c) and push the lock lever to the lock position.
3. Hold the handlebar with both hands, push buttons (1) shown in Figure (d).
Pull out the handlebar grips, figure d, up to a maximum and fold downwards to
reach that figure B, from previous page.
4. Push the handlebar forward, press folding lever in the direction of the arrow
in the figure (f)
5. Continue folding scooter until folding hook reaches and hangs the bolt
located on the rear brake

7"
"
Unfolding steps
1. Press the rear brake in the direction of the arrow in the figure (a) until folding
hook releases the bolt located on the rear brake. Then, lift the handlebar until it
reaches the working position and the locking bolt comes into place,like in figure
(b).
2. Raise the two handles of the handlebar until they automatically return to the
work position, figure (c)
3. Push the lock lever in the direction of the arrow in Figure (d) and lift
handlebars to desired height. Now press button shown in Figure (e) and fix it in
one of the two holes, as desired.
a b c
d e

8"
"
OPERATION
1. Introduction of Handlebar parts
1. Thumb Accelerator
2. Thumb Electronic Magnetic Brake
3. Switch Button
4. Setting Button
5. On/Off Light Button
6. Horn Button
7. Led Headlight
8. Handlebar Fold Button
9. Display
2. Operating Instructions
a. ON/OFF
Press the switch for 1 sec, and the display lights indicate power on. Press for 3
seconds if you want to turn it off. It will turn off after unused for 3 minutes.
b. Speed control
Press the right thumb accelerator to control the speed (1-25km/h).
c. Braking Control
1
2
3
4
9
7
5
8
8
6

9"
"
Press the left thumb electronic magnetic brake. The greater angle you press, the
greater braking force will be.
d. Horn
Turn on the power, press the horn button and it will hoot.
e. LED Headlight
In manual mode: Press the On/Off Light button when need and there will be a
sign in display indicates the light is turn on. Press the button again when you do
not need the light
The scooter is equiped with a sensor light that detects the need of light. The light
will turn on automaticaly (auto light mode) if the sensor detects poor light.
For example: when is cloudy and the auto light mode is on, the lights turn on. If
the light is proper, the auto light mode detects the light and the headlights go off
after 5 secons.
On auto light mode, the display is also lighted depending on the ambiental light.
If the scooter is on auto light mode, you can go to manual mode by pushing the
On/Off Light Button.
f. Mileage Show
When power off, it shows time.
When power on, It displays three modes: total, trip and time. You can press the
settings button to change it.
When it displays the 'trip' mode, press the setting button for 3 seconds and it will
clear the trip.( Single stroke accumulated more than 100 belongs to 100)
g. Emergency
Emergency, stamp the rear foot brake can simultaneously achieve front
electronic magnetic brake and rear wheel friction brake; under normal
circumstances, please do not use the emergency brake at high speed to avoid
the wheel damage and the company shall not be responsible for this damage.
Please repair it for pay.

10"
"
3. Display Factory Setting
Accesing the menu P0 and P1 is made by pressing at the same time the switch
button and setting buton. Pressing the setting button helps you togle between
P0 and P1.
Both menus have other two menus : 0 and 1, as fallows:
P00- displays the speed in km/h and temperature in Celsius degrees
P01– displays the speed in mile/h and the temperature in Farenheit degrees
P10– light are on manual mode
P11– auto light mode
You can switch between menus 0 and 1 in P0 or P1 by pressing the on/off light
button.
Press the setting button at last and the settings will be finished.
Ce manuel convient aux modèles suivants
1
Table des matières
Manuels Scooter populaires d'autres marques

First Choice Mobility
First Choice Mobility Roma Medical Corella S741 Manuel utilisateur

Carrera
Carrera impel Manuel utilisateur

Afikim
Afikim Superlight SL-3 Manuel utilisateur

CareCo
CareCo ZOOM Manuel utilisateur

Douglas
Douglas Vespa G.S. Manuel utilisateur

Gazelle
Gazelle with BOSCH System Manuel utilisateur











