User Manual
The module has received Federal Communications Commission (FCC) CFR47 Telecommunications, Part 15 Subpart C
"Intentional Radiators" modular approval in accordance with Part 15.212 Modular Transmitter approval. Modular approval
allows the end user to integrate the module into a nished product without obtaining subsequent and separate FCC
approvals for intentional radiation, provided no changes or modications are made to the module circuitry. Changes or
modications could void the user's authority to operate the equipment. The end user must comply with all of the
instructions provided by the Grantee, which indicate installation and/or operating conditions necessary for compliance.
The nished product is required to comply with all applicable FCC equipment authorizations regulations, requirements and
equipment functions not associated with the transmitter module portion. For example, compliance must be demonstrated
to regulations for other transmitter components within the host product; to requirements for unintentional radiators (Part
15 Subpart B "Unintentional Radiators"), such as digital devices, computer peripherals, radio receivers, etc.; and to additional
authorization requirements for the nontransmitter functions on the transmitter module (i.e., Verication, or Declaration of
Conformity) (e.g., transmitter modules may also contain digital logic functions) as appropriate.
LABELING AND USER INFORMATION REQUIREMENTS
The
B0134
module has been labeled with its own FCC ID number, and if the FCC ID is not visible when the module is installed
inside another device, then the outside of the nished product into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use wording as follows:
Contains Transmitter Module FCC ID:
RN489896162-B0134 or Contains FCC ID: RN489896162-B0134
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation
A user's manual for the nished product should include the following statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Additional information on labeling and user information requirements for Part 15 devices can be found in KDB Publication
784748 available at the FCC Oce of Engineering and Technology (OET) Laboratory Division Knowledge Database (KDB)
http://apps.fcc.gov/oetcf/kdb/index.cfm.
RF EXPOSURE
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located
or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna
installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
