§4 Unpacking, installation and debugging
1. After the machine arrives at the site, check whether the machine, parts and
accessories listed in the packing list are complete and whether the machine is
damaged during transportation.
2. Check the certificates to confirm that the machines you will use are qualified
products and meet the requirements of your order.
3. Open the container at the designated position (be careful not to damage the
machine) and check the equipment and accessories according to the random
packing list.
4. Read this manual carefully for installation, debugging and use.
5. The equipment should be installed in a relatively dry indoor environment, and
there is no dust, no inflammable and explosive chemical preparations and other
corrosive substances on the machine, the temperature range of -10 -- 40 C, no
condensation.
6. Place the turntable on the flat ground and connect the guide column of the
film system with the turntable.
Install the ramp (accessory, optional) in the working position where the goods
can be placed or unloaded, and at the same level with the turntable. Pay
attention to the position and the gap between the turntable. After the
installation, you can fix it with expansion screw (self-provided).
7. Check other connected parts, whether the electrical wiring is loose or falling
off, and fix all loose or falling parts and wires in time.
8. Be sure to provide correct, stable and reliable fixed power supply (temporary
