General Sublimation Instructions
•Preheat the heat press to around 395-405°F. Set the time to 45-60 sec., set pressure to medium.
•Attach the printed transfer to the cake pan lid using heat tape.
•Place blowout paper or Teflon sheet onto the heat press platen.
•Place the product blank with attached transfer onto the sheet, with transfer on top.
•Place another piece of blowout paper or Teflon sheet on top of the transfer sheet.
•Close and press for recommended time.
•When finished, open heat press. Using heat gloves, remove the paper transfer and allow the product
to cool.
Tips and Tricks
•For best image placement, utilize the product template found on the product page on JPPlus.com.
Troubleshooting
•The image came out light and/or faded.
oThe time setting may need to be increased.
oThe temperature setting may need to be increased.
oThe pressure setting on the press or wrap may be too light and need to be increased for better
contact between the sublimation transfer paper and the surface of the product.
oThe press or oven may not be heating at the temperature set on the display.
oThe sublimated image may have been printed on the wrong side of the sublimation paper.
•The image colors are dull on the sublimated product.
oThe press/heat time may need to be decreased.
oThe press/heat temperature may need to be decreased.
oThe print settings may need to be adjusted. Also check that the proper paper type and/or color
profile is selected before printing the image.
•The image colors are not correct on the sublimated product.
oThe print settings may need to be adjusted. Also check that the proper paper type and/or color
profile is selected before printing the image.
