HOW TO USE
1. Loosen the adjustment lock knob and
turn the adjustment knob unl the stop
is located roughly in the middle of its
range of moon. Reghten the
adjustment lock knob and turn the
adjustment sleeve unl it is zeroed in
its current posion. This will allow you
to adjust the stop in either direcon if
required.
2. Loosen the plasc adjustable handle
and slide the Micro Adjuster unl the
right-hand side of the upper ip stop is
aligned with the desired cut length.
3. Using a scrap piece of wood, make a
cut and check the length. If the length
is o, loosen the adjustment lock knob
and turn the adjustment knob to
change the length. Use the scale on the
adjustment sleeve to adjust by the
correct amount. Turning the
adjustment knob clockwise will
lengthen the cut while counter
clockwise will shorten it. Ensure the
adjustment lock knob is reghtened
before making another cut.
4. When not in use, simply ip the stop
out of the way to use the miter gauge
without obstrucon.
