JBL CSS-15C-VA Manuel utilisateur

Ø148 [5.9] dia. Fire Dome

Ø162 [6.4] dia. Outside Clamps

Ø165 [6.5] dia. Hole Cut-Out

Ø176 [6.9] dia.

Ø183 [7.2] dia.

116 [4.6]

CSS-15C-VA

INSTALLATION INSTRUCTIONS:

CUT THE HOLE IN THE CEILING MATERIAL:

1. Cut a 165 mm (6.5 in) diameter hole (±2 mm; 0.1 in) in the ceiling with

the proper tool. Precision of the hole diameter is important.

INSTALL THE FIRE DOME:

2. Slide the main wiring through the cutouts in the back of the FIRE DOME --

either using the included grommets or via an installer-added strain-relief or

gland nut fitting.

3. Remove the tape holding the CLAMP SCREWS and CLAMPS to the sides of

the FIRE DOME. While holding the CLAMPS upward (flush to the sides of the

FIRE DOME), slide the FIRE DOME into the hole in the ceiling.

4. Insert the two CLAMP SCREWS into threaded inserts on the sides of the

FIRE DOME (from the inside of the FIRE DOME). Rotate the two CLAMP

SCREWS downward to drive the two CLAMPS until the they hold the ceiling

securely. This completes the installation of the fire dome section.

INSTALL THE SPEAKER AND WIRING:

5. Hang one of the SPEAKER SUSPENSION SPRINGS on the HOOK

of the FIRE DOME (by squeezing the springs together and clipping

the spring into the hook).

6. Adjust Tap Setting via Wires from Ceramic Terminal Block:

Make sure the black wire’s slide-on connector is on the “COM” (common)

tab of the transformer. Slide the red wire’s connector onto the desired

remaining marked tab (6W, 3W or 1.5W) of the transformer. The marked

figures are the 100V distributed line power settings. Make sure the green

wire’s lug is securely connected under one of the screws around the

perimeter of the speaker, to ground the speaker’s metal baffle.

7. Connect the main wiring to the CERAMIC TERMINAL BLOCK -- to

the “+,” “-,” and Ground terminals, securing the wires in place with the screws.

CLOSE THE SPEAKER:

8. Hang the other SPEAKER SUSPENSION SPRING onto the other HOOK

of the FIRE DOME.

9. Gently push the SPEAKER upward toward the hole. It will pull itself up

into place.

150324

Dims in mm [in]

FIRE DOME

CERAMIC TERMINAL BLOCK

CLAMP SCREW

CLAMP

CEILING & HOLE

CUT-OUT

SPEAKER

Last Step: Push speaker up

CLAMP SCREW

CLAMP SUSPENSION SPRING & HOOK

SUSPENSION SPRING & HOOK

JBL Professional

8500 Balboa Blvd.

Northridge, CA 91329

Table des matières

Autres manuels JBL Intervenants

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur