7. If the light did NOT GO OFF, the Lantern Receiver is not picking up a signal from the TX. Check
the radio signal path between transmitter and receiver for any metal obstructions (support beams,
aluminum window casings etc). these can block the radio signals and interfere with signal
transmission. To determine a clear signal path, move the Lantern Receiver to different outlets and
activate the Transmitter. Locate the Lantern Receiver in an outlet where the Transmitter activates
it.
8. Remove the sticker from the photocell on the DC PIR Transmitter.
Lantern Receiver Settings
After Auto Programming is complete, the ON TIME and DUSK TIMER can also be set:-
1.ON TIME
The ON TIME setting determines how long the light will remain ON after motion has been sensed
by the DC PIR TX. Turn the ON TIME dial to 1, 3, 5 or 12 minutes.
PLEASE NOTE THAT THE LANTERN RECEIVER IS DESIGNED TO TURN THE LIGHT ON IN
DAYLIGHT AS WELL AS NIGHT IF MOVEMENT IS DETECTED.
THE LIGHT WILL REMAIN ON FOR THE LENGTH OF TIME SET BY THE USER AND THE LED
WILL FLASH ON/OFF FOR APPROX. 5 SECONDS
IF FURTHER MOVEMENT IS DETECTED WHILST THE LIGHT IS ILLUMINATED, THE LIGHT
WILL BLINK OFF QUICKLY AND THEN TURN BACK ON FOR THE LENGTH OF TIME SET BY
THE USER AND THE LED WILL FLASH ON/OFF FOR APPROX. 5 SECONDS
2. DUSK TIMER.
To set how long the light remains ON after dusk, set the DUSK TIMER dial to 2, 4, 8, hours or
DUSK/DAWN.
After dusk, the light will turn on in DIMMED MODE for the time you set.
If motion is detected by the DC PIR TX, the light turns ON for the length of time you have set using
the ON TIME dial then will return to DIMMED MODE..
WARNING!!
If you decide to use a Compact Fluorescent Lamp (CFL) in the Lantern Receiver, you MUST
set the dials as follows:-
ON TIME DIAL to 3, 5 or 12 minutes. DO NOT SET TO 1 minute as a CFL can be damaged
by short term switching on and off.
DUSK TIMER to OFF position as it is NOT possible to use the dim fuction with a CFL .
In this case the Lamp will remain OFF until it is activated, then will remain on for the
duration set by the ON TIME DIAL.
Manual Override.
To turn the light fixture on manually, flip the mains switch off/on within one second and the lamp
will illuminate permanently at full power.
The return the Receiver to Auto Mode repeat the same action.
ADDING ADDITIONAL TRANSMITTERS TO CONTROL THE LANTERN RECEIVER
The Lantern Receiver can be programmed to operate with up to 16 additional Transmitters. These
products are easily added to expand your system.
To add additional Tx`s, press the Rx PROGRAM button for 1 second while the Rx is powered.
