InkTec Jetrix LXi Series Manuel utilisateur
j
^
U
G
t
G
j
^
U
G
t
G
j
^
U
G
t
G
Shutting LXi6, LXi7 or LXi8 for an indefinite time
Leave printer on whilst left unattended
Leave compressor on
We recommend that the temperature in the room where the printer is situated is maintained at
an ambient temperature between 18 - 25ºC
Ensure auto-wiper tray is in the normal position (engaging idle mode)
Solution clean white heads (see solution cleaning document)
Empty the main waste ink tank at the rear of the machine, if the printer is down for a longer
period than 2 weeks, it is strongly recommended to replace the waste ink tank with a
larger container to stop any leaking.
Using the DIO Check (In System Config) Enable the waste pump to run for 10 minutes prior
to leaving the machine.
In Purge window Make sure purge is set to 2 seconds, x1 purge only
Set idle purge to run every 5-6 hours (In System Config)
Disable UV lamp power breaker
Empty excess water from compressor (where possible)
Whilst these procedures are designed to keep your printer running smoothly after a shutdown
has occurred, please bear in mind that these printers are not designed to be unused for a
prolonged period of time, as stated in our warranty terms and conditions. We strongly
recommend that the printers are checked weekly or fortnightly (at least) by carrying out a
nozzle check, cleaning heads if required, as well as checking and emptying the waste ink
tank/tray. Please also check your ink levels to ensure ink is in the ink tanks.
Please retain nozzle checks and detail maintenance carried out
Process on return:
Purge all print heads and wipe clean manually using DT Purge again
Empty waste ink tank (at the rear) and clean around waste ink tray (under heads)
Enable UV lamp breaker
Clean and test as required
Once maintenance has been carried out, complete normal daily maintenance of purging, nozzle
check and offset check before printing commences.
If you have any issues on return, InkTec can provide assistance at a reasonable charge.
! " #
$ %
###
! "
#
$%&'
( )*++
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels InkTec Imprimante
