InFocus LP630 Manuel utilisateur

SP-CEIL-LM630

Projector Mount

INSTALLATION INSTRUCTIONS

qStep 1

Place warning label on lamp door where indicated. Invert the

projector and place it on a soft and flat surface.

Locate the four (4) 4 (mm) mounting points found on the bottom

of the projector. Secure the three (3) Quick release sleeves (D)

withthethree(3)4(mm)x16(mm)PhillipScrews(C)

(supplied). Align the keyhole openings from the mounting

bracket (B) to the sleeves (D) and secure the bracket with the

4 (mm) x 12 (mm) knurl knob(A) (supplied). Do not over

tighten!

See Figure 1

qStep 2

Install the base box securely to the ceiling structure in

accordance with proper commercial standards. Use

(commercially available) suitable hardware depending on the

installation requirements.

NOTE:If the (Optional) SP-LTMT-EXT adjustable height

suspension adapter is a part of the installation, securely install

the ceiling adapter to the ceiling at this time.

(Refer to its Installation Instructions)

qStep 3

Install the two (2) conical spacers (J) and two (2) flat washers (K), two

(2) hinge screws (L) loosely on both sides of the base box (H). Raise

the projector with the mounting bracket attached and slip though the

hinge pin slots openings on the bracket into the base box. Install the

two (2) angle locking screws (I) adjust the angle, lock it, and then

tighten the hinge pin screws.

See Figure 2

qStep 4

Check all the hardware for proper tightness and security. Do not

over tighten hardware.

PORTABLEPROJECTORS

(1) Remove the knurl knob screw and hold the projector with

two hands.

(2) Slide it backwards to detach the sleeves from the keyholes.

(3) Reverse the process for quick reinstall.

qStep 5

Raise the projector with the mounting bracket (B) and slip through the

hinge pin slot openings on the bracket into the base box (H). Loosely

install the two (2) hinge pin screws (L), conical spacers (J) and flat

washers (K) and the angle lockingscrews (I). Adjust the angle and lock

it. Then tighten the hinge pin screws (L). Donot overtighten

See Figure 3

Check all hardware for proper tighten and security.

-_LA 073001_-

The ceiling should be capable of supporting a weight of

at least five (5) times the projector(s) or monitor(s)weight.

If it cannot, the ceiling must be reinforced. Proper

installation procedure by qualified personnel as outlined

in the installation instructions must be adhered to.

Failure to do so could result in serious personal injury.

To prevent eye injury wear protective eyewear before

openinglamp door.

DESCRIPTION/HARDWARE

A.4 (mm) x 12 (mm) Knurl Knob (1ea)

B. SP-CEIL-LM630 Mounting Bracket (1ea)

C. 4 (mm) x 16 (mm) Phillip Screws (3ea)

D.4 (mm) Quick Release Sleeves (3ea)

E.Projector (not supplied)

F. Ceiling Structure (See Warning Label)

G. Suitable Hardware (Commercially Available)

H.Base Box/Jam Screw (1ea)

I. 6 (mm) x 12 (mm) Angle Locking Screws (2ea)

J. Conical Spacer (2ea)

K.FlatWashers(2ea)

L.6 (mm) x 12 (mm) Hinge Pin Screws (2ea)

M.SP-LTMT-EXT Adjustable Suspesion Adapter (Optional)

N. Suspension Adapter Ajustable Pins (2ea)

27700B S.W. Parkway Ave.

Wilsonville, Oregon 97070-9215

Phone 1-800-294-6400 Fax

www.infocus.com

For further in

formation or ordering assistance

on the front of this page.

Autres manuels pour LP630

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels InFocus Accessoires pour projecteur

InFocus

InFocus WT96 Manuel utilisateur

InFocus

InFocus IN2112 Mode d’emploi

InFocus

InFocus LP 650 Mode d’emploi

InFocus

InFocus LP 240 Instructions d'utilisation et de sécurité

InFocus

InFocus LP770 Manuel utilisateur

InFocus

InFocus SP-LAMP-088 Mode d’emploi

InFocus

InFocus SP-LAMP-092 Mode d’emploi

InFocus

InFocus SP-CEIL-010 Manuel utilisateur

InFocus

InFocus CableWizard SP-CW3 Guide de démarrage rapide

InFocus

InFocus LASER PROJECTOR LP 540 Mode d’emploi

InFocus

InFocus SP-CEIL-006 Manuel utilisateur

InFocus

InFocus SP-CEIL-001 Manuel utilisateur

InFocus

InFocus SP-CEIL-004 Manuel utilisateur

InFocus

InFocus LNS-W01 Mode d’emploi

InFocus

InFocus SP-CEIL-008 Manuel utilisateur

InFocus

InFocus LiteShow network adapter Manuel utilisateur

InFocus

InFocus CEILING MOUNT LP 1000 SERIES Manuel utilisateur

InFocus

InFocus LiteShow 4 DB+ Manuel utilisateur

InFocus

InFocus SP-LAMP-073 Mode d’emploi

InFocus

InFocus SP-LAMP-086 Mode d’emploi

InFocus

InFocus IN42 Mode d’emploi

InFocus

InFocus LP130 Mode d’emploi

InFocus

InFocus SP-LAMP-080 Mode d’emploi

InFocus

InFocus LP70+ Mode d’emploi

Manuels Accessoires pour projecteur populaires d'autres marques

Optoma

Optoma BX-AL133B Manuel utilisateur

PEERLESS

PEERLESS PE 1120 Mode d’emploi

Osram

Osram SIRIUS HRI Series Manuel

Presentation Switchers

Presentation Switchers PS111 Manuel utilisateur

Kramer

Kramer VIA GO Manuel utilisateur

Yamaha

Yamaha PJL-112 Manuel de la liste des pièces

Swedstyle

Swedstyle CL23AA02ZA25E Manuel utilisateur

Mitsubishi Electric

Mitsubishi Electric 236CB Manuel du propriétaire

Epson

Epson BrightLink 475Wi Manuel utilisateur

Acer

Acer WP100 Manuel utilisateur

i3 i3board Manuel utilisateur

CHIEF

CHIEF HB-43E Manuel utilisateur

Biamp

Biamp Modena Hub Manuel de service

NEC

NEC MP10RX Manuel utilisateur

Panamorph

Panamorph DCR-S3 Manuel utilisateur

Exact solutions

Exact solutions FRAME-EVO-P10 Manuel utilisateur

CHIEF

CHIEF VCM103S Manuel utilisateur

Sharp

Sharp AN-PH20EZ Manuel utilisateur