Impex PWR 8 Manuel utilisateur

NOTE:

Please read all instructions

carefully before using this

product

Table of Contents

Safety Notice

Hardware Pack

Assembly Instruction

Parts List

Warranty

Ordering Parts

Model

PWR 8

Retain This

Manual for

Reference

07-31-03

OWNER'S

MANUAL

POWERHOUSE CLUB

POWER 8

IMPEX FITNESS PRODUCTS

14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746

Tel: (800) 999-8899 Fax: (626) 961-9966

www.impex-fitness.com

[email protected]

TABLE OF CONTENTS

BEFORE YOU BEGIN...................................................................................... 1

IMPORTANT SAFETY NOTICES..................................................................... 2

SQUAT/LAT PULL HARDWARE PACK….......…............................................. 3

SQUAT/LAT PULL ASSEMBLY INSTRUCTIONS............................................. 5

EXPLODED DIAGRAM……………………………………………………………. 14

SQUAT/LAT PULL PARTS LIST………..………………………………………….. 15

MULTI-PURPOSE BENCH HARDWARE PACK………………………………… 16

MULTI-PURPOSE BENCH ASSEMBLY INSTRUCTIONS............................... 17

EXPLODED DIAGRAM……………………………………………………………... 22

MULTI-PURPOSE BENCH PARTS LIST…………………………………………. 23

WARRANTY.................................................................................................…. 24

ORDERING PARTS.......................................................................................… 24

BEFORE YOU BEGIN

Thank you for selecting the Powerhouse Power 8 by IMPEX FITNESS

PRODUCTS. For your safety and benefit, read this manual carefully

before using the machine. As a manufacturer, we are committed to

provide you complete customer satisfaction. If you have any questions,

or find there are missing or damaged parts, we guarantee you complete

satisfaction through direct assistance from our factory. To avoid

unnecessary delays, please call our TOLL-FREE customer service

number. Our Customer Service Agents will provide immediate assistance

to you.

Toll-Free Customer Service Number

1-800-999-8899

Mon. - Fri. 9 a.m. - 5 p.m. PST

www.impex-fitness.com

[email protected]m

IMPORTANT SAFETY NOTICE

PRECAUTIONS

This exercise machine is built for optimum safety. However, certain precautions apply

whenever you operate a piece of exercise equipment. Be sure to read the entire

manual before you assemble or operate your machine. In particular, note the following

safety precautions:

1. Keep children and pets away from the machine at all times. DO NOT

leave children unattended in the same room with the machine.

2. Only one person at a time should use the machine.

3. If the user experiences dizziness, nausea, chest pain, or any other abnormal

symptoms, STOP the workout at once. CONSULT A PHYSICIAN

IMMEDIATELY.

4. Position the machine on a clear, leveled surface. DO NOT use the machine

near water or outdoors.

5. Keep hands away from all moving parts.

6. Always wear appropriate workout clothing when exercising. DO NOT wear

robes or other clothing that could become caught in the machine. Running

or aerobic shoes are also required when using the machine.

7. Use the machine only for its intended use as described in this manual. DO

NOT use attachments not recommended by the manufacturer.

8. Do not place any sharp object around the machine.

9. Disabled person should not use the machine without a qualified person or

physician in attendance.

10. Before using the machine to exercise, always do stretching exercises to

properly warm up.

11. Never operate the machine if the machine is not functioning properly.

12. A spotter is recommended during exercise.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR

PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE

AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL

INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.

ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY

DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.

SQUAT/LAT PULL HARDEWARE PACK

SQUAT/LAT PULL MACHINE ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen

Wrenches. NOTE: It is strongly recommended two or more people assembling this

machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.) Attach the Right Support (#5) to the Right Stabilizer (#1). Attach the Cross Brace

(#3) to the Right Support. Align the holes and secure them with two M10 x 3 ¾”

Carriage Bolts (#53), two Ø ¾” Washers (#67), and two M10 Aircraft Nuts (#69).

Repeat the same step to install the Left Support (#6) on the other side.

NOTE: DO NOT tighten the Nuts and Bolts yet.

B.) Cover the end of the Stabilizers with four 2” x 2 ¾” Stabilizer End Caps (#37).

DIAGRAM 1

STEP 2 (See Diagram 2)

A.) Attach an Upright Beam (#4) to the Right Stabilizer (#1) and the Right Support (#5). Secure

the Upright Beam to the Right Stabilizer with two M10 x 2 3/8” Carriage Bolts (#56), one 7”

x 3 1/8” Bracket (#26), two Ø ¾” Washers (#67), and two M10 Aircraft Nuts (#69).

B.) Secure the Upright Beam to the Right Support with two M10 x ¾” Allen Bolts (#63) and two

Ø ¾” Washers (#67).

C.)Repeat Steps A and B above to install the other side.

D.)Place the Upper Frame (#8) onto the two Upright Beams. Secure each end of the Upper

Frame with three M10 x 5/8” Allen Bolts (#64) and Ø ¾” Washers (#67).

E.) Securely tighten all the Nuts and Bolts previously installed.

STEP 3 (See Diagram 3)

A.) Attach the Rear Stabilizer (#21) and the Chromed Foot Support (#25) to the Cross

Brace (#3). Secure them with two M10 x 3 ½” Carriage Bolts (#54), Ø ¾” Washers

(#67) and M10 Aircraft Nuts (#69).

B.) Attach the Support Bracket (#14) to the Rear Stabilizer. Secure it with two M10 x 2 ¾”

Carriage Bolts (#55), Ø ¾” Washers (#67) and M10 Aircraft Nuts (#69).

C.)Slide the Sliding Weight Post (#13) onto the Rear Vertical Frame (#7). Attach the

Vertical Frame to the Support Bracket (#14). Secure it with two M10 x 5/8” Allen Bolts

(#64) and Ø ¾” Washers (#67). Attach two Spring Clips (#31) to the posts.

D.)Attach four Olympic Weight Posts (#15) to the Right & Left Supports (#5 & 6). Secure

each Post with two M10 x 2 3/8” Carriage Bolts (#56), one 4 ¾” x 2 3/8” Bracket (#27),

two Ø ¾” Washers (#67), and two M10 Aircraft Nuts (#69). Attach a Spring Clip to each

Post. DIAGRAM 3

STEP 4 (See Diagram 4)

A.) Attach the Lat Bar Frame Bracket (#20) to the top of the Rear Vertical Frame (#7). Secure it

with two M10 x 5/8” Allen Bolts (#64) and Ø ¾” Washers (#67).

B.) Attach the Left & Right Lat Bar Frames (#10 & 9) to the Lat Bar Frame Bracket (#20). Secure

them with two M10 x 5 ¼” Allen Bolts (#57), four Ø ¾” Washers (#67), and two M10 Aircraft

Nuts (#69).

C.) Secure each Lat Bar Frame to the Upper Frame (#8) with one M10 x 4 ½” Allen Bolt (#58), two

Ø ¾” Washers (#67) and one M10 Aircraft Nut (#69).

D.) Securely tighten all Bolts and Nuts previously installed.

E.) Attach a Pulley (#36) to the open slot on the Left Lat Bar Frame (#10). Secure it with one M10 x

2 1/8” Allen Bolt (#60), two ∅5/8” Pulley Bushings (#49), and one M10 Aircraft Nut (#69).

Repeat the same procedure to install the other side.

F.) Attach a Pulley to the Lat Bar Frame Bracket (#20). Secure it with one M10 x 1 ¾” Allen Bolt

(#61), two Ø ¾” Washers (#67), and one M10 Aircraft Nut (#69).

G.) Insert the Right & Left Bar Catches (#18 & 19), Right & Left Safety Catches (#16 & 17) into the

selected holes on the Upright Beams to obtain the desired position.

CABLE LOOP DIAGRAM

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Impex Salle de sport à domicile

Impex

Impex PHC -265 Manuel utilisateur

Impex

Impex MWB-838 Manuel utilisateur

Impex

Impex MARCY DIAMOND ELITE MD-2080 Manuel utilisateur

Impex

Impex Marcy SB-685 Manuel utilisateur

Impex

Impex CB-202 Manuel utilisateur

Impex

Impex JD-1.2 Manuel utilisateur

Impex

Impex MACH V Manuel utilisateur

Impex

Impex Iron Grip Strength IGS-6900 Manuel utilisateur

Impex

Impex Marcy Pro NS-6023RW Instructions d'installation et d'utilisation

Impex

Impex 120727 Manuel utilisateur

Impex

Impex WM 1403 Manuel utilisateur

Impex

Impex MARCY DIAMOND ELITE MD-3401 Manuel utilisateur

Impex

Impex MARCY PRO SM-7409 Manuel utilisateur

Impex

Impex Competitor WM-203 Manuel utilisateur

Impex

Impex STB-98010 Manuel utilisateur

Impex

Impex MWB-715N Manuel utilisateur

Impex

Impex CB 555 Manuel utilisateur

Impex

Impex MCB-5700 Manuel utilisateur

Impex

Impex GD-810 Manuel utilisateur

Impex

Impex PM-4510 Manuel utilisateur

Impex

Impex MARCY SB-510 Manuel utilisateur

Impex

Impex MARCY MWM 900 Manuel utilisateur

Impex

Impex POWERHOUSE SB 680 Manuel utilisateur

Impex

Impex MARCY TC-5580 Manuel utilisateur

Manuels Salle de sport à domicile populaires d'autres marques

Horizon Fitness

Horizon Fitness OXFORD 6 Manuel utilisateur

Energetics

Energetics Multi Trainer 5.1 Manuel utilisateur

Matrix

Matrix MG-PL Series Manuel utilisateur

Reebok

Reebok Tbr2i Manuel d'utilisation et d'entretien

Weider

Weider 8300 Hard Drive Manuel utilisateur

Pure Fitness

Pure Fitness 8526HE Manuel utilisateur

Weider

Weider 8700 I Guide de démarrage rapide

Bowflex

Bowflex Sport 001-6961 Manuel utilisateur

NordicTrack

NordicTrack E8200 Competition Bench Guide de démarrage rapide

Weider

Weider WEMC10161 Manuel utilisateur

Body Solid

Body Solid GHYP-345 Manuel utilisateur

Evo

Evo TAHOE 5105 Manuel utilisateur

cardiobull

cardiobull RA17 Manuel utilisateur

ParaBody

ParaBody 40 Manuel utilisateur

JLL

JLL Ventus Pro Air Power Manuel utilisateur

Trojan

Trojan Colorado 370 Manuel utilisateur

Octane Fitness

Octane Fitness xRide xR650 Manuel utilisateur

Precor

Precor Discovery Series Manuel utilisateur