6. CLEANING AND MAINTENANCE OPERATIONS
6.1. GENERALITIES AND PRODUCTS FOR CLEANING
BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS, CHECK TO MAKE SURE THAT THE
MAINS SWITCH BE OFF AND THE SUPPLY PLUG DISCONNECTED FROM THE MAINS.
ACCURATELY CLEAN THE EQUIPMENT AND THE DISCS EVERY DAY FOR A CORRECT OPERATION AND LIFE
OF THE EQUIPMENT.
THE DISCS,AND THE PLASTIC EJECTOR, CAN BE REMOVED FOR WASHING UNDER AWARM WATER JET.
CLEAN THE MACHINE, AND ABOVEALL WHERE THE DISCS REST, WITH A CLOTH OR A SPONGE WET WITH
WARM WATER, ACCURATELY REMOVE ALL WASTES TO PREVENT THE DISCS FROM CHANGING THEIR
POSITION.
OPEN THE COVER AND LOOSEN THE 2 PINSAS SHOWN IN FIG.6. REMOVE THE COVER AND WASH UNDER A
WATER JET.
(6)
CLEAN THE SURFACES WITH WATER AND SOUP, ALCOHOL, DETERGENTS WITHOUTABRASIVES OR
SUBSTANCES BASED ON CHLORINE OR SODA(CHLORINE WATER, MURIATIC ACID).
NEVER USE ABRASIVES, STEEL WOOL, OR SIMILAR PRODUCTS AS THEY MAY BRING DAMAGES TO THE
PAINT, THE COAT, OT THE MACHINE BODY.
FOR CLEANING, USE NON-TOXIC PRODUCTSAND ONES THAT GUARANTEE THE BEST HYGIENE.
6.2. OPERATIONS IN THE CASE OF FAILURES
1.WHEN PRESS THE GREEN BUTTON, IF THE LIGHT IS DARK, CHECK WHETHER THE COVERING OF MACHINE
COVER TIGHTLY; IF THE LIGHT IS BRIGHT, THE MACHINE CAN NOT WORK, CHECK WHETHER HANDLE DOWN;
IF STILL CAN’T WORK, THEN CUT OFF THE POWER AND CONTACT THE SERVICE CENTER.
2.WHEN THE MACHINE DOES NOT HAVE POWER OR BLADE RUN SLOW, OPEN THE MACHINE BOTTOM,
ACCORDING TO THE FOLLOWING CHART METHOD TOADJUST MOTOR TENSION BELT (2~3 MONTHS TO
ADJUST THE NEW MACHINES TENSIONING BELT, THE OLD MACHINE IS OFTEN GIVEN). THE GUARANTEE
PERIOD OF INSTALL NEW BELT ON THE MACHINE IS 9 MONTHSAFTER MANUFACTURED. THE
NON-PROFESSIONALS DO NOT DISASSEMBLE THE MACHINE.
1) REMOVE THE BOTTOM 2) REMOVE THE BRACKET
