Page 1 of 4
Inlet Guide Replacement Kit
Part Number: IC0118
Replacement Instructions
Introduction. This document provides the instructions necessary to replace the Inlet Guide of a CR 8 VET system. Make
sure to read this entire document before proceeding with any service.
The following information is supplementary to the device installation and operating instructions.
As a general rule, the installation and operating instructions for the device must also be observed. These instructions
include important information such as safety instructions and information on the setup, electrical connections, disinfection
process, cleaning process, etc.
Any repairs above and beyond routine maintenance must only be carried out by suitably qualified personnel.
Scope of Delivery. The following items are included in the scope of delivery:
– Inlet Guide (Qty 1)
– M3 X 8 Socket Head Cap Screws (Qty 10)
Required Tools (not supplied).
– 2.5 mm Allen wrench
– 5 mm flat-head screwdriver
NOTICE
Electrostatic-sensitive devices on the
assemblies
iAlways switch off the operating voltage before
carrying out any assembly or installation work on
the device.
iBefore and during the installation or assembly
work on the device, always ensure that the person
carrying out the work is grounded.
Before working on the appliance or in case of
danger, disconnect it from the mains (e. g. pull the
mains plug).
Task Guidelines. Personnel performing the replacement tasks should use standard industry guidelines for working
on equipment. These include the following:
iAlways use a clean well-lit work area with ample space required for the size of the job.
iObserve all warnings and precautions for safety as shown by the labels placed on the equipment. Keep all attaching
hardware and fastening screws together with the associated removed assembly.
iIf necessary use separate storage containers or envelopes for each hardware group.
iPrior to removing any part or assembly, note location and orientation of assemblies being removed.
iTag wires and associated mating connectors before disconnecting.
iUse care when disconnecting mating connectors so as not to damage the connector keys and connection to
the associated printed circuit board, wire or cable.
iBe aware of the damage impact of electrostatic discharge (ESD) on electronic devices and use ESD precautions
when handling printed circuit boards and wiring.
iDo not lift or move the unit by the top Touchscreen Assembly.
iOnly llift the unit by the sides of the Transport Assembly and/or the bottom base.
(J1650)
Image Plate Scanner
