iLight DALI-I-U Manuel utilisateur
Introduction
The DALI-I-U DALI Input Unit has 4 inputs
which can be individually congured as digital
inputs for a DALI control system.
Press and Release actions can be dened
individually for each of the inputs through
software. This enables third party control
plates, sensors, door contacts etc. to be added
to the iLight DALI control network.
Dimensions
Installation
The unit should be installed in a dry
location, where ambient temperature
and humidity are within the operating
limits of the unit.
Warning
This device is classied as ELV.
Third Party devices used as input
devices for DALI Input Unit must have
mains rating (DALI bus provides basic
insulation only). Exposed conductive
parts must be earthed in accordance
with local wiring regulations.
DALI-I-U DALI Input Unit
Installation guide
41mm
*Do not extend cables
20mm
4mm Deep
Cable length
158mm*
Control wiring
DALI-I-U includes 2 x polarity-free wires used to
connect to the DALI line (0.5 mm²).
Cable colours
Purple: Input 1
Blue: Input 2
Green: Input 3
Yellow: Input 4
Orange: COM
Red: DALI bus
Brown: DALI bus
Document: 9850-000651-01 DALI-I-U DALI Input Unit
Eaton Lighting Systems
Usk House, Lakeside, Llantarnam Park, Cwmbran, NP44 3HD, UK
T: +44 (0)1923 495495 F: +44 (0)1923 228796
E: [email protected] EatonLightingSystems.com
All products manufactured by Eaton Lighting Systems and identied with the iLight product series mark are warranted to be free from
defects in material and workmanship and shall conform to and perform in accordance with Seller’s written specications.
For warranty information, visit: www.eatonlightingsystems.com
This warranty will be limited to the repair or replacement, at Seller’s discretion, of any such goods found to be defective, upon their
authorized return to Seller. This limited warranty does not apply if the goods have been damaged by accident, abuse, misuse, modication
or misapplication, by damage during shipment or by improper service.
There are no warranties, which extend beyond the hereinabove-limited warranty,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY AND THE IMPLIED WARRANTY OF FITNESS.
No employee, agent, dealer, or other person is authorised to give any warranties on behalf of the Seller or to assume for the Seller any other
liability in connection with any of its goods except in writing and signed by the Seller. The Seller makes no representation that the goods
comply with any present or future federal, state or local regulation or ordinance. Compliance is the Buyer’s responsibility.
The use of the Seller’s goods should be in accordance with the provision of the National Electrical Code, UL and/or other industry or
military standards that are pertinent to the particular end use. Installation or use not in accordance with these codes and standards could
be hazardous.
Technical Information
Power
DALI voltage: 12-25 VDC
DALI consumption: < 9mA
Control Inputs
Voltage range: Open 5VDC / closed max. 0.3VDC
Current range: Max. 1mA
Mechanical
Housing: Encapsulated PCB
Weight: 10g
Operating conditions
Ambient temp. range: 0ºC - +40ºC
Relative humidity: 85 % (non-condensing)
Storage temp. range: -40°C - +70°C
Wiring Diagram
* input wires not
to be extended
Table des matières
Autres manuels iLight Équipement d'éclairage
Manuels Équipement d'éclairage populaires d'autres marques
Qazqa
Qazqa Suplux SL 3 Black 103062 Manuel utilisateur
Commercial Electric
Commercial Electric 54568141 Manuel utilisateur
CREE LIGHTING
CREE LIGHTING 304 Series Manuel utilisateur
Goobay
Goobay 49867 Manuel utilisateur
ECOMAN ITALIA
ECOMAN ITALIA LED T8 Manuel utilisateur
Alkalite
Alkalite Krypton KT-81 Manuel utilisateur
