Main unit
The AGF2B main unit is smaller than AGF2 main unit, but it works the same way.
Also user interface and connections are the same , just two redundant key are removed.
There are two versions of AGF2B main unit :
1. One is the 'BLU' version , recognizable from blue paint on connector and from power-on message. This
BLU main unit use specific BLU-type optic heads, which are better then standard non-BLU ones .
2. The other is the non-BLU version , or normal one, just the standard type compatible with optic heads
previously used .
The present messages on the display vary according to the state of operation. When the loom regularly
turns the display it shows the message 'Counting.. .OK' and to the left it points out the present heads (up
to 4 heads). The count and the relative verify take place in two following turns of the textile machine.
What the tool shows after power on, without pressing keys, is called 'initial page.'
The principal functions of the keys are the followings :
•'Page' key used to flow the various visualizations or pages .
•Key 'R' , it restores the normal operation of the device after a block and if pressed for a long time
(6 seconds ) it disable the device.
•The keys '+', '- ', they serve for planning the data in the various visualizations or pages (delay arrest
needle, password...).
•The key 'C' on AGF2 and the key 'J' on AGF2B serve for planning the data in the various
visualizations or pages (delay arrest needle, password...).
•The key 'C' on AGF2 and the key 'J' on AGF2B also serves for memorizing the number of needles
to count when the instrument show the relative page.
•The key ‘J ' allows to enable or to disable the jump of the discarded initial needle. When the jump
is enabled the message ‘Jump ' appear in the inferior line of the display, this immediately
implicates the skip of the control of the zones of fabric following to the magnetic sensor . If the
present message is then ‘No J. ' , then the whole fabric is checked.
There are some connector in the lower side :
•the most left connector type DB9 must be connected to the optic head of the proper type ; connect
BLU type optic heads if the main unit is BLU type . Otherwise connect standard optic head if the
main unit is a normal or standard one.
•The middle connector must connect to the adapter module or amplifier, one or two optic needle
scanner are then connected to the adapter.
•To the most right connector type DB15 must be connected the power supply cable, furnished.
15/01/10
Il presente documento è di proprietà della ditta I.L.E., ogni riproduzione o cessione a terzi è vietata a norma di legge.
6
