Please Note ( for 1 and 2 relay devices ONLY):
· As a power saving feature, the display dims if settings are not being made.
· Even though the device seems to operate correctly, the relay(s) will not energise if the input voltage is below the operating
voltage.
12 Month guarantee:
Ourproductis guaranteedfora 12 (twelve)monthperiod fromdate of purchase. This guaranteeis validfor defects arising from
failureduring specifiedconditions. This guarantee does notcover damagedue toabuse, tampering orimproper installation.Our
company does not accept liability for any consequential damage or loss arising from product malfunction. Should this product
proveto bedefective, kindly return for inspectionor repair.
Relay specifications:
Contactrating: 10A 250 VAC 2500VA
Mechanicallife: 30 millionoperations
Electrical life: 250000 operations(at maximumload)
Forfurtherinformation, please visit usat:www.iconelectronics.co.za
Menu operation (single display device):
All adjustments are made via the three front mounted buttons.
Press the “MENU” button repeatedly until the desired setting is reached, press “SELECT” to display the current value of the
selectedparameter, orsub menu(if applicable).
The“+” and“-” buttonsare usedto changethe value.
“ENTER”will returnthe deviceto themenu.
The “BACK” button will exit the menu.
Menu operation (dual display device):
Press the menu “4” button repeatedly until the desired setting is reached.
The“S” and“T” buttons areused to changethe value.
“4” will display the next menu item.
To exit the menu hold “4” button for 3 seconds.
Menu options:
Exitthe menu before making the following adjustments.
Lock / unlock parameters:
(default: unlocked)
Press “BACK” (“T”), then “ENTER” (“4”) and hold the 2 buttons until the desired option is displayed.
Thedisplay cycles between “Loc” (no changes allowed) & “u.Loc” (parameters may be adjusted)
Full / reduced menu (default: Full)
Press “SELECT”(“S”),then “ENTER”(“4”) and hold the 2 buttons until the desired option is displayed.
The display cycles between “rEdu” (limited menu) & “Full” (all parameters are accessible)
Access Code: (default: no code)
Oncethe aboveoptions havebeen setas required,Press “BACK”and “SELECT”(“T” and “S”)simultaneouslyuntil “CODE”is
displayed.
Now use the “+” & “-” (“S” and “T”) to enter a code.
Once a code is entered, access to the options above is not permitted.
To clear the code, re-enter the same code again.
If the code is forgotten. Press and hold “+” & “-” (“S”and “T” ) until “CODE” is displayed while re-applying power to the device.
