Please Note ( for 1 and 2 relay devices ONLY):
· As a power saving feature, the display dims if settings are not being made.
· Even though the device seems to operate correctly, the relay(s) will not energise if the input voltage is below the operating
voltage.
12 Month guarantee:
Ourproductisguaranteedfora12(twelve)monthperiodfrom date of purchase. This guarantee is valid for defects arising from
failureduringspecifiedconditions.Thisguaranteedoesnotcoverdamagedueto abuse, tampering or improper installation. Our
company does not accept liability for any consequential damage or loss arising from product malfunction. Should this product
provetobedefective,kindlyreturnforinspectionorrepair.
Relay specifications:
Contactrating: 10A 250 VAC 2500VA
Mechanicallife: 30millionoperations
Electrical life: 250000 operations (at maximum load)
Forfurtherinformation, pleasevisitusat: www.iconelectronics.co.za
Menu operation (single display device):
All adjustments are made via the three front mounted buttons.
Press the “MENU” button repeatedly until the desired setting is reached, press “SELECT” to display the current value of the
selectedparameter, or sub menu (if applicable).
The“+” and “-” buttons are used to change the value.
“ENTER”willreturnthedeviceto the menu.
The “BACK” button will exit the menu.
Menu operation (dual display device):
Press the menu “4” button repeatedly until the desired setting is reached.
The“S”and“T”buttonsareused to change thevalue.
“4” will display the next menu item.
To exit the menu hold “4” button for 3 seconds.
Menu options:
Exitthe menu before making the following adjustments.
Lock / unlock parameters:
(default: unlocked)
Press “BACK” (“T”), then “ENTER” (“4”) and hold the 2 buttons until the desired option is displayed.
Thedisplay cycles between “Loc” (no changes allowed) & “u.Loc” (parameters may be adjusted)
Full / reduced menu (default: Full)
Press “SELECT”(“S”),then “ENTER”(“4”) and hold the 2 buttons until the desired option is displayed.
The display cycles between “rEdu” (limited menu) & “Full” (all parameters are accessible)
Access Code: (default: no code)
Oncethe above options have been set as required, Press “BACK” and “SELECT” (“T”and“S”)simultaneously until “CODE” is
displayed.
Now use the “+” & “-” (“S” and “T”) to enter a code.
Once a code is entered, access to the options above is not permitted.
To clear the code, re-enter the same code again.
If the code is forgotten. Press and hold “+” & “-” (“S”and“T” ) until “CODE” is displayed while re-applying power to the device.
