IBM Eserver pSeries 7311 D10 Manuel utilisateur

pSeries 7311 Model D10 and Model D20

Service Guide

SA38-0627-00

ERserver

IBM

pSeries 7311 Model D10 and Model D20

Service Guide

SA38-0627-00

ER ser ver

IBM

First Edition (December 2002)

Before using this information and the product it supports, read the information in “Safety Notices” on page vii,

Appendix A, “Environmental Notices”, on page 201, and Appendix B, “Notices”, on page 203.

A reader’s comment form is provided at the back of this publication. If the form has been removed, address comments

to Information Development, Department H6DS-905-6C006, 11501 Burnet Road, Austin, Texas 78758-3493. To send

comments electronically, use this commercial internet address: [email protected]. Any information that you

supply may be used without incurring any obligation to you.

Note to U.S. Government Users -- Documentation related to restricted rights -- Use, duplication or disclosure is subject

to restrictions set forth is GSA ADP Schedule Contract with IBM Corp.

Contents

Safety Notices........................vii

Rack Safety Instructions .....................vii

Electrical Safety .......................viii

Laser Safety Information .....................ix

Laser Compliance ......................ix

Data Integrity and Verification ..................xi

About This Book ......................xiii

ISO 9000 .........................xiii

Accessing Information .....................xiii

Related Publications ......................xiii

Trademarks .........................xiv

Chapter 1. Reference Information .................1

pSeries 7311 Model D10 Overview .................1

Model D10 I/O Subsystem Features .................1

I/O Subsystem PCI-X Slot LED Definitions ..............3

D10 Power ........................4

Subsystem Positioning and Cabling ................6

D10 I/O Subsystem Locations ...................10

7311 Model D10 I/O Subsystem Front Locations............10

7311 Model D10 I/O Subsystem Rear Locations ............11

Model D10 I/O Backplane Locations................12

D10 I/O Subsystem PHB ...................13

D10 Location Codes ......................14

Physical Location Code Table ..................14

7311 Model D10 I/O Subsystem Location Code Table ..........15

pSeries 7311 Model D20 Overview .................16

Model D20 I/O Subsystem Features.................16

Model D20 PCI-X Slots ....................16

Model D20 Power ......................18

Model D20 Location Codes....................33

AIX and Physical Location Code Table ...............33

Model D20Location Code Table .................34

Powering the System On and Off..................36

Power-On Self-Test ......................36

Specifications ........................37

Model D10 Specifications ...................37

Model D20 Specifications ...................38

External AC Power Cables ....................39

Service Inspection Guide ....................40

Chapter 2. Diagnostics Overview .................41

Power and Attention LEDs ....................41

Component LEDs ......................41

Resetting the LEDs .....................41

iii

Checkpoints.........................41

FRU Isolation ........................42

Chapter 3. Maintenance Analysis Procedures (MAPs) ..........43

Chapter 4. Checkpoints ....................45

Chapter 5. Error Code to FRU Index ................47

Chapter 6. Using the Service Processor...............49

Chapter 7. Using System Management Services............51

Chapter 8. Removal and Replacement Procedures ...........53

Safety Considerations .....................53

Handling Static-Sensitive Devices .................54

Stopping the System ......................55

Starting the System ......................55

7311 Model D10 I/O Subsystem Removal and Replacement Procedures.....56

Model D10 FRU Replacement Procedure List ............56

D10 Service Position .....................57

D10 Operating Position ....................57

D10 Front Bezel ......................58

D10 Covers ........................59

D10 PCI Adapters......................61

Hot-Pluggable PCI Adapter...................63

PCI Hot-Plug Manager Access .................71

PCI Adapter or Blank Filler Removal From a Cassette Assembly ......74

Replacing an Adapter in a PCI Adapter Cassette ...........86

Short Adapter or Blank Filler Installation ..............90

Long Adapter Installation ...................106

D10Fan........................120

D10 RIO Cable ......................121

D10 RIO Bus Adapter ....................121

D10 I/O Backplane Assembly .................122

D10 Power Supply .....................123

7311 Model D20 I/O Subsystem Removal and Replacement Procedures ....124

Model D20 FRU Replacement Procedure List ............124

D20 Service Position ....................125

D20 Operating Position ...................126

D20 Service Access Cover ..................127

D20 Front Bezel ......................129

D20 Operator Panel.....................131

D20 Blowers .......................134

D20 Cooling Blowers Cable ..................137

D20 RIO Bus Adapter Assembly ................139

D20 PCI Adapters .....................142

D20 Hot-Plug Disk Drives ...................160

D20 Disk Drive Cage ....................165

D20 Disk Drive Backplane ..................167

iv Eserver pSeries 7311 Model D10 and Model D20 Service Guide

D20 Power Supplies ....................169

D20 Power Supply Bulkhead..................172

D20 I/O Backplane .....................175

Chapter 9. Parts Information ..................179

7311 Model D10 I/O Subsystem..................180

D10 I/O Backplane and Cooling.................180

D10 Power and Cooling ...................182

D10 SPCN, RIO, and Rack Beacon Cables .............184

D10 Rack Mounting Enclosure .................185

Model D20 I/O Subsystem ...................186

D20 I/O Backplane and Cabling.................186

D20 PCI Slots ......................188

D20 Power, RIO ......................190

D20 Operator Panel.....................192

D20 Fans and Disk Drives ..................194

D20 Covers and Brackets...................196

D20 RIO, SPCN, and Rack Beacon Cables .............197

Power Cables........................198

Appendix A. Environmental Notices................201

Product Recycling and Disposal..................201

Environmental Design .....................201

Acoustical Noise Emissions ...................201

pSeries 7311 Model D10 Declared Acoustical Noise Emissions ......201

pSeries 7311 Model D20 Declared Acoustical Noise Emissions ......202

Appendix B. Notices .....................203

Index ..........................205

Contents v

vi Eserver pSeries 7311 Model D10 and Model D20 Service Guide

Safety Notices

danger

notice indicates the presence of a hazard that has the potential of causing

death or serious personal injury. Danger notices appear on the following pages:

vviii

v53

caution

notice indicates the presence of a hazard that has the potential of causing

moderate or minor personal injury. Caution notices appear on the following pages:

vviii

vix

v53

v54

Note: For a translation of these notices, see

System Unit Safety Information

, order

number SA23-2652.

Rack Safety Instructions

vDo not install this unit in a rack where the internal rack ambient temperatures will

exceed 35 degrees C.

vDo not install this unit in a rack where the air flow is compromised. Any side, front or

back of the unit used for air flow through the unit must not be in direct contact with

the rack.

vCare should be taken to ensure that a hazardous condition is not created due to

uneven mechanical loading when installing this unit in a rack. If the rack has a

stabilizer it must be firmly attached before installing or removing this unit.

vConsideration should be given to the connection of the equipment to the supply

circuit so that overloading of circuits does not compromise the supply wiring or

overcurrent protection. To provide the correct power connection to the rack, refer to

the rating labels located on the equipment in the rack to determine the total power

requirement for the supply circuit.

vAn electrical outlet that is not correctly wired could place hazardous voltage on the

metal parts of the system or the devices that attach to the system. It is the

responsibility of the customer to ensure that the outlet is correctly wired and

grounded to prevent an electrical shock.

vii

Electrical Safety

Observe the following safety instructions any time you are connecting or disconnecting

devices attached to the workstation.

In the system you are about to setup or service:

vThe ac power interface connector is considered the main power disconnect device.

vThis system has redundant power supply capabilities, meaning that it has the ability

to have two power supplies running simultaneously in the same system unit. When

instructed to disconnect the power source, ensure that all power cables have been

unplugged.

DANGER

An electrical outlet that is not correctly wired could place hazardous voltage

on metal parts of the system or the devices that attach to the system. It is the

responsibility of the customer to ensure that the outlet is correctly wired and

grounded to prevent an electrical shock.

Before installing or removing signal cables, ensure that the power cables for

the system unit and all attached devices are unplugged.

When adding or removing any additional devices to or from the system,

ensure that the power cables for those devices are unplugged before the

signal cables are connected. If possible, disconnect all power cables from the

existing system before you add a device.

Use one hand, when possible, to connect or disconnect signal cables to

prevent a possible shock from touching two surfaces with different electrical

potentials.

During an electrical storm, do not connect cables for display stations, printers,

telephones, or station protectors for communications lines.

D05

CAUTION:

This product is equipped with a three-wire power cable and plug for the user’s

safety. Use this power cable with a properly grounded electrical outlet to avoid

electrical shock.

C01

CAUTION:

This unit has more than one power supply cord. To reduce the risk of electrical

shock, disconnect two power supply cords before servicing.

C21

viii Eserver pSeries 7311 Model D10 and Model D20 Service Guide

Autres manuels pour eserver pSeries 7311 D10

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels IBM Serveur

IBM

IBM eServer xSeries 345 Type 8670 Manuel utilisateur

IBM

IBM Power System LC922 Manuel utilisateur

IBM

IBM System x3755 M3 7164 Manuel utilisateur

IBM

IBM Power System E880C Manuel d'utilisation et d'entretien

IBM

IBM 990 Manuel utilisateur

IBM

IBM Redboks System x3550 M4 Instructions d'installation et d'entretien

IBM

IBM eServer xSeries 305 Type 8673 Manuel utilisateur

IBM

IBM S/390 Multiprise 3000 Manuel utilisateur

IBM

IBM BladeCenter HX5 Manuel utilisateur

IBM

IBM eServer 200 xSeries Fiche d'information produit

IBM

IBM 8671 - Eserver xSeries 235 Mode d'emploi

IBM

IBM System x3620 M3 7376 Manuel utilisateur

IBM

IBM PS700 Guide d'installation

IBM

IBM 8647 - Eserver xSeries 225 Mode d'emploi

IBM

IBM xSeries 450 8688 Instructions d'utilisation et d'entretien

IBM

IBM 8649 - Eserver xSeries 225 Mode d'emploi

IBM

IBM eserver xSeries 306 Manuel utilisateur

IBM

IBM Power Systems E870 Guide d'installation

IBM

IBM Flex System p24L Compute Node Manuel utilisateur

IBM

IBM eServer xSeries 135 Manuel utilisateur

IBM

IBM X366 Series Manuel utilisateur

IBM

IBM System x3550 M3 Manuel utilisateur

IBM

IBM eServer BladeCenter HS20Type 8832 Manuel utilisateur

IBM

IBM 7944 Manuel utilisateur

Manuels Serveur populaires d'autres marques

HP AlphaServer ES47 Manuel utilisateur

Dell

Dell PowerEdge R410 Manuel utilisateur

PowerNAS

PowerNAS CMA Manuel utilisateur

Supero

Supero FatTwin F617R3-FT Manuel utilisateur

MSI

MSI P1-109N-L70 Manuel utilisateur

Dell

Dell PowerEdge XE9640 Manuel

Dell

Dell PS4100 Instructions de montage

EtroVISION

EtroVISION EV3151 Manuel utilisateur

NEC

NEC Express5800/T110j Manuel utilisateur

HP ProLiant Gen9 Manuel utilisateur

Compaq

Compaq ProLiant 3000 Manuel

Dell

Dell PowerEdge 3YPMN Manuel utilisateur

iRobo

iRobo IPC2U Manuel utilisateur

Nortel

Nortel 1000 Con?guration guide Manuel utilisateur

Asus

Asus AP7500 Manuel d'utilisation et d'entretien

Avid Technology

Avid Technology AirSpeed 5000 Manuel utilisateur

HP Integrity rx2600 Guide d'installation

Milestone

Milestone Husky IVO 350T Manuel utilisateur

IBM eserver pSeries 7311 D10 Manuel utilisateur

Manuels Serveur populaires d'autres marques