iBeam TE-FDPL Manuel utilisateur
IMPORTANT
If you are having difficulties with the installation of this
product, please call out Tech Support line at 1-800-253-
TECH. Before doing so, looks over the instructions a
second time, and make sure the installation was
performed exactly as the instructions are stated. Please
have the vehicle apart and ready to perform
troubleshooting steps before calling.
REV. 10/23/2018
TE-FDPL
Manual
1. Box Contents
Wiring Camera
2. Applications
2010-2016 Ford Transit Connect
3. Installation
4. Specifications
Sensor
CMOS ¼ sensor
Resolution
420 TV Lines
Field of view
Diagonal 170º
Illumination
.05 Lux
IP rating
IP68
Parking Lines
Defeatable
Extension cable
23’
TV system
NTSC
Working Temp
-30ºC ~ 70ºC
Warranty
3 years
NOTES
NOTES
1.) Remove the panel from inside the back door of
the vehicle, there are 4 push pins holding the
panel on the door, remove the 4 pins and
remove the panel.
2.) Push out the light over the license plate. It is
being held in by two side clips.
3.) Unplug the light.
4.) Remove the gasket from the light fixture to gain
access to the light fixture. Sometimes you can
pop the light fixture out without removing the
gasket.
5.) Pop the light fixture out from the hood and light
diffuser. Pay attention when removing the light
fixture to the clips and their orientation to the
hood.
6.) Take the new hood, camera and light diffuser.
Make sure the properly line up the factory light
fixture with the new hood. Line up the clips to
match the factory hood.
7.) Run the wire from the camera through the clip
area of the light fixture.
8.) Clip the light fixture back into place. Re-stick the
gasket back onto the housing to ensure a
watertight fitment.
9.) Plug back into vehicle, run wire for the camera
through the door and into the vehicle. Run the
video wire to the front of the vehicle to the
monitor.
10.)Plug into the video in or rear camera input.
11.)Wire up the RED wire to reverse and BLACK
wire to chassis ground. Test trigger and video to
make sure the camera is operating correctly.
12.)Re-assemble vehicle.
NOTES
Table des matières
Autres manuels iBeam Appareil photo numérique
iBeam
iBeam TE-360-3D Manuel utilisateur
iBeam
iBeam OnSite Manuel utilisateur
iBeam
iBeam TE-MDC Manuel utilisateur
iBeam
iBeam TE-3BDP Manuel utilisateur
iBeam
iBeam TE-3BUV Manuel utilisateur
iBeam
iBeam TE-LPC Manuel utilisateur
iBeam
iBeam TE-3BMC Manuel utilisateur
iBeam
iBeam Fixed 4K Premier Manuel utilisateur
iBeam
iBeam TE-3BNV Manuel utilisateur
