HydroTherm DYNAMIC /X8 Manuel utilisateur
DYNAMIC /X8
PLUMBER’S CONDENSED
INSTALLATION GUIDE
SUPPLIED CONTENTS
Welcome to the future of hot water.
OWNER’S MANUAL
DYNAMIC /X8
OWNER’S
MANUAL
HYDROTHERM UNIT
1. LOCATION SELECTION
CONDENSATE
DRAINAGE
ELBOW (connected)
150mm 600mm
300mm
FRONT SIDE LEFT SIDE
150mm
2. BASE
PTR
Clearance Requirements
300mm
• This unit is designed for external operation only and requires a continuous supply of air to operate efficiently.
• Avoid installation in areas where falling debris, such as leaves, is prevalent as this may result in air vents being
blocked or the unit being damaged.
• Avoid placing the system in locations with multiple walls or structures.
• Always maintain optimum perimeter from all structures.
• The unit should be installed on a concrete plinth or stable structure capable of sustaining weights in excess of
450kg.
• A minimum dimension of 600mm x 600mm is required. Please ensure that all four feet are supported by the
base being used otherwise warranties may be voided.
• The system is to be installed level to ensure that the condensation drainage is not impaired.
pg.1
4. CONDESATION DRAINAGE
pg.2
Cold water supply outlet (3/4” female thread)
Hot water outlet (3/4” female thread)
Condensate drainage elbow*
PTR relief valve* (1/2” female thread 850kPa)
Electrical cable
Tempering Valve (high performance recommended)
ECV (if required by council - 700kPa)
Pressure Reduction Valve (PRV - 500kPa)
Non-return Isolation valve
Electrical access (50mm min.)
Electrical access dish (50mm min.)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11 .
5. BLEEDING THE SYSTEM
2
3
4
5
10
6
7
8
9
11
3. PLUMBING CONNECTIONS
1
Hand
screws
Tighten Loosen
Ensure at least one hot water tap is open inside
the property. While the system begins filling with
water, you will hear air being expelled from the
open hot water tap. This ensures that no air
pockets remain. Once water begins running out of
the hot water tap, the system is completely bled
and you can then turn the tap off.
6. TURNING THE UNIT ON
Remove Stainless Steel cover by simply loosening hand screws.
Unlock the screen by pressing the POWER button once.
Press and hold the POWER button for 3 seconds until the SUN symbol flashes.
Return screen cover back onto unit after setting clock
1.
2.
3.
4.
SYSTEM MUST
BE LEVEL
!
620mm
Dish
Condensate
drainage
elbow
1800mm
*Supplied with system
Table des matières
Manuels Système d'eau populaires d'autres marques
Spirotech
Spirotech SPIROVENT SUPERIOR S250 Manuel utilisateur
Culligan
Culligan Aqua-Cleer Aqua-Cleer Advanced Drinking Water... Manuel utilisateur
A.O. Smith
A.O. Smith Dura-Max AJH - 1000A - P Manuel utilisateur
Microline
Microline T.F.C.-4 Manuel
Eureka Forbes
Eureka Forbes Aquaguard Select Manuel utilisateur
Cetetherm
Cetetherm AquaEfficiency Manuel utilisateur
