Huvitz HS-5500 Manuel utilisateur

------------------------------------------------------ -----------------------------

SLIT LAMP HS

Operator’s Manual

SLIT LAMP MICROSCOPE HS

SLIT LAMP HS

-------------------

-----------------------------------------

---------------------

MPORTANT NOTICE

WARNING

Potential electromagnetic or other interference between medical equipments and other

devices being operated together in the same environmental may expert an adverse

influence on f

unctioning of the medical equipment.

Non

medical equipments not in

compliance with the requirements of EN 60601

1 and EN 60601

2 should not be

used together in the same environmental as the medical equipments

This equipment has been tested and found t

o comply with the limits for medical devices in

IEC 60601

2:2001.

These limits are designed to provide reasonable protection against

harmful interference in a typical medical installation

Power Cord

For use of equipment in rated voltage less than 125V

, minimum

, Type

SJT or

SVT,

18/3AWG

, 10A

, max 3.0m

long:

One end with Hospital Grade Type, NEMA 5

15P

other

end with appliance coupler. For use of equipment in rated voltage less than 250Vac

minimum

, Type

SJT or

SVT,

18/3AWG

, 10A

, max 3.0m

long:

ne end

terminated

with

blade attachment

plug (

HAR) Type, NEMA 6

15P.

This product may malfunction due to electromagnetic waves caused by portable personal

telephones, transceivers, radio

controlled toys, etc. Be sure to avoid having objects such as,

which

affect this product, brought near the product.

The information in this publication has been carefully checked and is believed to be entirely

accurate at the time of publication. HUVITZ assumes no responsibility, however, for possible

errors or omissions,

or for any consequences resulting from the use of the ormation

contained herein.

------------------------------------------------------ -----------------------------

SLIT LAMP HS

HUVITZ reserves the right to make changes in its products or product specifications at any

time and without prior notice, and is not required to update this documentation

to reflect such

changes.

HUVITZ Co., Ltd.

689

3, Geumjeong

dong, Gunpo

si, Gyeonggi

do,

435

862, Republic of Korea

All rights are reserved.

Under copyright laws, this manual may not be copied, in whole or in part, without the prior

written c

onsent of HUVITZ Co., Ltd.

Document

Number: 9000ENGJ101

SLIT LAMP HS

-------------------

-----------------------------------------

---------------------

Contents

Introduction

................................

.......

Safety Information

................................

..............................

Features & Operating Condition

................................

......

Standard Components

................................

.....................

Accessories

................................

.....

Composition

................................

....

Installation

................................

.......

Trial Operations

................................

...............................

Main Features

................................

10.

Ordinary Maintenance

................................

......................

Indication for use

................................

.....................

1.2.

Classification

................................

............................

2.1.

Introduction

................................

..............................

2.2.

Safety Symbols

................................

........................

2.3.

Environment factors

................................

................

2.4.

Safety Preca

utions

................................

..................

3.1.

Brief Description

................................

.....................

3.2.

Operating Condition

................................

................

7.1.

Assembling the Instrument

................................

......

------------------------------------------------------ -----------------------------

SLIT LAMP HS

11.

EMC Information

................................

..............................

12.

Electric Diagram

................................

...............................

13.

Technical Specifications

................................

..................

14.

Service Information

................................

..........................

15. Pa

rti

cular Information

………………

…

…………………

………………

…

……

.47

10.1.

Halogen Projection bulb

................................

..........

10.2.

Protection fuses replacement

................................

...

10.3.

Cleaning & Disinfect

ion

................................

...........

11.1.

Guidance and manufacturer’s declaration

–

electromagnetic emissions

......

11.2.

Guidance and manufacturer’s declaration

–

electromagnetic immunity

.......

11.3.

Guidance and manufacturer’s declaration

–

electromagnetic immunity

.......

11.4.

Recommended separation distances between portable and mobile RF

communications equipment and the EUT

................................

..............................

11.5.

Immunity

and Compliance Level

................................

..............................

11.6.

Guidance and manufacturer’s declaration

–

electromagnetic immunity

.......

SLIT LAMP HS

-------------------

-----------------------------------------

---------------------

Introduction

1.1.

Indication for

use (

intended use)

1.2.

Classification

CAUTION

The SLIT LAMP, HS

5500 is intended for use in eye examination of the ant eye

segments, from the cornea epithelium to the posterior capsule. It is used to aid in the

diagnosis of dise

ases or trauma which

affects

the structural properties of the anterior

eye segment.

Protection against electric shock: Class I

Applied Parts: Type B applied parts.

Protection against harmful ingress of water: Ordinary, IPX0

Degree of safet

y in the presence of a flammable anesthetics mixture with air

or with oxygen or with nitrous oxide: Not suitable for use in the presence of a

flammable anesthetics mixture with air or with oxygen or with nitrous oxide.

Mode of operation: Continuous

Light H

azard protection Classification: Group 2 by ISO15004

2:2007

Stationary:

Do not try to move this equipment without help.

This microscope is

heavy and should maintain stationary. Always get two persons to help lift this

unit

Federal law restricts this de

vice to sale by or on the order of a physician

------------------------------------------------------ -----------------------------

SLIT LAMP HS

Safety Information

2.1.

Introduction

NOTE

WARNING

UTION

Safety is everyone

’

s responsibility. The safe use of this equipment is largely dependent

upon the installer, user, operator, and maintainer. It is imperative that personnel

study

and become familiar with this entire manual before attempting to

install

use, clean,

service or adjust this equipment and any associated accessories. It is paramount that

the instructions contained in this manual are fully understood and followed to

enhance

safety to the patient and the user/operator. It is for this reason that the following safety

notices have been placed appropriately within the text of this manual to highlight safety

related information or information requiring special emphasis. Al

l users, operators, and

maintainers must be familiar with and pay particular attention to all Warnings and

Cautions incorporated herein.

“

Warning

”

indicates the presence of a hazard that could result in severe personal injury,

death or substantial prop

erty damage if ignored

“

Note

”

describes information for the installation, operation, or maintenance of which is

important but hazard related if ignored.

“

Caution

”

indicates the presence of a hazard that could result in minor injury, or

proper

ty damaged if ignored.

SLIT LAMP HS

-------------------

-----------------------------------------

---------------------

2.2.

Safety Symbols

Save this instruction

The International

Electro technical

Commission

(IEC) has established a set of symbols

for medical electronic equipment which classify a connection or warn of any potential

hazards. The classifications and symbols are

shown below.

This applies only to the instrument that has the certification symbol printed explicitly on

the product label or sticker.

I and O on power switch represent ON and OFF respectively.

Type B Isolated patient connecti

on.

This symbol identifies a safety note. Ensure you understand

the function of this control before using it. Control on

described in the appropriate User’s or Service Manual.

Identifies the point where the system safety ground is

fastened t

o the chassis. Protective earth connected to

conductive parts of

Class I equipment for safety purposes.

Hot surface.

------------------------------------------------------ -----------------------------

SLIT LAMP HS

UL60601

CAN/CSA C22.2

NO.601.1

MEDICAL EUIPMENT

WITH RESPECT TO ELECTRIC SHOCK

FIRE AND MECHANICAL HAZARDS

ONLY IN ACCORDANC

E WITH UL

60601

AND CAN/CSA

C22.2

NO.601.1

Disposal of your old appliance

When this crossed

out wheeled bin

symbol is

attached to a

product it

means the

product is covered by the European

Directive 2002/96/EC.

All electrical and electronic products s

hould be disposed of

separately from the municipal waste stream via designated

collection facilities appointed by the government or the local

authorities.

The correct disposal of your old appliance will help prevent

potential negative consequences for the

environment and

human health.

4. For more detailed information about disposal of your old

appliance, please contact your city office, waste disposal

service or the shop where you purchased the product.

Alternating Current

SLIT LAMP HS

-------------------

-----------------------------------------

---------------------

2.3.

Environment factors

Avoid

the following environments for operation or storage:

Where the equipment is exposed to water vapor.

Don

’

t operate

equipment

with a wet hand.

Where the equipment is exposed to direct sunlight.

Where the temperature changes

extremely

Normal operat

ing temperature range is from 10

C to 40

Humidity is from 30% to 75%.

Altitude is from 700 to 1060hpa

Where it is near the heat equipment.

Where the humidity is extremely high or there is a ventilation

problem.

Where t

he equipment is subject to excessive shocks or

vibrations.

Table des matières

Autres manuels Huvitz Microscope

Huvitz

Huvitz HSZ-700 Manuel utilisateur

Huvitz

Huvitz HS-7500 Manuel utilisateur

Huvitz

Huvitz HS-5000 3X Manuel utilisateur

Huvitz

Huvitz HRM-300 Manuel utilisateur

Huvitz

Huvitz HS-5000 SX Manuel utilisateur

Huvitz

Huvitz HS-5000 5X Manuel utilisateur

Huvitz

Huvitz HS-5000 2X Manuel utilisateur

Huvitz

Huvitz HSZ-600 Manuel utilisateur

Huvitz

Huvitz HS-7000 Manuel utilisateur

Manuels Microscope populaires d'autres marques

Thermo Scientific

Thermo Scientific Nicolet iN10 Mode d’emploi

National

National DC3-163 Manuel utilisateur

KERN Optics

KERN Optics OPE-1 Manuel utilisateur

OPTIKA MICROSCOPES

OPTIKA MICROSCOPES B-150D Manuel utilisateur

Prior

Prior Lux POL Manuel utilisateur

Opitec

Opitec Smartscoop 115615 Manuel utilisateur

KERN

KERN OPO-1 Manuel utilisateur

Topcon

Topcon SP-1P Manuel utilisateur

Motic

Motic PA43 Manuel utilisateur

Leica

Leica DVM5000 Guide de l'utilisateur

MshOt

MshOt MZ62 Manuel utilisateur

KERN Optics

KERN Optics OZR-5 Manuel utilisateur

VWR

VWR VisiScope 384 Series Manuel utilisateur

Nikon

Nikon ECLIPSE E200 POL Manuel utilisateur

Leica

Leica DI C800 Manuel

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Manuel utilisateur

ThermoFisher Scientific

ThermoFisher Scientific Continuµm Manuel utilisateur

Olympus

Olympus SZ61 Manuel utilisateur