HUSKY LINERS 5730 Manuel utilisateur

PART NO. 5730

5730 Rear Instructions.doc

Rev: 0

95-02 CHEVROLET ZR2 S-10 PICKUP / GMC SONOMA HIGHRIDER TRUCK

REAR MUD GUARD SET

INSTALLATION INSTRUCTIONS

Install Paint Protection Film before mud guards (see other side)

Please read instructions thoroughly before installation.

Tools Required:

•1/8” drill bit / Drill

•Wrench (varies depending on vehicle)

•Center punch / Hammer

•Short Phillips screwdriver

•Marking utensil (fine tip marker, grease pencil, etc.)

Package Contents

•Driver & passenger side mud guard

•1” #10 screws (qty. 4)

•Paint protection film

•Instruction sheet

NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.

1. Clean and degrease the mud guard location area on the fender before installation.

2. Using a Wrench, remove existing fastener from location A (see figure 1) (fastener type varies from vehicle to vehicle).

3. Attach mud guard to fender with existing fastener at location A, check fit and level before tightening.

4. Using mud guard as a template, mark, center punch, and drill 1/8” holes at locations B and C.

5. Attach mud guard to fender with #10 screws at locations B and C.

PAINTING INSTRUCTIONS

1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.

2. Sand painting surface with 320 grit sand paper.

3. Apply a coating of flexible primer-adhesion promoter.

4. Apply a flexible paint as directed by the paint manufacturer.

PART NO. 5730

5730 Rear Instructions.doc

Rev: 0

PAINT PROTECTION FILM - INSTALLATION INSTRUCTIONS

NOTE: The Paint Protection Film is a precut template of film used to protect the mud guard mounting

surfaces of your fenders against wear. The templates (left and right side) can be removed from the

backing liner by folding the liner at the center cut of the template, separating the film sides and peeling

the film templates from the backing liner.

1. Position mud guard on fender to indicate placement of paint protection film.

2. Clean the placement area of fender with a clean cotton cloth and a petroleum distillate based cleaner

such as DuPonts Prep-Sol Brand Solvent Cleaner or 3M Brand Adhesive Cleaner and dry.

3. Mix a wetting solution of 1 pint of water with 4 drops of liquid dishwashing detergent.

4. Mark correct position of film by placing mud guard against fender.

5. Remove protection film from liner and flood adhesive side of film with wetting solution (use a spray bottle

or sponge).

6. Thoroughly wet film placement location of fender with wetting solution.

7. Position the adhesive side of film on fender and flood with wetting solution.

8. Check location of film with mud guard and reposition as necessary.

9. Using a sponge, squeegee any air bubbles and wrinkles from film.

10. Allow film to dry before installing mud guard.

Ce manuel convient aux modèles suivants

1

Table des matières

Autres manuels HUSKY LINERS Accessoires automobiles

HUSKY LINERS

HUSKY LINERS 9178 Manuel

HUSKY LINERS

HUSKY LINERS 6251 Manuel

HUSKY LINERS

HUSKY LINERS 6203 Manuel

HUSKY LINERS

HUSKY LINERS Hitch Mount Mud Flap Manuel utilisateur

HUSKY LINERS

HUSKY LINERS 2053 Manuel

HUSKY LINERS

HUSKY LINERS 5622 Manuel utilisateur

HUSKY LINERS

HUSKY LINERS 3577 Manuel

HUSKY LINERS

HUSKY LINERS 7379 Manuel

HUSKY LINERS

HUSKY LINERS BELMOR BFM1004M2 Manuel

HUSKY LINERS

HUSKY LINERS 6334 Manuel

HUSKY LINERS

HUSKY LINERS 5777 Manuel utilisateur

HUSKY LINERS

HUSKY LINERS 6077FR Manuel

HUSKY LINERS

HUSKY LINERS 6597 Manuel

HUSKY LINERS

HUSKY LINERS 6921FR Manuel

HUSKY LINERS

HUSKY LINERS 6621 Manuel

HUSKY LINERS

HUSKY LINERS 2107 Manuel

HUSKY LINERS

HUSKY LINERS 6141 Manuel

HUSKY LINERS

HUSKY LINERS 3402 Manuel

HUSKY LINERS

HUSKY LINERS 47904 Manuel utilisateur

HUSKY LINERS

HUSKY LINERS 2590FR Manuel

HUSKY LINERS

HUSKY LINERS 8141 Manuel

HUSKY LINERS

HUSKY LINERS 47911 Manuel utilisateur

HUSKY LINERS

HUSKY LINERS 7391 Manuel

HUSKY LINERS

HUSKY LINERS 47952 Manuel utilisateur

Manuels Accessoires automobiles populaires d'autres marques

James Baroud

James Baroud Odyssey Manuel utilisateur

Motorola

Motorola i50sx Manuel utilisateur

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuel utilisateur

Feniex

Feniex T3 Manuel utilisateur

Renault

Renault 77 11 423 180 Manuel utilisateur

Kia

Kia E8300-4D000 Manuel utilisateur

Brink

Brink 756843 Manuel utilisateur

Whispbar

Whispbar K085W Manuel utilisateur

v.link

v.link CI-VL2-PC-HSD Manuel utilisateur

Viking

Viking Stack-Rack Guide de configuration rapide

Aries

Aries 203015 Manuel utilisateur

Choetech

Choetech AT0005 Manuel utilisateur

ZZ2

ZZ2 ZZAIR-PRO Manuel utilisateur

Holman

Holman 4A80L Manuel utilisateur

Thule

Thule 2075 Manuel utilisateur

Motorola

Motorola T325 Manuel utilisateur

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guide d'installation

DV8

DV8 FBJL-02 Manuel utilisateur