Human Touch Ht103 Manuel utilisateur

REMOVING THE BACKREST

1. Locate the connector box on the bottom right-hand side of the chair (Fig.2).

2. Using a Phillips-head screwdriver, remove the two screws that secure the connector box cover, remove the cover, then disconnect the connectors.

3. Using a nail clippers, or other suitable instrument, cut and remove all zip ties that secure the backrest connectors and cable harness to the bottom of the

chair, being careful not to cut the harness casing.

1. Remove the head pillow and backrest pad, following the instructions in the Use & Care manual.

2. Push down on the backrest release lever, then fold the backrest forward onto the chair seat (Fig.1).

3. Power off the chair and unplug it.

GET READY

(Fig.1)

Backrest release lever

Tools Required: Pliers, vice grip, Phillips-head screwdriver, small hammer, nail clipper or other instrument suitable for cutting zip ties, new zip ties

NOTE: SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY

REPLACING THE BACKREST

Connector box

(Right-hand side of the chair)

(Fig.2)

Sept 19, 2011

HT-100/102/103/120/130/140

410/430/450/3100/3200/3300

It is imperative that Human Touch® products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used

during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair

instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.

SERVICE LEVEL: 3

4. Pull gently outward on the bottom of one of the rear side panel covers to remove it (Fig.3).

5. Using a Phillips-head screwdriver, remove the screw and washers that secure the metal hinge pin to the chair (Fig.4).

6. Using a pliers (or a vice grip if necessary), pull the hinge pin toward you until it is freed from the chair (Fig.5). NOTE: The hinge pin is lubricated.

Place it on a disposable object, such as a paper towel, to avoid damaging the flooring beneath the chair.

NOTE: When the hinge pin is removed, the two spacers that are located between the backrest and the chair base will most likely fall off (Fig.6).

Be sure to set these spacers aside for use during reassembly.

7. Repeat steps 4 - 6 on the other rear side panel panel.

8. Carefully lift the backrest up and off the chair base.

Hinge pin

(Fig.5)

Backrest

spacers

(Fig.6)

(Fig.3)

Hinge pin

Washer

Screw

(Fig.4)

INSTALLING THE NEW BACKREST

1. Place the new backrest into position, face-down on the chair base.

2. From the outside of one of the side panels, insert the hinge pin through the hole, just until it is visible on the inside of the side panel.

3. Place the two spacers into position on the inside of the side panel, with the smaller spacer between the larger spacer and the side panel, then push the

hinge pin through both spacers (Fig.7).

4. Use your fingers to line up the bracket in the side of the backrest and the hinge pin; you will need to pull up slightly on the lower part of the backrest to

properly align the hinge pin with the bracket.

5. Insert the hinge pin as far into the bracket as possible, then use a small hammer to install it completely into the bracket.

6. Secure the hinge pin to the side panel using a Phillips-head screwdriver and the screw you removed earlier.

7. Replace the side panel cover, by aligning the plugs on the inside of the cover with the corresponding holes on the chair, then pushing the cover firmly

into place (Fig.8).

Hinge pin

Side panel

Smaller spacer

Larger spacer

Backrest

(Fig.7)

(Fig.8)

8. Repeat steps 2 - 7 on the other side panel.

9. Reconnect the cables at the connector box on the bottom right-hand side of the chair (Fig.9).

10. Using a Phillips-head screwdriver, secure the connector box cover using the two screws you removed earlier.

11. Replace the zip ties you removed previously, to secure the connector boxes and cables to the bottom of the chair.

12. Reinstall the chair pads, following the instructions in the Use and Care Guide.

13. Plug in and power on the chair, then verify that both the massage and recline functions work.

Please send any questions or comments regarding these instructions to: [email protected]

Connector box

(Right-hand side of the chair)

(Fig.9)

Autres manuels pour ht103

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Human Touch masseur

Human Touch

Human Touch NOVO Manuel utilisateur

Human Touch

Human Touch Manhattan Manuel utilisateur

Human Touch

Human Touch HT-5270 Manuel utilisateur

Human Touch

Human Touch AcuTouch 840 Manuel utilisateur

Human Touch

Human Touch WholeBody 5.1 Manuel utilisateur

Human Touch

Human Touch Wholebody 5.0 Manuel utilisateur

Human Touch

Human Touch CirQlation Pro Manuel utilisateur

Human Touch

Human Touch iJOY 2.1 Manuel utilisateur

Human Touch

Human Touch PC500 Manuel utilisateur

Human Touch

Human Touch iJoy Manuel utilisateur

Human Touch

Human Touch Acuvibe ht1260 Manuel utilisateur

Human Touch

Human Touch PC6 Manuel utilisateur

Human Touch

Human Touch Perfect Chair Serenity PC-086 Manuel utilisateur

Human Touch

Human Touch HT Bliss Manuel utilisateur

Human Touch

Human Touch HT-820/9200 Manuel utilisateur

Human Touch

Human Touch ZeroG 3.0 Manuel utilisateur

Human Touch

Human Touch pc 075 Manuel utilisateur

Human Touch

Human Touch HT-2620 Manuel utilisateur

Human Touch

Human Touch IJOY HT-2720 Manuel utilisateur

Human Touch

Human Touch wholebody 7.1 Manuel utilisateur

Human Touch

Human Touch iJOY Active 2.0 Manuel utilisateur

Human Touch

Human Touch WholeBody HT-275 Manuel utilisateur

Human Touch

Human Touch feel better HT-245PS Manuel utilisateur

Human Touch

Human Touch HT-270 Manuel utilisateur

Manuels masseur populaires d'autres marques

ELEEELS

ELEEELS P2 Manuel utilisateur

Cenocco

Cenocco CC-9111 Manuel utilisateur

Panasonic

Panasonic EP790-C1 Manuel utilisateur

Adler

Adler AD 2167 Manuel utilisateur

Taurus

Taurus Wellness TW-MC-M Manuel utilisateur

Infinity

Infinity Syner-D Circadian Manuel utilisateur

Hydas

Hydas LH-095 Manuel utilisateur

AEG

AEG FM 5567 Manuel utilisateur

OBH Nordica

OBH Nordica Shiatus Tunes Manuel utilisateur

Hutech

Hutech Q9 Manuel utilisateur

Medisana

Medisana MM 825 Manuel utilisateur

SOLAC

SOLAC Therma Hydro Manuel utilisateur

Invacare

Invacare Texas Manuel utilisateur

Casada

Casada Bismarck II Manuel utilisateur

Fujiiryoki

Fujiiryoki Cyber-Relax EC-1700 Manuel utilisateur

Medisana

Medisana HM 886 Manuel utilisateur

HoMedics

HoMedics BA-C200 Manuel utilisateur

Repose

Repose Lynton Manuel utilisateur

Human Touch ht103 Manuel utilisateur

Manuels masseur populaires d'autres marques