Honeywell DOLPHIN 6500 Manuel utilisateur
™
DolphinTM 6500 Mobile Computer
Quick Start Guide
1
Dolphin 6500 Mobile Computer
Out of the Box
Verify that your carton contains the following items:
• Dolphin 6500 mobile computer (the terminal)
• Main battery pack (3.7v, Li-ion)
• AC power supply
• Localized plug adapters
Note: Be sure to keep the original packaging in case you need to return the
Dolphin terminal for service; see page 6.
Dolphin 6500 Front Panel
Software
Reset Key
LED
Navigation Keys
Power Key
28-key keypad (numeric)
Touch Screen Display
(screen protector installed
at the factory)
2
Software
Reset Key
LED
Navigation Keys
(arrow keys)
Power Key
52-key keypad (alphanumeric)
Touch Screen Display
(screen protector installed
at the factory)
3
Dolphin 6500 Back Panel
Dolphin 6500 Right and Left-Side Panels
Installed
Battery
Finger
Saddle
Hand Strap (with Stylus)
Image Engine Window
Rear Scan Button
Speaker
Side
Button
Headset
Jack
Side
Button
Right Side Left Side
4
Dolphin 6500 Bottom Connectors
Step 1: Install the Main Battery
Ensure all components are dry prior to placing the battery in the terminal. Mating
wet components may cause damage not covered by the warranty.
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell
battery may result in damage not covered by the warranty.
The 6500 is shipped with the battery packaged separately from the unit.
To install the battery, release the hand strap, remove the battery door by
turning the locks upward, insert the battery with the labels facing upward,
and replace the battery door.
DC Power Jack
I/O Connector
!
!
Cover Locks
Main Battery
5
Step 2: Charge the Batteries
Dolphin terminals ship with both the main battery pack and internal
backup battery significantly discharged of power. Charge the main
battery pack with the Dolphin charging cable for a minimum of 5 1/2
hours before initial use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use
of any non-Honeywell peripherals, cables, or power adapters may cause damage not
covered by the warranty.
Step 3: Boot the Terminal
The terminal begins booting as soon as power is applied and runs by
itself. Do NOT press any keys or interrupt the boot process.
When the boot process is complete, the Desktop appears and the
terminal is ready for use.
Resetting the Device
Soft Reset: Using the stylus, press the Reset button. The screen
turns white and the decode/scan LED flashes blue for
approximately 10 seconds.
Hard Reset: 28-key: Press and hold the Power button and then
using the stylus, press the Reset button.
52-key: Press and hold the Blue and Z(Power)
buttons and then using the stylus, press the Reset
button. The screen turns white and the decode/scan
LED flashes blue for approximately 18 seconds.
1
2
3
!
6
Available Dolphin 6500 Peripherals and Accessories
Dolphin HomeBase™ Device
Dolphin QuadCharger™ Device
Dolphin eBase Device
Dolphin 6500 USB Communication Cable
Technical Assistance
Contact information for technical support and product service and repair
can be found at www.honeywellaidc.com.
Limited Warranty
Please refer to www.honeywellaidc.com/warranty_information for the
warranty information.
User Documentation
Refer to www.honeywellaidc.com for detailed user documentation or for
localized versions of this Quick Start.
Disclaimer
Honeywell International Inc. (“HII”) reserves the right to make changes
in specifications and other information contained in this document
without prior notice, and the reader should in all cases consult HII to
determine whether any such changes have been made. The information
in this publication does not represent a commitment on the part of HII.
HII shall not be liable for technical or editorial errors or omissions
contained herein; nor for incidental or consequential damages resulting
from the furnishing, performance, or use of this material.
This document contains proprietary information that is protected by
copyright. All rights are reserved. No part of this document may be
photocopied, reproduced, or translated into another language without
the prior written consent of HII.
Web Address: www.honeywellaidc.com
Trademarks
Dolphin, Dolphin RF, HomeBase, Mobile Base, and QuadCharger are
trademarks or registered trademarks of Hand Held Products, Inc. or
Honeywell International Inc.
Microsoft, Windows, Windows Mobile, Windows CE, Windows
Embedded Handheld, Windows NT, Windows 2000, Windows ME,
Windows XP, ActiveSync, Outlook, and the Windows logo are
trademarks or registered trademarks of Microsoft Corporation.
Other product names mentioned in this manual may be trademarks or
registered trademarks of their respective companies and are the
property of their respective owners.
Patents
For patent information, please refer to www.honeywellaidc.com/patents.
©2010-2011 Honeywell International Inc. All rights reserved.
Autres manuels pour DOLPHIN 6500
4
Table des matières
Autres manuels Honeywell portable
Honeywell
Honeywell ScanPal EDA51 Manuel utilisateur
Honeywell
Honeywell 7600BP-112-B6EE - Hand Held Products Dolphin... Manuel utilisateur
Honeywell
Honeywell MX9 Manuel utilisateur
Honeywell
Honeywell CK65 Series Manuel utilisateur
Honeywell
Honeywell 7600BP-112-B6EE - Hand Held Products Dolphin... Manuel utilisateur
Honeywell
Honeywell CN51 PrintPAD Manuel utilisateur
Honeywell
Honeywell ScanPal EDA51K Manuel utilisateur
Honeywell
Honeywell ScanPal EDA51 Manuel utilisateur
Honeywell
Honeywell 7600BP-112-B6EE - Hand Held Products Dolphin... Manuel utilisateur
Honeywell
Honeywell Dolphin 9900 Manuel utilisateur
Honeywell
Honeywell MX9 Manuel utilisateur
Honeywell
Honeywell Dolphin CH80 Manuel utilisateur
Honeywell
Honeywell 8680i Series Manuel utilisateur
Honeywell
Honeywell Dolphin 70e Black Manuel utilisateur
Honeywell
Honeywell CN70 Series Manuel utilisateur
Honeywell
Honeywell CT50 Manuel utilisateur
Honeywell
Honeywell DOLPHIN 6500 Manuel utilisateur
Honeywell
Honeywell ScanPal EDA50K Manuel utilisateur
Honeywell
Honeywell VM242A BasicMes-2 Manuel utilisateur
Honeywell
Honeywell MX8 Manuel utilisateur
