Hobby King Li13der-EP Manuel utilisateur

Specs:

Wing Span: 1016mm

Wing Area: 27.3 Sq dm

Length: 923.5mm

Weight: 650g RTF

Required:

Motor: BL2214 - 1000kv

Radio: 4 hannels,

Servos: 4 x 9g servo

Battery: 3S 1300~1500mAh

ESC: 20~25A

Warning!

This item is not a toy. It has the potential to ause serious harm if mistreated. The user a epts all

responsibility in the assembly of this model. Always he k the model to ensure it is free of damage and all

s rews and ontrol hardware is tight before ea h flight.

Wing Assembly

1) Aileron ontrol hardware – ontrol horns, levis, pushrod onne tor, pushrod, ontrol horn s rews.

2) Cut overing to expose servo mounting holes. Servos are mounted on the bottom of the wing.

3) Cut overing away at rudder servo lo ation on top of wing. Servo is mounted in the fuselage, but

needs learan e from the wing. Cut Hole in enter of wing sheeting for aileron servo leads.

4) Cut overing to insert main wing. Use a overing iron to seal edges of overing.

5) Glue wing with CA glue or epoxy, use a hobby knife to pun ture overing for better glue penetration.

6) Glue hinges with thin CA glue.

7) Install aileron servo, se ure with s rews.

8) Install aileron ontrol horn, se ure with s rews. Control horn in ludes square ba kplate for top of aileron.

9) Thread levis to ontrol rod. Pushrod onne tor should be installed on outermost hole in servo arm for

best ontrol throw. Center aileron with servo arm at 90 degrees to ontrol rod. Se ure pushrod with set

s rew. A small amount of thread lo k should be applied to set s rew to prevent it oming loose over time.

Tail Assembly

1) Tail hardware – Pull Pull ables, levis, aluminum rimps, ontrol horns, elevator joiner, tail wheel

2) Cut overing to install stabilizer. Seal edges with overing iron.

3) Cut overing for elevator servo mount on right side only.

4) Insert elevator into fuselage before installing stabilizer fin

5) Insert stabilizer into slot, enter it, pun ture overing at lo ation it onta ts fuselage, then glue in pla e

with CA or Epoxy.

6) Glue hinge with thin CA.

7) Install elevator servo, se ure with s rews. You may need a small servo extension lead for the elevator

servo to rea h your re eiver.

8) Install elevator horn, se ure with s rews and in luded ba kplate.

9) Glue verti al fin with CA glue or epoxy

10) Glue plywood tail wheel mount with CA glue or epoxy.

11) Cut a small hannel in balsa wood for tail wheel wire.

12) Drill a diameter 1.5mm hole to install the tail wheel wire.

13) Glue hinge with CA glue.

14) Glue tail wheel steel wire with CA glue or epoxy. A small pie e of lear tape wrapped around works for

double se urity.

15) Install rudder servo, se ure with s rews.

16) Insert rudder pull pull ables down the length of the fuselage to the rudder servo arm. Insert ables

through threaded fittings, loop able through, use aluminum rimps to se ure able.

17) Install rudder horn, se ure with s rews and nut M2 nuts.

18) Center servo arm, and rudder. Pull ables tight and loop able through threaded ends, se uring with

aluminum rimps. Final tension an be adjusted through the levis to threaded end.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Hobby King Jouet

Hobby King

Hobby King RYAN-STA Manuel utilisateur

Hobby King

Hobby King Gee Bee R3 Manuel utilisateur

Hobby King

Hobby King Fokker Dr.I Manuel utilisateur

Hobby King

Hobby King Decathlon-46 Manuel utilisateur

Hobby King

Hobby King AT-6 Texan Instructions d'utilisation

Hobby King

Hobby King EXTRA260P Manuel utilisateur

Hobby King

Hobby King ViperJet G500 Manuel utilisateur

Hobby King

Hobby King MiG-15 Manuel utilisateur

Hobby King

Hobby King ASK-2100 Manuel utilisateur

Hobby King

Hobby King Fokker E.111 Fighter Aircraft Manuel utilisateur

Hobby King

Hobby King Estrella Sport-50E Manuel utilisateur

Hobby King

Hobby King YAK 54 EP ARF Manuel utilisateur

Hobby King

Hobby King Assault 100 Manuel utilisateur

Hobby King

Hobby King spitfire Manuel utilisateur

Hobby King

Hobby King Mig-15 EDF Manuel utilisateur

Hobby King

Hobby King J3 CUB Manuel utilisateur

Hobby King

Hobby King TRAINSTAR Manuel utilisateur

Hobby King

Hobby King Cessna 195 Manuel utilisateur

Hobby King

Hobby King HD Wing Camera Manuel utilisateur

Hobby King

Hobby King wing wing z-84 Manuel utilisateur

Hobby King

Hobby King Waco SRE Manuel utilisateur

Hobby King

Hobby King Mellizo-50e Manuel utilisateur

Hobby King

Hobby King Decathlon Manuel utilisateur

Hobby King

Hobby King H-KING Cri Cri Manuel utilisateur

Manuels Jouet populaires d'autres marques

marklin

marklin 37321 Manuel utilisateur

Canon

Canon PAPER CRAFT Manuel utilisateur

GREAT PLANES

GREAT PLANES Pitts M-12S Manuel utilisateur

NOCH

NOCH 14261 Manuel utilisateur

Hausler

Hausler 450 SE V2 Manuel utilisateur

Dynaflite

Dynaflite Daydream Manuel utilisateur

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manuel

Kenner

Kenner Batman 63651 Manuel utilisateur

LEGO

LEGO 8527 Manuel utilisateur

iKarus

iKarus ECO 8 Manuel utilisateur

Multiplex

Multiplex EasyStar II Mode d’emploi

Walkera

Walkera 38 Mode d’emploi

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manuel utilisateur

MD MXION SWD Manuel utilisateur

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manuel utilisateur

marklin

marklin 39671 Manuel utilisateur

Meccano

Meccano 15103 Manuel utilisateur

LEGO

LEGO TECHNIC 8735 Manuel utilisateur