HME ServerCall 12 Manuel utilisateur
ServerCall® Paging w/Rugged Staff Pagers
Quick Setup Guide
Components
• JTECH Transmier
Applies to models: ServerCall (12/24)
& ServerCall Cancel Panel (12/24)
• Rugged Pagers
• Rugged Charger
Mount the transmier to the cook line using the
included brackets. Bracket can also be used as a
stand by reversing its posion on the back of the
transmier.
Step 1
Lock the antenna to the transmier by placing the
antenna on the connector and twisng le to lock
into place.
Step 2
Plug the power supply in to the transmier and
then into a standard outlet. A surge protector is
recommended.
Step 3
Compile charger bases and connector wires if
applicable. Plug charger power supply into
charger and then into a standard outlet. Surge
protecon is recommended for charging bases.
Step 4 > ‘LO’ on the number display: Baery is below
20% charged and SHOULD NOT be used.
> Flashing BLUE: Pager is charging and CAN BE
used.
> Solid BLUE: Pager is fully charged.
> Allow 4 hours for a complete charge of the
pagers.
Connector Wire
©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
Step 5
Add pagers to charger slots. You will see a BLUE
light on each pager. This indicates the charging
status.
QSSCRG-1
Using your ServerCall Paging System
1. Server is assigned a pager for the shi. Write the server name next to the pager number with a white grease pencil
(included).
2. When needed, press the number that corresponds to the server’s name.
3. When the server returns to pick up the order, press the number again to cancel the page.
By default, servers will be paged 3 mes before the page is escalated to a manager*. Each page is indicated by a
colored LED on the transmier.
Addional informaon available at www.jtech.com.
©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
By default, all messages are sent as a SINGLE vibraon. To send 2x or 3x vibraon paerns, press the corresponding buon on the
transmier PRIOR to selecng the server’s number.
GREEN – 1st page has been sent to server
YELLOW – 2nd page has been sent.
SOLID RED – 3rd page has been sent.
FLASHING RED – page not canceled, manager has been noed. *
*When used with a manager’s messaging pager, the manager will receive a page with the number of any server who has not cancelled their page.
• To renumber the pagers, with ALL of the pagers
in the charging base, PRESS and HOLD the
PROG buon on the charger for 8 seconds.
• Charger will beep twice indicang the cycle has
begun.
• The pagers will renumber starng at the loca-
on indicated by the on the charging base.
1. Mount the Cancel Panel on the expo line in the kitchen.
2. Connect the Cancel Panel to the ServerCall transmier using the Ethernet cable (provided).
3. When the server returns to pick up the order, the server will cancel the page on the Cancel Panel.
ServerCall Paging System
with oponal Cancel Panel
Ce manuel convient aux modèles suivants
4
Autres manuels HME Panneau de contrôle
