Hisense WTHX1701T Instructions de montage

Installation and usage of drain pipe

Put the clip at 2-3cm point of drain pipe(side without hook),then install the drain pipe on the connector at back of washing

machine, fasten with clip and hang on cabinet with hook.

Usage of drain pipe

The drain pipe must drain smoothly

1、The height between drain pipe and ground must be less

than 10cm, or will cause drain not smoothly. If drain too

long time, the machine will stop working.

2、Do not trample or squeeze drain pipe.

3、If user do not need so long drain pipe, can cut in the

middle of pipe. To keep draining smoothly, the front

of drain pipe can be cut slanted.

4、If need extend drain pipe, user should buy

extra pipe which is fit for and the length should

be less than 1.5m.

5、If extended pipe is too long, user can cut in

the middle of pipe.

Connect inlet pipe adaptor with faucet

1、Hold the bottom part of locking lever and press down the slider, detach the adaptor from the water

inlet pipe accessories as picture 1

2、Loosen the four screws of inlet pipe adaptor to put on the faucet as picture 2.(if the mouth of faucet

is too big to put on, loosen screws and take off the ring inside as picture 3. The front of faucet must

be balance to prevent leaking. )

3、Fasten four screws evenly as picture 4.

4、Rotate fastening nut tightly as picture 5.

Ps: before rotate fastening nut, the thread is exposed around 4mm. after rotating, the thread is exposed

around 2mm.

nut

Connect inlet pipe with washing machine

1、Do not take off water-proof circle. Check the water-proof

circle dropped or broken every time before using washing

machine. If yes, please contact us immediately.

2、Put inlet pipe thread on the connector of inlet valve.

3、Fasten inlet pipe thread, shake slightly to check

if fasten well.

Water Valve Ring

Connect inlet pipe adaptor with inlet pipe

1、Press slider, insert inlet pipe into adaptor.

2、Hold the locking lever and press down the slider,

until the sound of “pop”.

Before Rotation,about4mm

Ater Rotation,below2mm

Adaptor

Slider

Locking Lever

Inlet Pipe

Screwdriver

Screw

Ring

Mark Label

Pipe nut

Slider

Locking Lever

Adaptor

Maintance

Appearance maintenance

Wipe the machine with soft and dry cloth after every

wash. Do not use chemicals such as cleaning agents

and volatile agents in case any damage.

After working

The machine will buzzer automatically once

finish working.

Do not open faucet when not work. Take off plug

to prevent leaking of water and electric.

Clean inlet pipe mouth

There may be block at the mouth of inlet pipe after

long-term usage, please clean as below steps:

1、Close the faucet, connect power.

2、Start washing machine for 5s (in order to let the

water inside inlet pipe flow into washing tub),

then turn off.

3、Take off inlet pipe, take out net inside. Clean it

then put on again.

Clean filter

1、Press handle of filter follow the direction as below

picture shows, take off the filter.

2、Open it from back as picture shows, clean inside

dirty stuff.

3、After cleaning, close it and install back.

Good maintenance can make sure good washing performance and extend span life

Before maintenance, must take off plug.

1、After working, close faucet. (if necessary, take off inlet pipe as well.)

2、Do put keep water inside for long term. Drain out once finish working.

3、Hang power cord and drain pipe well.

4、Wipe left water on surface and tub, keep tub open for around one hour before close.

If frozen:

1.I n winter, if left water is frozen, the machine may break down. Please take off inlet pipe and drain left water

completely.

2.I f frozen happen, do not operate directly. Pour hot water around 40 degree until drown pulsator. Wait some

minutes, turn it by hand. The machine can be used if pulsator can move.

installation board handle filter

back cover

13kg

9-12

6-9

3-6

0-3 1-2

3-4

5-6

7-8

9-10

65ml 65g

80ml

95ml

80g

95g

Autres manuels Hisense Rondelle

Hisense

Hisense WFER1014VA Instructions de montage

Hisense

Hisense WFP8014VS Fiche d'information produit

Hisense

Hisense HWGE8141V Instructions de montage

Hisense

Hisense WFHV6012 Instructions de montage

Hisense

Hisense HWFE1014VA Manuel utilisateur

Hisense

Hisense WF3M841BWI Instructions de montage

Hisense

Hisense WT5J1313DT Instructions de montage

Hisense

Hisense WFU7012S Fiche d'information produit

Hisense

Hisense W10630786B Instructions de montage

Hisense

Hisense WFBL7014V Instructions de montage

Hisense

Hisense WFBJ8012-ES Instructions de montage

Hisense

Hisense WFEH9014VA Manuel du propriétaire

Hisense

Hisense HWGE9014 Instructions de montage

Hisense

Hisense WH8014V Instructions de montage

Hisense

Hisense WFMB6010EM Instructions de montage

Hisense

Hisense WF5S1043B Series Instructions de montage

Hisense

Hisense WFXE6012 Instructions de montage

Hisense

Hisense WFEH1014VJ Manuel utilisateur

Hisense

Hisense HWFE7510 Instructions de montage

Hisense

Hisense WFP1014V Fiche d'information produit

Hisense

Hisense WFGE80141VMB Instructions de montage

Hisense

Hisense Washing Machines Instructions de montage

Hisense

Hisense WDQY901418VJM Series Manuel utilisateur

Hisense

Hisense WFU7012 Manuel utilisateur

Manuels Rondelle populaires d'autres marques

Tricity Bendix

Tricity Bendix AW 1000 W Guide produit

Panasonic

Panasonic NA-F60L5WRB Manuel utilisateur

GE WSLP1500 Manuel

Electrolux

Electrolux EWF1284EDW Manuel utilisateur

Bosch

Bosch WAN2829BSN Manuel utilisateur

LG TV2516DV3B Manuel utilisateur

LG TH2517DSAV Manuel utilisateur

VESTEL

VESTEL CMH-XL 7510 TE Manuel utilisateur

AEG

AEG 74335 Manuel d'utilisation

Johnson

Johnson JWF721A Manuel utilisateur

Beko

Beko WTE7604XLW0 Manuel utilisateur

Danby

Danby DTT100A1WDB Instructions de montage

Amica

Amica WA 14 Ex Manuel utilisateur

Daewoo

Daewoo DWD-F1222 Manuel utilisateur

Bosch

Bosch WAS28461AU Manuel utilisateur

Miele

Miele PW 6080 Vario Manuel utilisateur

Finlux

Finlux FLX108CF220 Manuel utilisateur

Whirlpool

Whirlpool 3LBR5132AN0 Manuel utilisateur