- 9 -
Arm Stopper
Cord Snap
Wing nut
Spring
Cylinder
Connector Cap
Switch Lever
Driver Lock screws
Switch Lever
Driver Lock Screw
(Hexagon Socket Head
Cap screw)
Ring for PG-7000
Ring for PG-7000
Hanger Screw
holes
Lock Screw
holes
• After setting the screwdriver in step 2-1-4, t ring
onto the connector and connect the Driver Cord.
• Align the Lock Screw holes in the Holder and the
Hanger Screw holes, then fasten the Driver Lock screws.
L wrench
2-2 When using Model VMS-50VZ
2-2-1 Remove the Hanger from the VZ Screwdriver and
Loosen the Connector Cap. (Fig. 1)
2-2-2 Loosen the two Driver Lock screws and set the
driver as in the gure. (Fig. 2)
• Pass the Driver Connector through the Holder
and fasten the Connector Cap to x the driver.
• Align the Lock Screw holes in the Holder and the
Hanger Screw holes, then fasten the Driver Lock
screws.
Pass the Pole through the Cylinder,
Springand Arm Stopper, then x the
Driver Cord in the Cord Snapto refrain
it from interfering operation.
To adjust the screwdriver to a comfortable
operating height, loosen the Wing nut
and move the Cylinder up or down as
necessary.
The screwdriver automatically returns to
its pre-set position when the operator
release it. Its position can be set by
adjusting the Arm Stopper.
Check that the screwdriver returns to the desired position when it is released. Now it is ready for
use.
Attaching VMS-0900-PG7 Holder
EN
Fig. 1
Fig. 2
*Spacers are not used on models other than the PG-7000.
