- 6 -
CAUTIONS IN OPERATION
1. This Screw Driver is integral unit consisting of Screw Driver parts
and cord parts.
If any trouble occur, don't take a part o the tool. Stop the
operation and have the repair it immediately.
2. Never lubricate aerosol oil and the like. Otherwise it may cause
the expensive repair.
3. Do not drop, hit or abuse the tool. Otherwise it may cause some
trouble such as crack or damage.
4. Never use the chemicals to wipe the body cover.
5. Use under the proper voltage. Never use under the higher
voltage.
6. Do not pull the AC cord when unplug the AC plug. Otherwise it
may cause the breaking of wire.
7. To avoid trailing the AC cord on oor, use the Spring Balancer to
hang the AC cord.
8. For the safety use, do not set the torque adjusting nut at higher
than 10 on the torque adjusting scale. (Ref. to P.14)
9. Use the tool intermittently which describes on the tool: (ex: 0.5
sec. on / 3.5 sec. o)
10. Do not tighten more than 900 pcs of tapping screws per 60
minutes.
11. This tool is not for tightening up wood screw.
12. During the motor is running, never change the forward ←→
reverse direction immediately.
13. Whenever the tool is not in use, set the start switch and
Forward/o/Reverse switch to "OFF" position and unplug the AC
cord plug.
14. Use of model VZ-4506PS at high torque settings brings a
very high impact to the operator's hand. Please use this tool
with caution, as Carpal Tunnel Syndrome (CTS) or other trauma
disorders may result.
HIOS shock-Resistant Stand is available to absorb the torque to the
operator's hand during operation.
SUMMARY
This VZ Series Screw Driver is a Control Function Built-in Type.
The body is light and designed to decrease the vibration and noise.
It is possible to use hexagonal bit with opposite side of 6.35 mm (1/4
inch. HEX.)
Also, you can select the starting system (Lever Start and Push to
Start) in accordance with the work.
